summaryrefslogtreecommitdiffstats
path: root/mm/vmscan.c
Commit message (Collapse)AuthorAgeFilesLines
* [PATCH] cpusets: formalize intermediate GFP_KERNEL containmentPaul Jackson2005-09-071-4/+4
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | This patch makes use of the previously underutilized cpuset flag 'mem_exclusive' to provide what amounts to another layer of memory placement resolution. With this patch, there are now the following four layers of memory placement available: 1) The whole system (interrupt and GFP_ATOMIC allocations can use this), 2) The nearest enclosing mem_exclusive cpuset (GFP_KERNEL allocations can use), 3) The current tasks cpuset (GFP_USER allocations constrained to here), and 4) Specific node placement, using mbind and set_mempolicy. These nest - each layer is a subset (same or within) of the previous. Layer (2) above is new, with this patch. The call used to check whether a zone (its node, actually) is in a cpuset (in its mems_allowed, actually) is extended to take a gfp_mask argument, and its logic is extended, in the case that __GFP_HARDWALL is not set in the flag bits, to look up the cpuset hierarchy for the nearest enclosing mem_exclusive cpuset, to determine if placement is allowed. The definition of GFP_USER, which used to be identical to GFP_KERNEL, is changed to also set the __GFP_HARDWALL bit, in the previous cpuset_gfp_hardwall_flag patch. GFP_ATOMIC and GFP_KERNEL allocations will stay within the current tasks cpuset, so long as any node therein is not too tight on memory, but will escape to the larger layer, if need be. The intended use is to allow something like a batch manager to handle several jobs, each job in its own cpuset, but using common kernel memory for caches and such. Swapper and oom_kill activity is also constrained to Layer (2). A task in or below one mem_exclusive cpuset should not cause swapping on nodes in another non-overlapping mem_exclusive cpuset, nor provoke oom_killing of a task in another such cpuset. Heavy use of kernel memory for i/o caching and such by one job should not impact the memory available to jobs in other non-overlapping mem_exclusive cpusets. This patch enables providing hardwall, inescapable cpusets for memory allocations of each job, while sharing kernel memory allocations between several jobs, in an enclosing mem_exclusive cpuset. Like Dinakar's patch earlier to enable administering sched domains using the cpu_exclusive flag, this patch also provides a useful meaning to a cpuset flag that had previously done nothing much useful other than restrict what cpuset configurations were allowed. Signed-off-by: Paul Jackson <pj@sgi.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] VM: zone reclaim atomic ops cleanupMartin Hicks2005-09-051-4/+5
| | | | | | | | | | Christoph Lameter and Marcelo Tosatti asked to get rid of the atomic_inc_and_test() to cleanup the atomic ops in the zone reclaim code. Signed-off-by: Martin Hicks <mort@sgi.com> Signed-off-by: Christoph Lameter <clameter@sgi.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] VM: add capabilites check to set_zone_reclaimMartin Hicks2005-09-051-0/+3
| | | | | | | | | Add a capability check to sys_set_zone_reclaim(). This syscall is not something that should be available to a user. Signed-off-by: Martin Hicks <mort@sgi.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] rename wakeup_bdflush to wakeup_pdflushPekka J Enberg2005-06-281-1/+1
| | | | | | Signed-off-by: Pekka Enberg <penberg@cs.helsinki.fi> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] Cleanup patch for process freezingChristoph Lameter2005-06-251-2/+2
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | 1. Establish a simple API for process freezing defined in linux/include/sched.h: frozen(process) Check for frozen process freezing(process) Check if a process is being frozen freeze(process) Tell a process to freeze (go to refrigerator) thaw_process(process) Restart process frozen_process(process) Process is frozen now 2. Remove all references to PF_FREEZE and PF_FROZEN from all kernel sources except sched.h 3. Fix numerous locations where try_to_freeze is manually done by a driver 4. Remove the argument that is no longer necessary from two function calls. 5. Some whitespace cleanup 6. Clear potential race in refrigerator (provides an open window of PF_FREEZE cleared before setting PF_FROZEN, recalc_sigpending does not check PF_FROZEN). This patch does not address the problem of freeze_processes() violating the rule that a task may only modify its own flags by setting PF_FREEZE. This is not clean in an SMP environment. freeze(process) is therefore not SMP safe! Signed-off-by: Christoph Lameter <christoph@lameter.com> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] vm: try_to_free_pages unused argumentDarren Hart2005-06-211-2/+1
| | | | | | | | | | try_to_free_pages accepts a third argument, order, but hasn't used it since before 2.6.0. The following patch removes the argument and updates all the calls to try_to_free_pages. Signed-off-by: Darren Hart <dvhltc@us.ibm.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] VM: rate limit early reclaimMartin Hicks2005-06-211-0/+10
| | | | | | | | | | | When early zone reclaim is turned on the LRU is scanned more frequently when a zone is low on memory. This limits when the zone reclaim can be called by skipping the scan if another thread (either via kswapd or sync reclaim) is already reclaiming from the zone. Signed-off-by: Martin Hicks <mort@sgi.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] VM: early zone reclaimMartin Hicks2005-06-211-0/+64
