From 84899d394e755989a1cc080083080f7695c36467 Mon Sep 17 00:00:00 2001 From: Guenter Roeck Date: Mon, 12 May 2014 11:10:56 -0700 Subject: hwmon: (emc1403) Make all hyst attributes except for temp1_crit_hyst read-only All chips in this chip series only support a single hysteresis value. Having multiple writable hysteresis attributes is therefore confusing, since a single write affects all hysteresis temperatures. Make all but one (temp1_crit_hyst) read-only. Reviewed-by: Jean Delvare Signed-off-by: Guenter Roeck --- Documentation/hwmon/emc1403 | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-) (limited to 'Documentation/hwmon') diff --git a/Documentation/hwmon/emc1403 b/Documentation/hwmon/emc1403 index b109e35..a869b0e 100644 --- a/Documentation/hwmon/emc1403 +++ b/Documentation/hwmon/emc1403 @@ -51,6 +51,9 @@ This implementation detail implies the following: was 80 degrees C, and the hysteresis was 75 degrees C, and you change the critical limit to 90 degrees C, then the hysteresis will automatically change to 85 degrees C. -* While hysteresis limits can be set for all critical limits, setting a single - hysteresis value affects the hysteresis values for all limits on all sensors. +* The hysteresis values can't be set independently. We decided to make + only temp1_crit_hyst writable, while all other hysteresis attributes + are read-only. Setting temp1_crit_hyst writes the difference between + temp1_crit_hyst and temp1_crit into the chip, and the same relative + hysteresis applies automatically to all other limits. * The limits should be set before the hysteresis. -- cgit v1.1