summaryrefslogtreecommitdiffstats
path: root/Documentation/devicetree/bindings/pinctrl/brcm,nsp-gpio.txt
blob: 0844168a6dd4b0a68be830f9d868c143df84e737 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
Broadcom Northstar plus (NSP) GPIO/PINCONF Controller

Required properties:
- compatible:
    Must be "brcm,nsp-gpio-a"

- reg:
    Should contain the register physical address and length for each of
    GPIO base, IO control registers

- #gpio-cells:
    Must be two. The first cell is the GPIO pin number (within the
    controller's pin space) and the second cell is used for the following:
    bit[0]: polarity (0 for active high and 1 for active low)

- gpio-controller:
    Specifies that the node is a GPIO controller

- ngpios:
    Number of gpios supported (58x25 supports 32 and 58x23 supports 24)

Optional properties:
- interrupts:
    Interrupt ID

- interrupt-controller:
    Specifies that the node is an interrupt controller

- gpio-ranges:
    Specifies the mapping between gpio controller and pin-controllers pins.
    This requires 4 fields in cells defined as -
    1. Phandle of pin-controller.
    2. GPIO base pin offset.
    3  Pin-control base pin offset.
    4. number of gpio pins which are linearly mapped from pin base.

Supported generic PINCONF properties in child nodes:
- pins:
    The list of pins (within the controller's own pin space) that properties
    in the node apply to. Pin names are "gpio-<pin>"

- bias-disable:
    Disable pin bias

- bias-pull-up:
    Enable internal pull up resistor

- bias-pull-down:
    Enable internal pull down resistor

- drive-strength:
    Valid drive strength values include 2, 4, 6, 8, 10, 12, 14, 16 (mA)

Example:

	gpioa: gpio@18000020 {
		compatible = "brcm,nsp-gpio-a";
		reg = <0x18000020 0x100>,
		      <0x1803f1c4 0x1c>;
		#gpio-cells = <2>;
		gpio-controller;
		ngpios = <32>;
		gpio-ranges = <&pinctrl 0 0 31>;
		interrupt-controller;
		interrupts = <GIC_SPI 85 IRQ_TYPE_LEVEL_HIGH>;

		/* Hog a few default settings */
		pinctrl-names = "default";
		pinctrl-0 = <&led>;
		led: led {
			pins = "gpio-1";
			bias-pull-up;
		};

		pwr: pwr {
			gpio-hog;
			gpios = <3 1>;
			output-high;
		};
	};
OpenPOWER on IntegriCloud