diff options
Diffstat (limited to 'share/man/man4/zyd.4')
-rw-r--r-- | share/man/man4/zyd.4 | 63 |
1 files changed, 22 insertions, 41 deletions
diff --git a/share/man/man4/zyd.4 b/share/man/man4/zyd.4 index 6599a53..23eb9c6 100644 --- a/share/man/man4/zyd.4 +++ b/share/man/man4/zyd.4 @@ -32,7 +32,7 @@ .\" ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF .\" THE POSSIBILITY OF SUCH DAMAGE. .\" -.Dd September 6, 2007 +.Dd Apri 13, 2008 .Dt ZYD 4 .Os .Sh NAME @@ -64,34 +64,16 @@ The driver provides support for wireless network adapters based around the ZyDAS ZD1211 and ZD1211B USB chips. .Pp -These are the modes the .Nm -driver can operate in: -.Bl -tag -width "IBSS-masterXX" -.It BSS mode -Also known as -.Em infrastructure -mode, this is used when associating with an access point, through -which all traffic passes. -This mode is the default. -.It monitor mode -In this mode the driver is able to receive packets without -associating with an access point. -This disables the internal receive filter and enables the card to -capture packets from networks which it wouldn't normally have access to, -or to scan for access points. -.El -.Pp -.Nm -supports software WEP. -Wired Equivalent Privacy (WEP) is the de facto encryption standard -for wireless networks. -It can be typically configured in one of three modes: -no encryption; 40-bit encryption; or 104-bit encryption. -Unfortunately, due to serious weaknesses in WEP protocol -it is strongly recommended that it not be used as the -sole mechanism to secure wireless communication. -WEP is not enabled by default. +supports +.Cm station , +.Cm adhoc , +and +.Cm monitor +mode operation. +Only one virtual interface may be configured at any time. +For more information on configuring this device, see +.Xr ifconfig 8 . .Sh HARDWARE The following devices are known to be supported by the .Nm @@ -143,24 +125,20 @@ driver: .El .Sh EXAMPLES The following -examples configures zyd0 to join whatever network is available on boot, -using WEP key +examples configures zyd0 to join any BSS network using WEP key .Dq 0x1deadbeef1 , channel 11: .Bd -literal -offset indent -inet 192.168.1.1 netmask 255.255.255.0 wepkey 0x1deadbeef1 channel 11 -.Ed -.Pp -Configure zyd0 for WEP, using hex key -.Dq 0x1deadbeef1 : -.Bd -literal -offset indent -# ifconfig zyd0 wepkey 0x1deadbeef1 +ifconfig wlan create wlandev zyd0 channel 11 \e + wepmode on wepkey 0x1deadbeef1 weptxkey 1 \e + inet 192.168.1.1 netmask 255.255.255.0 .Ed .Pp Join an existing BSS network, .Dq my_net : .Bd -literal -offset indent -# ifconfig zyd0 192.168.0.2 netmask 0xffffff00 ssid my_net +ifconfig wlan create wlandev zyd0 192.168.0.2 \e + netmask 0xffffff00 ssid my_net .Ed .Sh DIAGNOSTICS .Bl -diag @@ -181,16 +159,19 @@ The driver will reset the hardware. This should not happen. .El .Sh SEE ALSO -.Xr arp 4 , .Xr intro 4 , .Xr netintro 4 , .Xr usb 4 , .Xr wlan 4 , .Xr wlan_amrr 4 , -.Xr ifconfig 8 +.Xr wlan_ccmp 4 , +.Xr wlan_tkip 4 , +.Xr wlan_wep 4 , +.Xr ifconfig 8 , +.Xr wpa_supplicant 8 . .Sh AUTHORS .An -nosplit -The +The original .Nm driver was written by .An Florian Stoehr Aq ich@florian-stoehr.de , |