Add $ipv6_cpe_wanif to enable functionality required for IPv6 CPE

(r225485).  When setting an interface name to it, the following
configurations will be enabled:

 1. "no_radr" is set to all IPv6 interfaces automatically.

 2. "-no_radr accept_rtadv" will be set only for $ipv6_cpe_wanif.  This is
    done just before evaluating $ifconfig_IF_ipv6 in the rc.d scripts (this
    means you can manually supersede this configuration if necessary).

 3. The node will add RA-sending routers to the default router list
    even if net.inet6.ip6.forwarding=1.

This mode is added to conform to RFC 6204 (a router which connects
the end-user network to a service provider network).  To enable
packet forwarding, you still need to set ipv6_gateway_enable=YES.

Note that accepting router entries into the default router list when
packet forwarding capability and a routing daemon are enabled can
result in messing up the routing table.  To minimize such unexpected
behaviors, "no_radr" is set on all interfaces but $ipv6_cpe_wanif.

Approved by:	re (bz)

1 files changed, 13 insertions, 0 deletions

diff --git a/etc/rc.d/netoptions b/etc/rc.d/netoptions
index 09ed6ef..1547ade 100755
--- a/etc/rc.d/netoptions
+++ b/etc/rc.d/netoptions
@@ -106,6 +106,19 @@ netoptions_inet6()
 		${SYSCTL} net.inet6.ip6.use_tempaddr=1 >/dev/null
 		${SYSCTL} net.inet6.ip6.prefer_tempaddr=1 >/dev/null
 	fi
+
+	case $ipv6_cpe_wanif in
+	""|[Nn][Oo]|[Nn][Oo][Nn][Ee]|[Ff][Aa][Ll][Ss][Ee]|[Oo][Ff][Ff]|0)
+		${SYSCTL} net.inet6.ip6.no_radr=0 >/dev/null
+		${SYSCTL} net.inet6.ip6.rfc6204w3=0 >/dev/null
+	;;
+	*)	
+		netoptions_init
+		echo -n " IPv6 CPE WANIF=${ipv6_cpe_wanif}"
+		${SYSCTL} net.inet6.ip6.no_radr=1 >/dev/null
+		${SYSCTL} net.inet6.ip6.rfc6204w3=1 >/dev/null
+	;;
+	esac
 }
 
 load_rc_config $name