From 25985edcedea6396277003854657b5f3cb31a628 Mon Sep 17 00:00:00 2001 From: Lucas De Marchi Date: Wed, 30 Mar 2011 22:57:33 -0300 Subject: Fix common misspellings Fixes generated by 'codespell' and manually reviewed. Signed-off-by: Lucas De Marchi --- drivers/net/wireless/rt2x00/rt2800.h | 2 +- drivers/net/wireless/rt2x00/rt2800lib.c | 2 +- drivers/net/wireless/rt2x00/rt2x00.h | 8 ++++---- drivers/net/wireless/rt2x00/rt2x00config.c | 2 +- drivers/net/wireless/rt2x00/rt2x00crypto.c | 2 +- drivers/net/wireless/rt2x00/rt2x00dump.h | 2 +- drivers/net/wireless/rt2x00/rt2x00link.c | 2 +- drivers/net/wireless/rt2x00/rt2x00queue.c | 6 +++--- drivers/net/wireless/rt2x00/rt2x00queue.h | 12 ++++++------ drivers/net/wireless/rt2x00/rt2x00usb.c | 2 +- drivers/net/wireless/rt2x00/rt2x00usb.h | 2 +- 11 files changed, 21 insertions(+), 21 deletions(-) (limited to 'drivers/net/wireless/rt2x00') diff --git a/drivers/net/wireless/rt2x00/rt2800.h b/drivers/net/wireless/rt2x00/rt2800.h index 70b9abb..8fbc5fa 100644 --- a/drivers/net/wireless/rt2x00/rt2800.h +++ b/drivers/net/wireless/rt2x00/rt2800.h @@ -616,7 +616,7 @@ * READ_CONTROL: 0 write BBP, 1 read BBP * BUSY: ASIC is busy executing BBP commands * BBP_PAR_DUR: 0 4 MAC clocks, 1 8 MAC clocks - * BBP_RW_MODE: 0 serial, 1 paralell + * BBP_RW_MODE: 0 serial, 1 parallel */ #define BBP_CSR_CFG 0x101c #define BBP_CSR_CFG_VALUE FIELD32(0x000000ff) diff --git a/drivers/net/wireless/rt2x00/rt2800lib.c b/drivers/net/wireless/rt2x00/rt2800lib.c index 2ee6ceb..dbf74d0 100644 --- a/drivers/net/wireless/rt2x00/rt2800lib.c +++ b/drivers/net/wireless/rt2x00/rt2800lib.c @@ -1518,7 +1518,7 @@ static void rt2800_config_channel_rf2xxx(struct rt2x00_dev *rt2x00dev, if (rf->channel > 14) { /* * When TX power is below 0, we should increase it by 7 to - * make it a positive value (Minumum value is -7). + * make it a positive value (Minimum value is -7). * However this means that values between 0 and 7 have * double meaning, and we should set a 7DBm boost flag. */ diff --git a/drivers/net/wireless/rt2x00/rt2x00.h b/drivers/net/wireless/rt2x00/rt2x00.h index a3940d7..7f10239 100644 --- a/drivers/net/wireless/rt2x00/rt2x00.h +++ b/drivers/net/wireless/rt2x00/rt2x00.h @@ -484,13 +484,13 @@ struct rt2x00intf_conf { enum nl80211_iftype type; /* - * TSF sync value, this is dependant on the operation type. + * TSF sync value, this is dependent on the operation type. */ enum tsf_sync sync; /* - * The MAC and BSSID addressess are simple array of bytes, - * these arrays are little endian, so when sending the addressess + * The MAC and BSSID addresses are simple array of bytes, + * these arrays are little endian, so when sending the addresses * to the drivers, copy the it into a endian-signed variable. * * Note that all devices (except rt2500usb) have 32 bits @@ -1131,7 +1131,7 @@ void rt2x00queue_stop_queue(struct data_queue *queue); * @drop: True to drop all pending frames. * * This function will flush the queue. After this call - * the queue is guarenteed to be empty. + * the queue is guaranteed to be empty. */ void rt2x00queue_flush_queue(struct data_queue *queue, bool drop); diff --git a/drivers/net/wireless/rt2x00/rt2x00config.c b/drivers/net/wireless/rt2x00/rt2x00config.c index e7f67d5..9416e36 100644 --- a/drivers/net/wireless/rt2x00/rt2x00config.c +++ b/drivers/net/wireless/rt2x00/rt2x00config.c @@ -60,7 +60,7 @@ void rt2x00lib_config_intf(struct rt2x00_dev *rt2x00dev, * Note that when NULL is passed as address we will send * 00:00:00:00:00 to the device to clear the address. * This will prevent the device being confused when it wants - * to ACK frames or consideres itself associated. + * to ACK frames or considers itself associated. */ memset(conf.mac, 0, sizeof(conf.mac)); if (mac) diff --git a/drivers/net/wireless/rt2x00/rt2x00crypto.c b/drivers/net/wireless/rt2x00/rt2x00crypto.c index 5e9074b..3f5688f 100644 --- a/drivers/net/wireless/rt2x00/rt2x00crypto.c +++ b/drivers/net/wireless/rt2x00/rt2x00crypto.c @@ -237,7 +237,7 @@ void rt2x00crypto_rx_insert_iv(struct sk_buff *skb, } /* - * NOTE: Always count the payload as transfered, + * NOTE: Always count the payload as transferred, * even when alignment was set to zero. This is required * for determining the correct offset for the ICV data. */ diff --git a/drivers/net/wireless/rt2x00/rt2x00dump.h b/drivers/net/wireless/rt2x00/rt2x00dump.h index 5d6e0b8..063ebcc 100644 --- a/drivers/net/wireless/rt2x00/rt2x00dump.h +++ b/drivers/net/wireless/rt2x00/rt2x00dump.h @@ -51,7 +51,7 @@ * [rt2x00dump header][hardware descriptor][ieee802.11 frame] * * rt2x00dump header: The description of the dumped frame, as well as - * additional information usefull for debugging. See &rt2x00dump_hdr. + * additional information useful for debugging. See &rt2x00dump_hdr. * hardware descriptor: Descriptor that was used to receive or transmit * the frame. * ieee802.11 frame: The actual frame that was received or transmitted. diff --git a/drivers/net/wireless/rt2x00/rt2x00link.c b/drivers/net/wireless/rt2x00/rt2x00link.c index c975b0a..29abfde 100644 --- a/drivers/net/wireless/rt2x00/rt2x00link.c +++ b/drivers/net/wireless/rt2x00/rt2x00link.c @@ -283,7 +283,7 @@ void rt2x00link_start_tuner(struct rt2x00_dev *rt2x00dev) /** * While scanning, link tuning is disabled. By default * the most sensitive settings will be used to make sure - * that all beacons and probe responses will be recieved + * that all beacons and probe responses will be received * during the scan. */ if (test_bit(DEVICE_STATE_SCANNING, &rt2x00dev->flags)) diff --git a/drivers/net/wireless/rt2x00/rt2x00queue.c b/drivers/net/wireless/rt2x00/rt2x00queue.c index 4b3c70e..4358051 100644 --- a/drivers/net/wireless/rt2x00/rt2x00queue.c +++ b/drivers/net/wireless/rt2x00/rt2x00queue.c @@ -546,7 +546,7 @@ int rt2x00queue_write_tx_frame(struct data_queue *queue, struct sk_buff *skb, } /* - * When DMA allocation is required we should guarentee to the + * When DMA allocation is required we should guarantee to the * driver that the DMA is aligned to a 4-byte boundary. * However some drivers require L2 padding to pad the payload * rather then the header. This could be a requirement for @@ -689,7 +689,7 @@ void rt2x00queue_for_each_entry(struct data_queue *queue, spin_unlock_irqrestore(&queue->index_lock, irqflags); /* - * Start from the TX done pointer, this guarentees that we will + * Start from the TX done pointer, this guarantees that we will * send out all frames in the correct order. */ if (index_start < index_end) { @@ -883,7 +883,7 @@ void rt2x00queue_flush_queue(struct data_queue *queue, bool drop) } /* - * Check if driver supports flushing, we can only guarentee + * Check if driver supports flushing, we can only guarantee * full support for flushing if the driver is able * to cancel all pending frames (drop = true). */ diff --git a/drivers/net/wireless/rt2x00/rt2x00queue.h b/drivers/net/wireless/rt2x00/rt2x00queue.h index 0c8b0c6..217861f 100644 --- a/drivers/net/wireless/rt2x00/rt2x00queue.h +++ b/drivers/net/wireless/rt2x00/rt2x00queue.h @@ -344,8 +344,8 @@ struct txentry_desc { * only be touched after the device has signaled it is done with it. * @ENTRY_DATA_PENDING: This entry contains a