summaryrefslogtreecommitdiffstats
path: root/Documentation/devicetree/bindings/media/atmel-isi.txt
blob: 332513a151cc9d45ba299e4722cb19eb8a20a827 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
Atmel Image Sensor Interface (ISI)
----------------------------------

Required properties for ISI:
- compatible: must be "atmel,at91sam9g45-isi".
- reg: physical base address and length of the registers set for the device.
- interrupts: should contain IRQ line for the ISI.
- clocks: list of clock specifiers, corresponding to entries in the clock-names
	property; please refer to clock-bindings.txt.
- clock-names: required elements: "isi_clk".
- pinctrl-names, pinctrl-0: please refer to pinctrl-bindings.txt.

ISI supports a single port node with parallel bus. It shall contain one
'port' child node with child 'endpoint' node. Please refer to the bindings
defined in Documentation/devicetree/bindings/media/video-interfaces.txt.

Endpoint node properties
------------------------

- bus-width: <8> or <10> (mandatory)
- hsync-active (default: active high)
- vsync-active (default: active high)
- pclk-sample (default: sample on falling edge)
- remote-endpoint: A phandle to the bus receiver's endpoint node (mandatory).

Example:

isi: isi@f0034000 {
	compatible = "atmel,at91sam9g45-isi";
	reg = <0xf0034000 0x4000>;
	interrupts = <37 IRQ_TYPE_LEVEL_HIGH 5>;
	pinctrl-names = "default";
	pinctrl-0 = <&pinctrl_isi_data_0_7>;
	clocks = <&isi_clk>;
	clock-names = "isi_clk";
	port {
		isi_0: endpoint {
			remote-endpoint = <&ov2640_0>;
			bus-width = <8>;
			vsync-active = <1>;
			hsync-active = <1>;
		};
	};
};

i2c1: i2c@f0018000 {
	ov2640: camera@30 {
		compatible = "ovti,ov2640";
		reg = <0x30>;
		pinctrl-names = "default";
		pinctrl-0 = <&pinctrl_pck0_as_isi_mck &pinctrl_sensor_power &pinctrl_sensor_reset>;
		resetb-gpios = <&pioE 11 GPIO_ACTIVE_LOW>;
		pwdn-gpios = <&pioE 13 GPIO_ACTIVE_HIGH>;
		clocks = <&pck0>;
		clock-names = "xvclk";
		assigned-clocks = <&pck0>;
		assigned-clock-rates = <25000000>;

		port {
			ov2640_0: endpoint {
				remote-endpoint = <&isi_0>;
				bus-width = <8>;
			};
		};
	};
};
OpenPOWER on IntegriCloud