1 files changed, 170 insertions, 0 deletions
diff --git a/arch/blackfin/include/asm/mach-bf518/anomaly.h b/arch/blackfin/include/asm/mach-bf518/anomaly.h
new file mode 100644
index 0000000..56383f7
--- /dev/null
+++ b/arch/blackfin/include/asm/mach-bf518/anomaly.h
@@ -0,0 +1,170 @@
+/*
+ * DO NOT EDIT THIS FILE
+ * This file is under version control at
+ *   svn://sources.blackfin.uclinux.org/toolchain/trunk/proc-defs/header-frags/
+ * and can be replaced with that version at any time
+ * DO NOT EDIT THIS FILE
+ *
+ * Copyright 2004-2011 Analog Devices Inc.
+ * Licensed under the ADI BSD license.
+ *   https://docs.blackfin.uclinux.org/doku.php?id=adi_bsd
+ */
+
+/* This file should be up to date with:
+ *  - Revision F, 05/23/2011; ADSP-BF512/BF514/BF516/BF518 Blackfin Processor Anomaly List
+ */
+
+#if __SILICON_REVISION__ < 0
+# error will not work on BF518 silicon version
+#endif
+
+#ifndef _MACH_ANOMALY_H_
+#define _MACH_ANOMALY_H_
+
+/* Multi-Issue Instruction with dsp32shiftimm in slot1 and P-reg Store in slot2 Not Supported */
+#define ANOMALY_05000074 (1)
+/* DMA_RUN Bit Is Not Valid after a Peripheral Receive Channel DMA Stops */
+#define ANOMALY_05000119 (1)
+/* Rx.H Cannot Be Used to Access 16-bit System MMR Registers */
+#define ANOMALY_05000122 (1)
+/* False Hardware Error from an Access in the Shadow of a Conditional Branch */
+#define ANOMALY_05000245 (1)
+/* Incorrect Timer Pulse Width in Single-Shot PWM_OUT Mode with External Clock */
+#define ANOMALY_05000254 (1)
+/* Sensitivity To Noise with Slow Input Edge Rates on External SPORT TX and RX Clocks */
+#define ANOMALY_05000265 (1)
+/* False Hardware Errors Caused by Fetches at the Boundary of Reserved Memory */
+#define ANOMALY_05000310 (1)
+/* PPI Underflow Error Goes Undetected in ITU-R 656 Mode */
+#define ANOMALY_05000366 (1)
+/* Lockbox SESR Firmware Does Not Save/Restore Full Context */
+#define ANOMALY_05000405 (1)
+/* Lockbox Firmware Memory Cleanup Routine Does not Clear Registers */
+#define ANOMALY_05000408 (1)
+/* Speculative Fetches Can Cause Undesired External FIFO Operations */
+#define ANOMALY_05000416 (1)
+/* TWI Fall Time (Tof) May Violate the Minimum I2C Specification */
+#define ANOMALY_05000421 (1)
+/* TWI Input Capacitance (Ci) May Violate the Maximum I2C Specification */
+#define ANOMALY_05000422 (1)
+/* Speculative Fetches of Indirect-Pointer Instructions Can Cause False Hardware Errors */
+#define ANOMALY_05000426 (1)
+/* Software System Reset Corrupts PLL_LOCKCNT Register */
+#define ANOMALY_05000430 (__SILICON_REVISION__ < 1)
+/* Incorrect Use of Stack in Lockbox Firmware During Authentication */
+#define ANOMALY_05000431 (1)
+/* SW Breakpoints Ignored Upon Return From Lockbox Authentication */
+#define ANOMALY_05000434 (1)
+/* Certain SIC Registers are not Reset After Soft or Core Double Fault Reset */
+#define ANOMALY_05000435 (__SILICON_REVISION__ < 1)
+/* PORTx_DRIVE and PORTx_HYSTERESIS Registers Read Back Incorrect Values */
+#define ANOMALY_05000438 (__SILICON_REVISION__ < 1)
+/* Preboot Cannot be Used to Alter the PLL_DIV Register */
+#define ANOMALY_05000439 (__SILICON_REVISION__ < 1)
+/* bfrom_SysControl() Cannot be Used to Write the PLL_DIV Register */
+#define ANOMALY_05000440 (__SILICON_REVISION__ < 1)
+/* IFLUSH Instruction at End of Hardware Loop Causes Infinite Stall */
+#define ANOMALY_05000443 (1)
+/* Incorrect L1 Instruction Bank B Memory Map Location */
+#define ANOMALY_05000444 (__SILICON_REVISION__ < 1)
+/* Incorrect Default Hysteresis Setting for RESET, NMI, and BMODE Signals */
