From cb4281528b62207918b1e95827cad7527aa4dbaa Mon Sep 17 00:00:00 2001 From: Tamizh chelvam Date: Thu, 2 Feb 2017 08:32:18 +0200 Subject: ath10k: fix boot failure in UTF mode/testmode Rx filter reset and the dynamic tx switch mode (EXT_RESOURCE_CFG) configuration are causing the following errors when UTF firmware is loaded to the target. Error message 1: [ 598.015629] ath10k_pci 0001:01:00.0: failed to ping firmware: -110 [ 598.020828] ath10k_pci 0001:01:00.0: failed to reset rx filter: -110 [ 598.141556] ath10k_pci 0001:01:00.0: failed to start core (testmode): -110 Error message 2: [ 668.615839] ath10k_ahb a000000.wifi: failed to send ext resource cfg command : -95 [ 668.618902] ath10k_ahb a000000.wifi: failed to start core (testmode): -95 Avoiding these configurations while bringing the target in testmode is solving the problem. Cc: stable@vger.kernel.org Signed-off-by: Tamizh chelvam Signed-off-by: Kalle Valo --- drivers/net/wireless/ath/ath10k/core.c | 14 +++++++++----- 1 file changed, 9 insertions(+), 5 deletions(-) (limited to 'drivers/net/wireless/ath/ath10k') diff --git a/drivers/net/wireless/ath/ath10k/core.c b/drivers/net/wireless/ath/ath10k/core.c index c2afcca..c27e7ea 100644 --- a/drivers/net/wireless/ath/ath10k/core.c +++ b/drivers/net/wireless/ath/ath10k/core.c @@ -1996,7 +1996,8 @@ int ath10k_core_start(struct ath10k *ar, enum ath10k_firmware_mode mode, ath10k_dbg(ar, ATH10K_DBG_BOOT, "firmware %s booted\n", ar->hw->wiphy->fw_version); - if (test_bit(WMI_SERVICE_EXT_RES_CFG_SUPPORT, ar->wmi.svc_map)) { + if (test_bit(WMI_SERVICE_EXT_RES_CFG_SUPPORT, ar->wmi.svc_map) && + mode == ATH10K_FIRMWARE_MODE_NORMAL) { val = 0; if (ath10k_peer_stats_enabled(ar)) val = WMI_10_4_PEER_STATS; @@ -2049,10 +2050,13 @@ int ath10k_core_start(struct ath10k *ar, enum ath10k_firmware_mode mode, * possible to implicitly make it correct by creating a dummy vdev and * then deleting it. */ - status = ath10k_core_reset_rx_filter(ar); - if (status) { - ath10k_err(ar, "failed to reset rx filter: %d\n", status); - goto err_hif_stop; + if (mode == ATH10K_FIRMWARE_MODE_NORMAL) { + status = ath10k_core_reset_rx_filter(ar); + if (status) { + ath10k_err(ar, + "failed to reset rx filter: %d\n", status); + goto err_hif_stop; + } } /* If firmware indicates Full Rx Reorder support it must be used in a -- cgit v1.1