From 0f8dc2f06560e2ca126d1670a24126ba08357d38 Mon Sep 17 00:00:00 2001 From: Andi Kleen Date: Fri, 29 Jun 2007 16:16:36 +0200 Subject: Revert HPET resource reservation Matthias Lenk reports that the PCI subsystem would move the HPET on SB400/SB600-based systems, where the HPET is in BAR1 of the SMbus controller. The reason? The ACPI layer registered the PCI MMIO range as being busy too early, before PCI enumeration had happened, causing the PCI layer to decide that it should relocate the resources somewhere else. Firmware resources should be marked busy _after_ the PCI enumeration and probing has happened, not before. Remove the too-early reservation, we'll fix it up to do it properly later. In the meantime, this solves the regression. Tested-by: Matthias Lenk Cc: Aaron Durbin Cc: Andrew Morton Signed-off-by: Linus Torvalds --- arch/i386/kernel/acpi/boot.c | 19 ------------------- 1 file changed, 19 deletions(-) (limited to 'arch/i386/kernel') diff --git a/arch/i386/kernel/acpi/boot.c b/arch/i386/kernel/acpi/boot.c index 280898b..3e497fd 100644 --- a/arch/i386/kernel/acpi/boot.c +++ b/arch/i386/kernel/acpi/boot.c @@ -636,29 +636,10 @@ static int __init acpi_parse_hpet(struct acpi_table_header *table) return -1; } -#define HPET_RESOURCE_NAME_SIZE 9 - hpet_res = alloc_bootmem(sizeof(*hpet_res) + HPET_RESOURCE_NAME_SIZE); - if (hpet_res) { - memset(hpet_res, 0, sizeof(*hpet_res)); - hpet_res->name = (void *)&hpet_res[1]; - hpet_res->flags = IORESOURCE_MEM | IORESOURCE_BUSY; - snprintf((char *)hpet_res->name, HPET_RESOURCE_NAME_SIZE, - "HPET %u", hpet_tbl->sequence); - hpet_res->end = (1 * 1024) - 1; - } - hpet_address = hpet_tbl->address.address; printk(KERN_INFO PREFIX "HPET id: %#x base: %#lx\n", hpet_tbl->id, hpet_address); - res_start = hpet_address; - - if (hpet_res) { - hpet_res->start = res_start; - hpet_res->end += res_start; - insert_resource(&iomem_resource, hpet_res); - } - return 0; } #else -- cgit v1.1