+#define ANOMALY_05000452 (__SILICON_REVISION__ < 1)
+/* PWM_TRIPB Signal Not Available on PG10 */
+#define ANOMALY_05000453 (__SILICON_REVISION__ < 1)
+/* PPI_FS3 is Driven One Half Cycle Later Than PPI Data */
+#define ANOMALY_05000455 (__SILICON_REVISION__ < 1)
+/* False Hardware Error when RETI Points to Invalid Memory */
+#define ANOMALY_05000461 (1)
+/* Synchronization Problem at Startup May Cause SPORT Transmit Channels to Misalign */
+#define ANOMALY_05000462 (__SILICON_REVISION__ < 2)
+/* Incorrect Default MSEL Value in PLL_CTL */
+#define ANOMALY_05000472 (__SILICON_REVISION__ < 2)
+/* Interrupted SPORT Receive Data Register Read Results In Underflow when SLEN > 15 */
+#define ANOMALY_05000473 (1)
+/* TESTSET Instruction Cannot Be Interrupted */
+#define ANOMALY_05000477 (1)
+/* Reads of ITEST_COMMAND and ITEST_DATA Registers Cause Cache Corruption */
+#define ANOMALY_05000481 (1)
+/* PLL Latches Incorrect Settings During Reset */
+#define ANOMALY_05000482 (__SILICON_REVISION__ < 2)
+/* PLL_CTL Change Using bfrom_SysControl() Can Result in Processor Overclocking */
+#define ANOMALY_05000485 (__SILICON_REVISION__ < 2)
+/* SPI Master Boot Can Fail Under Certain Conditions */
+#define ANOMALY_05000490 (1)
+/* Instruction Memory Stalls Can Cause IFLUSH to Fail */
+#define ANOMALY_05000491 (1)
+/* EXCPT Instruction May Be Lost If NMI Happens Simultaneously */
+#define ANOMALY_05000494 (1)
+/* CNT_COMMAND Functionality Depends on CNT_IMASK Configuration */
+#define ANOMALY_05000498 (1)
+/* RXS Bit in SPI_STAT May Become Stuck In RX DMA Modes */
+#define ANOMALY_05000501 (1)
+
+/* Anomalies that don't exist on this proc */
+#define ANOMALY_05000099 (0)
+#define ANOMALY_05000120 (0)
+#define ANOMALY_05000125 (0)
+#define ANOMALY_05000149 (0)
+#define ANOMALY_05000158 (0)
+#define ANOMALY_05000171 (0)
+#define ANOMALY_05000179 (0)
+#define ANOMALY_05000182 (0)
+#define ANOMALY_05000183 (0)
+#define ANOMALY_05000189 (0)
+#define ANOMALY_05000198 (0)
+#define ANOMALY_05000202 (0)
+#define ANOMALY_05000215 (0)
+#define ANOMALY_05000219 (0)
+#define ANOMALY_05000220 (0)
+#define ANOMALY_05000227 (0)
+#define ANOMALY_05000230 (0)
+#define ANOMALY_05000231 (0)
+#define ANOMALY_05000233 (0)
+#define ANOMALY_05000234 (0)
+#define ANOMALY_05000242 (0)
+#define ANOMALY_05000244 (0)
+#define ANOMALY_05000248 (0)
+#define ANOMALY_05000250 (0)
+#define ANOMALY_05000257 (0)
+#define ANOMALY_05000261 (0)
+#define ANOMALY_05000263 (0)
+#define ANOMALY_05000266 (0)
+#define ANOMALY_05000273 (0)
+#define ANOMALY_05000274 (0)
+#define ANOMALY_05000278 (0)
+#define ANOMALY_05000281 (0)
+#define ANOMALY_05000283 (0)
+#define ANOMALY_05000285 (0)
+#define ANOMALY_05000287 (0)
+#define ANOMALY_05000301 (0)
+#define ANOMALY_05000305 (0)
+#define ANOMALY_05000307 (0)
+#define ANOMALY_05000311 (0)
+#define ANOMALY_05000312 (0)
+#define ANOMALY_05000315 (0)
+#define ANOMALY_05000323 (0)
+#define ANOMALY_05000353 (0)
+#define ANOMALY_05000357 (0)
+#define ANOMALY_05000362 (1)
+#define ANOMALY_05000363 (0)
+#define ANOMALY_05000364 (0)
+#define ANOMALY_05000371 (0)
+#define ANOMALY_05000380 (0)
+#define ANOMALY_05000383 (0)
+#define ANOMALY_05000386 (0)
+#define ANOMALY_05000389 (0)
+#define ANOMALY_05000400 (0)
+#define ANOMALY_05000402 (0)
+#define ANOMALY_05000412 (0)
+#define ANOMALY_05000432 (0)
+#define ANOMALY_05000447 (0)
+#define ANOMALY_05000448 (0)
+#define ANOMALY_05000456 (0)
+#define ANOMALY_05000450 (0)
+#define ANOMALY_05000465 (0)
+#define ANOMALY_05000467 (0)
+#define ANOMALY_05000474 (0)
+#define ANOMALY_05000475 (0)
+#define ANOMALY_05000480 (0)
+
+#endif