summaryrefslogtreecommitdiffstats
path: root/Documentation/i2c/busses/i2c-mlxcpld
blob: 4e46c440b38d9a07046f43323cc011fcffa10838 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
Driver i2c-mlxcpld

Author: Michael Shych <michaelsh@mellanox.com>

This is the Mellanox I2C controller logic, implemented in Lattice CPLD
device.
Device supports:
 - Master mode.
 - One physical bus.
 - Polling mode.

This controller is equipped within the next Mellanox systems:
"msx6710", "msx6720", "msb7700", "msn2700", "msx1410", "msn2410", "msb7800",
"msn2740", "msn2100".

The next transaction types are supported:
 - Receive Byte/Block.
 - Send Byte/Block.
 - Read Byte/Block.
 - Write Byte/Block.

Registers:
CTRL		0x1 - control reg.
			Resets all the registers.
HALF_CYC	0x4 - cycle reg.
			Configure the width of I2C SCL half clock cycle (in 4 LPC_CLK
			units).
I2C_HOLD	0x5 - hold reg.
			OE (output enable) is delayed by value set to this register
			(in LPC_CLK units)
CMD			0x6 - command reg.
			Bit 0, 0 = write, 1 = read.
			Bits [7:1] - the 7bit Address of the I2C device.
			It should be written last as it triggers an I2C transaction.
NUM_DATA	0x7 - data size reg.
			Number of data bytes to write in read transaction
NUM_ADDR	0x8 - address reg.
			Number of address bytes to write in read transaction.
STATUS		0x9 - status reg.
			Bit 0 - transaction is completed.
			Bit 4 - ACK/NACK.
DATAx		0xa - 0x54  - 68 bytes data buffer regs.
			For write transaction address is specified in four first bytes
			(DATA1 - DATA4), data starting from DATA4.
			For read transactions address is sent in a separate transaction and
			specified in the four first bytes (DATA0 - DATA3). Data is read
			starting from DATA0.
OpenPOWER on IntegriCloud