# daemon configuration telnet_port 4444 gdb_port 3333 # tell gdb our flash memory map # and enable flash programming gdb_memory_map enable gdb_flash_program enable # # interface, if you want to use an other interface # you must replace this section here # #################### interface start #################### interface ft2232 ft2232_device_desc "Amontec JTAGkey A" ft2232_layout jtagkey ft2232_vid_pid 0x0403 0xcff8 ##################### interface end ##################### # jtag speed # start slow, speed up after reset jtag_khz 16 2000 #delays on reset lines jtag_nsrst_delay 100 jtag_ntrst_delay 100 #use combined on interfaces or targets that can't set TRST/SRST separately reset_config trst_and_srst #jtag scan chain #format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE) jtag_device 8 0x1 0x1 0xfe jtag_device 4 0x1 0xf 0xe jtag_device 5 0x1 0x1 0x1e #target configuration daemon_startup reset #target #target arm7tdmi target arm966e little reset_halt 1 arm966e run_and_halt_time 0 30 target_script 0 reset ./prj/str912_reset.script target_script 0 gdb_program_config ./prj/str912_program.script working_area 0 0x50000000 16384 nobackup #flash bank str9x 0 0 flash bank str9x 0x00000000 0x00080000 0 0 0 flash bank str9x 0x00080000 0x00008000 0 0 0 # For more information about the configuration files, take a # look at the "Open On-Chip Debugger (openocd)" documentation.