From 01dd2fbf0da4019c380b6ca22a074538fb31db5a Mon Sep 17 00:00:00 2001 From: Matt LaPlante Date: Sat, 20 Oct 2007 01:34:40 +0200 Subject: typo fixes Most of these fixes were already submitted for old kernel versions, and were approved, but for some reason they never made it into the releases. Because this is a consolidation of a couple old missed patches, it touches both Kconfigs and documentation texts. Signed-off-by: Matt LaPlante Acked-by: Randy Dunlap Signed-off-by: Adrian Bunk --- Documentation/sound/alsa/soc/DAI.txt | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) (limited to 'Documentation/sound/alsa/soc/DAI.txt') diff --git a/Documentation/sound/alsa/soc/DAI.txt b/Documentation/sound/alsa/soc/DAI.txt index 58cbfd0..3feeb9e 100644 --- a/Documentation/sound/alsa/soc/DAI.txt +++ b/Documentation/sound/alsa/soc/DAI.txt @@ -20,12 +20,12 @@ I2S === I2S is a common 4 wire DAI used in HiFi, STB and portable devices. The Tx and -Rx lines are used for audio transmision, whilst the bit clock (BCLK) and +Rx lines are used for audio transmission, whilst the bit clock (BCLK) and left/right clock (LRC) synchronise the link. I2S is flexible in that either the controller or CODEC can drive (master) the BCLK and LRC clock lines. Bit clock usually varies depending on the sample rate and the master system clock (SYSCLK). LRCLK is the same as the sample rate. A few devices support separate -ADC and DAC LRCLK's, this allows for similtanious capture and playback at +ADC and DAC LRCLK's, this allows for simultaneous capture and playback at different sample rates. I2S has several different operating modes:- @@ -41,12 +41,12 @@ I2S has several different operating modes:- PCM === -PCM is another 4 wire interface, very similar to I2S, that can support a more +PCM is another 4 wire interface, very similar to I2S, which can support a more flexible protocol. It has bit clock (BCLK) and sync (SYNC) lines that are used to synchronise the link whilst the Tx and Rx lines are used to transmit and receive the audio data. Bit clock usually varies depending on sample rate whilst sync runs at the sample rate. PCM also supports Time Division -Multiplexing (TDM) in that several devices can use the bus similtaniuosly (This +Multiplexing (TDM) in that several devices can use the bus simultaneously (this is sometimes referred to as network mode). Common PCM operating modes:- -- cgit v1.1