From fded5fc8412a0bfadd2b130433109a5be7ffdf82 Mon Sep 17 00:00:00 2001 From: Leonard Crestez Date: Mon, 28 Aug 2017 14:05:18 +0300 Subject: cpufreq: imx6q: Fix imx6sx low frequency support This patch contains the minimal changes required to support imx6sx OPP of 198 Mhz. Without this patch cpufreq still reports success but the frequency is not changed, the "arm" clock will still be at 396000000 in clk_summary. In order to do this PLL1 needs to be still kept enabled while changing the ARM clock. This is a hardware requirement: when ARM_PODF is changed in CCM we need to check the busy bit of CCM_CDHIPR bit 16 arm_podf_busy, and this bit is sync with PLL1 clock, so if PLL1 NOT enabled, this bit will never get clear. Keep pll1_sys explicitly enabled until after the rate is change to deal with this. Otherwise from the clk framework perspective pll1_sys is unused and gets turned off. Signed-off-by: Leonard Crestez Reviewed-by: Lucas Stach Signed-off-by: Rafael J. Wysocki --- drivers/cpufreq/imx6q-cpufreq.c | 9 +++++++++ 1 file changed, 9 insertions(+) (limited to 'drivers') diff --git a/drivers/cpufreq/imx6q-cpufreq.c b/drivers/cpufreq/imx6q-cpufreq.c index b6edd3c..14466a9 100644 --- a/drivers/cpufreq/imx6q-cpufreq.c +++ b/drivers/cpufreq/imx6q-cpufreq.c @@ -47,6 +47,7 @@ static int imx6q_set_target(struct cpufreq_policy *policy, unsigned int index) struct dev_pm_opp *opp; unsigned long freq_hz, volt, volt_old; unsigned int old_freq, new_freq; + bool pll1_sys_temp_enabled = false; int ret; new_freq = freq_table[index].frequency; @@ -124,6 +125,10 @@ static int imx6q_set_target(struct cpufreq_policy *policy, unsigned int index) if (freq_hz > clk_get_rate(pll2_pfd2_396m_clk)) { clk_set_rate(pll1_sys_clk, new_freq * 1000); clk_set_parent(pll1_sw_clk, pll1_sys_clk); + } else { + /* pll1_sys needs to be enabled for divider rate change to work. */ + pll1_sys_temp_enabled = true; + clk_prepare_enable(pll1_sys_clk); } } @@ -135,6 +140,10 @@ static int imx6q_set_target(struct cpufreq_policy *policy, unsigned int index) return ret; } + /* PLL1 is only needed until after ARM-PODF is set. */ + if (pll1_sys_temp_enabled) + clk_disable_unprepare(pll1_sys_clk); + /* scaling down? scale voltage after frequency */ if (new_freq < old_freq) { ret = regulator_set_voltage_tol(arm_reg, volt, 0); -- cgit v1.1