valid frame and is waiting * for the signal to start sending. - * @ENTRY_DATA_IO_FAILED: Hardware indicated that an IO error occured - * while transfering the data to the hardware. No TX status report will + * @ENTRY_DATA_IO_FAILED: Hardware indicated that an IO error occurred + * while transferring the data to the hardware. No TX status report will * be expected from the hardware. * @ENTRY_DATA_STATUS_PENDING: The entry has been send to the device and * returned. It is now waiting for the status reporting before the @@ -365,7 +365,7 @@ enum queue_entry_flags { * @flags: Entry flags, see &enum queue_entry_flags. * @queue: The data queue (&struct data_queue) to which this entry belongs. * @skb: The buffer which is currently being transmitted (for TX queue), - * or used to directly recieve data in (for RX queue). + * or used to directly receive data in (for RX queue). * @entry_idx: The entry index number. * @priv_data: Private data belonging to this queue entry. The pointer * points to data specific to a particular driver and queue type. @@ -388,7 +388,7 @@ struct queue_entry { * @Q_INDEX: Index pointer to the current entry in the queue, if this entry is * owned by the hardware then the queue is considered to be full. * @Q_INDEX_DMA_DONE: Index pointer for the next entry which will have been - * transfered to the hardware. + * transferred to the hardware. * @Q_INDEX_DONE: Index pointer to the next entry which will be completed by * the hardware and for which we need to run the txdone handler. If this * entry is not owned by the hardware the queue is considered to be empty. @@ -627,7 +627,7 @@ static inline int rt2x00queue_threshold(struct data_queue *queue) } /** - * rt2x00queue_status_timeout - Check if a timeout occured for STATUS reports + * rt2x00queue_status_timeout - Check if a timeout occurred for STATUS reports * @queue: Queue to check. */ static inline int rt2x00queue_status_timeout(struct data_queue *queue) @@ -637,7 +637,7 @@ static inline int rt2x00queue_status_timeout(struct data_queue *queue) } /** - * rt2x00queue_timeout - Check if a timeout occured for DMA transfers + * rt2x00queue_timeout - Check if a timeout occurred for DMA transfers * @queue: Queue to check. */ static inline int rt2x00queue_dma_timeout(struct data_queue *queue) diff --git a/drivers/net/wireless/rt2x00/rt2x00usb.c b/drivers/net/wireless/rt2x00/rt2x00usb.c index fbe735f..36f388f 100644 --- a/drivers/net/wireless/rt2x00/rt2x00usb.c +++ b/drivers/net/wireless/rt2x00/rt2x00usb.c @@ -173,7 +173,7 @@ static void rt2x00usb_work_txdone_entry(struct queue_entry *entry) /* * If the transfer to hardware succeeded, it does not mean the * frame was send out correctly. It only means the frame - * was succesfully pushed to the hardware, we have no + * was successfully pushed to the hardware, we have no * way to determine the transmission status right now. * (Only indirectly by looking at the failed TX counters * in the register). diff --git a/drivers/net/wireless/rt2x00/rt2x00usb.h b/drivers/net/wireless/rt2x00/rt2x00usb.h index 6aaf51f..e11c759 100644 --- a/drivers/net/wireless/rt2x00/rt2x00usb.h +++ b/drivers/net/wireless/rt2x00/rt2x00usb.h @@ -400,7 +400,7 @@ void rt2x00usb_flush_queue(struct data_queue *queue); * @rt2x00dev: Pointer to &struct rt2x00_dev * * Check the health of the USB communication and determine - * if timeouts have occured. If this is the case, this function + * if timeouts have occurred. If this is the case, this function * will reset all communication to restore functionality again. */ void rt2x00usb_watchdog(struct rt2x00_dev *rt2x00dev); -- cgit v1.1