From b72458a80c75cab832248f536412f386e20a93a0 Mon Sep 17 00:00:00 2001 From: matthieu castet Date: Mon, 7 Nov 2005 23:27:13 +0100 Subject: [PATCH] USB: Eagle and ADI 930 usb adsl modem driver A driver for USB ADSL modems based on the ADI eagle chipset using the usb_atm infrastructure. The managing part was taken from bsd ueagle driver, other parts were written from scratch. The driver uses the in-kernel firmware loader : - to load a first usb firmware when the modem is in pre-firmware state - to load the dsp firmware that are swapped in host memory. - to load CMV (configuration and management variables) when the modem boot. (We can't use options or sysfs for this as there many possible values. See https://mail.gna.org/public/eagleusb-dev/2005-04/msg00031.html for a description of some) - to load fpga code for 930 chipset. The device had 4 endpoints : * 2 for data (use by usbatm). The incoming endpoint could be iso or bulk. The modem seems buggy and produce lot's of atm errors when using it in bulk mode for speed > 3Mbps, so iso endpoint is need for speed > 3Mbps. At the moment iso endpoint need a patched usbatm library and for this reason is not included in this patch. * One bulk endpoint for uploading dsp firmware * One irq endpoint that notices the driver - if we need to upload a page of the dsp firmware - an ack for read or write CMV and the value (for the read case). If order to make the driver cleaner, we design synchronous (read|write)_cmv : -send a synchronous control message to the modem -wait for an ack or a timeout -return the value if needed. In order to run these synchronous usb messages we need a kernel thread. The driver has been tested with sagem fast 800 modems with different eagle chipset revision and with ADI 930 since April 2005. Signed-off-by: Matthieu CASTET Signed-off-by: Andrew Morton Signed-off-by: Greg Kroah-Hartman --- drivers/usb/atm/Makefile | 1 + 1 file changed, 1 insertion(+) (limited to 'drivers/usb/atm/Makefile') diff --git a/drivers/usb/atm/Makefile b/drivers/usb/atm/Makefile index 8509971..4c4a776 100644 --- a/drivers/usb/atm/Makefile +++ b/drivers/usb/atm/Makefile @@ -4,6 +4,7 @@ obj-$(CONFIG_USB_CXACRU) += cxacru.o obj-$(CONFIG_USB_SPEEDTOUCH) += speedtch.o +obj-$(CONFIG_USB_UEAGLEATM) += ueagle-atm.o obj-$(CONFIG_USB_ATM) += usbatm.o obj-$(CONFIG_USB_XUSBATM) += xusbatm.o -- cgit v1.1