arm_gicv2m: Add GICv2m widget to support MSIs

The ARM GICv2m widget is a little device that handles MSI interrupt
writes to a trigger register and ties them to a range of interrupt lines
wires to the GIC.  It has a few status/id registers and the interrupt wires,
and that's about it.

A board instantiates the device by setting the base SPI number and
number SPIs for the frame.  The base-spi parameter is indexed in the SPI
number space only, so base-spi == 0, means IRQ number 32.  When a device
(the PCI host controller) writes to the trigger register, the payload is
the GIC IRQ number, so we have to subtract 32 from that and then index
into our frame of SPIs.

When instantiating a GICv2m device, tell PCI that we have instantiated
something that can deal with MSIs.  We rely on the board actually wiring
up the GICv2m to the PCI host controller.

Reviewed-by: Eric Auger <eric.auger@linaro.org>
Signed-off-by: Christoffer Dall <christoffer.dall@linaro.org>
Message-id: 1432897270-7780-3-git-send-email-christoffer.dall@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>

1 files changed, 1 insertions, 0 deletions

diff --git a/hw/intc/Makefile.objs b/hw/intc/Makefile.objs
index 843864a..092d8a8 100644
--- a/hw/intc/Makefile.objs
+++ b/hw/intc/Makefile.objs
@@ -11,6 +11,7 @@ common-obj-$(CONFIG_SLAVIO) += slavio_intctl.o
 common-obj-$(CONFIG_IOAPIC) += ioapic_common.o
 common-obj-$(CONFIG_ARM_GIC) += arm_gic_common.o
 common-obj-$(CONFIG_ARM_GIC) += arm_gic.o
+common-obj-$(CONFIG_ARM_GIC) += arm_gicv2m.o
 common-obj-$(CONFIG_OPENPIC) += openpic.o
 
 obj-$(CONFIG_APIC) += apic.o apic_common.o