From 483f33f63c1cb3c6becb465bac7b75d7ff5e3b8f Mon Sep 17 00:00:00 2001 From: Linus Walleij Date: Fri, 4 Jan 2013 17:57:40 +0100 Subject: pinctrl: add pinconf-generic defines for output This adds a definition of a generic output configuration for a certain pin when using the generic pin configuration library. Whereas driving pins low/high is usually a GPIO business, you may want to set up pins into a default state using hogs, and never touch them again. This helps out with that scenario. Based on a patch from Patrice Chotard. Signed-off-by: Patrice Chotard Reviewed-by: Stephen Warren Signed-off-by: Linus Walleij --- include/linux/pinctrl/pinconf-generic.h | 3 +++ 1 file changed, 3 insertions(+) (limited to 'include/linux/pinctrl') diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h index 47a1bdd..b23d99d 100644 --- a/include/linux/pinctrl/pinconf-generic.h +++ b/include/linux/pinctrl/pinconf-generic.h @@ -62,6 +62,8 @@ * operation, if several modes of operation are supported these can be * passed in the argument on a custom form, else just use argument 1 * to indicate low power mode, argument 0 turns low power mode off. + * @PIN_CONFIG_OUTPUT: this will configure the pin in output, use argument + * 1 to indicate high level, argument 0 to indicate low level. * @PIN_CONFIG_END: this is the last enumerator for pin configurations, if * you need to pass in custom configurations to the pin controller, use * PIN_CONFIG_END+1 as the base offset. @@ -79,6 +81,7 @@ enum pin_config_param { PIN_CONFIG_INPUT_DEBOUNCE, PIN_CONFIG_POWER_SOURCE, PIN_CONFIG_LOW_POWER_MODE, + PIN_CONFIG_OUTPUT, PIN_CONFIG_END = 0x7FFF, }; -- cgit v1.1