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | This is the core of the (much simplified) early reclaim. The goal of this patch is to reclaim some easily-freed pages from a zone before falling back onto another zone. One of the major uses of this is NUMA machines. With the default allocator behavior the allocator would look for memory in another zone, which might be off-node, before trying to reclaim from the current zone. This adds a zone tuneable to enable early zone reclaim. It is selected on a per-zone basis and is turned on/off via syscall. Adding some extra throttling on the reclaim was also required (patch 4/4). Without the machine would grind to a crawl when doing a "make -j" kernel build. Even with this patch the System Time is higher on average, but it seems tolerable. Here are some numbers for kernbench runs on a 2-node, 4cpu, 8Gig RAM Altix in the "make -j" run: wall user sys %cpu ctx sw. sleeps ---- ---- --- ---- ------ ------ No patch 1009 1384 847 258 298170 504402 w/patch, no reclaim 880 1376 667 288 254064 396745 w/patch & reclaim 1079 1385 926 252 291625 548873 These numbers are the average of 2 runs of 3 "make -j" runs done right after system boot. Run-to-run variability for "make -j" is huge, so these numbers aren't terribly useful except to seee that with reclaim the benchmark still finishes in a reasonable amount of time. I also looked at the NUMA hit/miss stats for the "make -j" runs and the reclaim doesn't make any difference when the machine is thrashing away. Doing a "make -j8" on a single node that is filled with page cache pages takes 700 seconds with reclaim turned on and 735 seconds without reclaim (due to remote memory accesses). The simple zone_reclaim syscall program is at http://www.bork.org/~mort/sgi/zone_reclaim.c Signed-off-by: Martin Hicks <mort@sgi.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] VM: add may_swap flag to scan_controlMartin Hicks2005-06-211-1/+6
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | Here's the next round of these patches. These are totally different in an attempt to meet the "simpler" request after the last patches. For reference the earlier threads are: http://marc.theaimsgroup.com/?l=linux-kernel&m=110839604924587&w=2 http://marc.theaimsgroup.com/?l=linux-mm&m=111461480721249&w=2 This set of patches replaces my other vm- patches that are currently in -mm. So they're against 2.6.12-rc5-mm1 about half way through the -mm patchset. As I said already this patch is a lot simpler. The reclaim is turned on or off on a per-zone basis using a syscall. I haven't tested the x86 syscall, so it might be wrong. It uses the existing reclaim/pageout code with the small addition of a may_swap flag to scan_control (patch 1/4). I also added __GFP_NORECLAIM (patch 3/4) so that certain allocation types can be flagged to never cause reclaim. This was a deficiency that was in all of my earlier patch sets. Previously, doing a big buffered read would fill one zone with page cache and then start to reclaim from that same zone, leaving the other zones untouched. Adding some extra throttling on the reclaim was also required (patch 4/4). Without the machine would grind to a crawl when doing a "make -j" kernel build. Even with this patch the System Time is higher on average, but it seems tolerable. Here are some numbers for kernbench runs on a 2-node, 4cpu, 8Gig RAM Altix in the "make -j" run: wall user sys %cpu ctx sw. sleeps ---- ---- --- ---- ------ ------ No patch 1009 1384 847 258 298170 504402 w/patch, no reclaim 880 1376 667 288 254064 396745 w/patch & reclaim 1079 1385 926 252 291625 548873 These numbers are the average of 2 runs of 3 "make -j" runs done right after system boot. Run-to-run variability for "make -j" is huge, so these numbers aren't terribly useful except to seee that with reclaim the benchmark still finishes in a reasonable amount of time. I also looked at the NUMA hit/miss stats for the "make -j" runs and the reclaim doesn't make any difference when the machine is thrashing away. Doing a "make -j8" on a single node that is filled with page cache pages takes 700 seconds with reclaim turned on and 735 seconds without reclaim (due to remote memory accesses). The simple zone_reclaim syscall program is at http://www.bork.org/~mort/sgi/zone_reclaim.c This patch: This adds an extra switch to the scan_control struct. It simply lets the reclaim code know if its allowed to swap pages out. This was required for a simple per-zone reclaimer. Without this addition pages would be swapped out as soon as a zone ran out of memory and the early reclaim kicked in. Signed-off-by: Martin Hicks <mort@sgi.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] vmscan: notice slab shrinkingakpm@osdl.org2005-06-211-5/+14
| | | | | | | | | | | | | | | | | | | | | | Fix a problem identified by Andrea Arcangeli <andrea@suse.de> kswapd will set a zone into all_unreclaimable state if it sees that we're not successfully reclaiming LRU pages. But that fails to notice that we're successfully reclaiming slab obects, so we can set all_unreclaimable too soon. So change shrink_slab() to return a success indication if it actually reclaimed some objects, and don't assume that the zone is all_unreclaimable if that is true. This means that we won't enter all_unreclaimable state if we are successfully freeing slab objects but we're not yet actually freeing slab pages, due to internal fragmentation. (hm, this has a shortcoming. We could be successfully freeing ZONE_NORMAL slab objects while being really oom on ZONE_DMA. If that happens then kswapd might burn a lot of CPU. But given that there might be some slab objects in ZONE_DMA, perhaps that is appropriate.) Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] vmscan: pageout(): remove unneeded testakpm@osdl.org2005-04-161-1/+1
| | | | | | | | | | | ) We only call pageout() for dirty pages, so this test is redundant. Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* Linux-2.6.12-rc2v2.6.12-rc2Linus Torvalds2005-04-161-0/+1311
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
OpenPOWER on IntegriCloud