From eab3a0ee342106a1c82e10682c02632e9d6af0df Mon Sep 17 00:00:00 2001 From: Bjorn Helgaas Date: Wed, 27 Aug 2014 14:38:14 -0600 Subject: PCI: Preserve BIOS PCI_COMMAND_SERR and PCI_COMMAND_PARITY settings Do not clear PCI_COMMAND_SERR or PCI_COMMAND_PARITY based on _HPP. The spec (ACPI rev 5.0, sec 6.2.7) says that when "Enable SERR" is set to 1, we should enable SERR in the command register. It says nothing about *disabling* SERR or PERR; in fact, the example in 6.2.7.1 says we should leave PERR alone unless "Enable PERR" is 1. For hot-added devices, this probably doesn't matter because they power up with these bits cleared. But in addition to hot-plugged devices, the spec allows the platform to use _HPP for "configuration of PCI devices not configured by the BIOS at system boot," and it may make a difference for devices present at boot. This change means that if BIOS enables SERR or PERR on a device, and it supplies _HPP or _HPX with the SERR or PERR bits *cleared*, we will now leave SERR or PERR reporting enabled on that device instead of disabling it as we previously did. See also 40abb96c51bb ("pciehp: Fix programming hotplug parameters"), where this code was first added. Signed-off-by: Bjorn Helgaas Acked-by: Yinghai Lu --- drivers/pci/probe.c | 8 -------- 1 file changed, 8 deletions(-) (limited to 'drivers/pci/probe.c') diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c index 003d112..a16b347 100644 --- a/drivers/pci/probe.c +++ b/drivers/pci/probe.c @@ -1264,12 +1264,8 @@ static void program_hpp_type0(struct pci_dev *dev, struct hpp_type0 *hpp) pci_read_config_word(dev, PCI_COMMAND, &pci_cmd); if (hpp->enable_serr) pci_cmd |= PCI_COMMAND_SERR; - else - pci_cmd &= ~PCI_COMMAND_SERR; if (hpp->enable_perr) pci_cmd |= PCI_COMMAND_PARITY; - else - pci_cmd &= ~PCI_COMMAND_PARITY; pci_write_config_word(dev, PCI_COMMAND, pci_cmd); /* Program bridge control value */ @@ -1279,12 +1275,8 @@ static void program_hpp_type0(struct pci_dev *dev, struct hpp_type0 *hpp) pci_read_config_word(dev, PCI_BRIDGE_CONTROL, &pci_bctl); if (hpp->enable_serr) pci_bctl |= PCI_BRIDGE_CTL_SERR; - else - pci_bctl &= ~PCI_BRIDGE_CTL_SERR; if (hpp->enable_perr) pci_bctl |= PCI_BRIDGE_CTL_PARITY; - else - pci_bctl &= ~PCI_BRIDGE_CTL_PARITY; pci_write_config_word(dev, PCI_BRIDGE_CONTROL, pci_bctl); } } -- cgit v1.1