From 31ea9d5dfd27b9aa6f92c207041eba8e81f4c497 Mon Sep 17 00:00:00 2001 From: Xie Xiaobo Date: Fri, 22 May 2015 13:07:19 +0800 Subject: powerpc/85xx: p1025twr: add module conditional to fix QE-uart issue A ioport setting was needed when used the QE uart function on TWR-P1025. Added a conditional definition to avoid missing this setting when the QE-uart driver was bulit to a module. Signed-off-by: Xie Xiaobo Signed-off-by: Li Pengbo Signed-off-by: Scott Wood --- arch/powerpc/platforms/85xx/twr_p102x.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) (limited to 'arch/powerpc/platforms') diff --git a/arch/powerpc/platforms/85xx/twr_p102x.c b/arch/powerpc/platforms/85xx/twr_p102x.c index 1eadb6d..30e002f 100644 --- a/arch/powerpc/platforms/85xx/twr_p102x.c +++ b/arch/powerpc/platforms/85xx/twr_p102x.c @@ -79,7 +79,7 @@ static void __init twr_p1025_setup_arch(void) mpc85xx_qe_init(); mpc85xx_qe_par_io_init(); -#if defined(CONFIG_UCC_GETH) || defined(CONFIG_SERIAL_QE) +#if IS_ENABLED(CONFIG_UCC_GETH) || IS_ENABLED(CONFIG_SERIAL_QE) if (machine_is(twr_p1025)) { struct ccsr_guts __iomem *guts; @@ -101,7 +101,7 @@ static void __init twr_p1025_setup_arch(void) MPC85xx_PMUXCR_QE(12)); iounmap(guts); -#if defined(CONFIG_SERIAL_QE) +#if IS_ENABLED(CONFIG_SERIAL_QE) /* On P1025TWR board, the UCC7 acted as UART port. * However, The UCC7's CTS pin is low level in default, * it will impact the transmission in full duplex -- cgit v1.1