From 3a85ca9d8a06c873b7a5fb24319572926fa20e10 Mon Sep 17 00:00:00 2001 From: Brian Austin Date: Fri, 15 Nov 2013 09:35:34 -0600 Subject: ASoC: dt: binding: sound cs42l52 driver Signed-off-by: Brian Austin Signed-off-by: Mark Brown --- .../devicetree/bindings/sound/cs42l52.txt | 46 ++++++++++++++++++++++ 1 file changed, 46 insertions(+) create mode 100644 Documentation/devicetree/bindings/sound/cs42l52.txt (limited to 'Documentation/devicetree/bindings/sound/cs42l52.txt') diff --git a/Documentation/devicetree/bindings/sound/cs42l52.txt b/Documentation/devicetree/bindings/sound/cs42l52.txt new file mode 100644 index 0000000..bc03c93 --- /dev/null +++ b/Documentation/devicetree/bindings/sound/cs42l52.txt @@ -0,0 +1,46 @@ +CS42L52 audio CODEC + +Required properties: + + - compatible : "cirrus,cs42l52" + + - reg : the I2C address of the device for I2C + +Optional properties: + + - cirrus,reset-gpio : GPIO controller's phandle and the number + of the GPIO used to reset the codec. + + - cirrus,chgfreq-divisor : Values used to set the Charge Pump Frequency. + Allowable values of 0x00 through 0x0F. These are raw values written to the + register, not the actual frequency. The frequency is determined by the following. + Frequency = (64xFs)/(N+2) + N = chgfreq_val + Fs = Sample Rate (variable) + + - cirrus,mica-differential-cfg : boolean, If present, then the MICA input is configured + as a differential input. If not present then the MICA input is configured as + Single-ended input. Single-ended mode allows for MIC1 or MIC2 muxing for input. + + - cirrus,micb-differential-cfg : boolean, If present, then the MICB input is configured + as a differential input. If not present then the MICB input is configured as + Single-ended input. Single-ended mode allows for MIC1 or MIC2 muxing for input. + + - cirrus,micbias-lvl: Set the output voltage level on the MICBIAS Pin + 0 = 0.5 x VA + 1 = 0.6 x VA + 2 = 0.7 x VA + 3 = 0.8 x VA + 4 = 0.83 x VA + 5 = 0.91 x VA + +Example: + +codec: codec@4a { + compatible = "cirrus,cs42l52"; + reg = <0x4a>; + reset-gpio = <&gpio 10 0>; + cirrus,chgfreq-divisor = <0x05>; + cirrus.mica-differential-cfg; + cirrus,micbias-lvl = <5>; +}; -- cgit v1.1