From dc7e3ef7dade7041fb1809f2a5403efac655a791 Mon Sep 17 00:00:00 2001 From: Paul Mundt Date: Thu, 24 Nov 2011 20:20:53 +0900 Subject: serial: sh-sci: Add support for loopback mode. This plugs in loopback control for SCFCR-enabled ports and plugs it in via the TIOCM_LOOP control, as others do. Signed-off-by: Paul Mundt --- drivers/tty/serial/sh-sci.c | 15 ++++++++++++++- 1 file changed, 14 insertions(+), 1 deletion(-) (limited to 'drivers/tty/serial/sh-sci.c') diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c index 680d34a..46deaae 100644 --- a/drivers/tty/serial/sh-sci.c +++ b/drivers/tty/serial/sh-sci.c @@ -1113,10 +1113,23 @@ static unsigned int sci_tx_empty(struct uart_port *port) * handled via the ->init_pins() op, which is a bit of a one-way street, * lacking any ability to defer pin control -- this will later be * converted over to the GPIO framework). + * + * Other modes (such as loopback) are supported generically on certain + * port types, but not others. For these it's sufficient to test for the + * existence of the support register and simply ignore the port type. */ static void sci_set_mctrl(struct uart_port *port, unsigned int mctrl) { - /* Nothing to do here. */ + if (mctrl & TIOCM_LOOP) { + struct plat_sci_reg *reg; + + /* + * Standard loopback mode for SCFCR ports. + */ + reg = sci_getreg(port, SCFCR); + if (reg->size) + sci_out(port, SCFCR, sci_in(port, SCFCR) | 1); + } } static unsigned int sci_get_mctrl(struct uart_port *port) -- cgit v1.1