summaryrefslogtreecommitdiffstats
path: root/drivers/nfc/Kconfig
Commit message (Collapse)AuthorAgeFilesLines
* NFC: nxp-nci: Add support for NXP NCI chipsClément Perrochaud2015-03-261-0/+1
| | | | | | | | Add support for NXP NCI NFC controllers such as the NPC100 or PN7150 families. Signed-off-by: Clément Perrochaud <clement.perrochaud@effinnov.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: st21nfcb: Add driver for STMicroelectronics ST21NFCB NFC chipChristophe Ricard2014-07-231-1/+1
| | | | | | | | | | | | | | | | | | | | | | | | Add driver for STMicroelectronics ST21NFCB NFC controller. ST21NFCB is using NCI protocol and a proprietary low level transport protocol called NDLC used on top. NDLC: The protocol defines 2 types of frame: - One type carrying NCI data (referred as DATAFRAME frames). - One type carrying protocol information used for flow control and error control mechanisms (referred as SUPERVISOR frames). After each frame transmission to the NFC controller, the device host SHALL waitfor an ACK (SUPERVISOR frame) reception before sending a new frame. The NFC controller MAY send a frame at anytime to the device host. The NFC controller MAY send a specific WAIT supervisor frame to indicate to device host that a NCI data packet has been received but that it could take significant time before the NFC controller sends an ACK and thus allows next data reception. Signed-off-by: Christophe Ricard <christophe-h.ricard@st.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: ST21NFCA: Add driver for STMicroelectronics ST21NFCA NFC ChipChristophe Ricard2014-04-221-0/+1
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | Add driver for STMicroelectronics ST21NFCA NFC controller. ST21NFCA is using HCI protocol, shdlc as LLC layer & I2C as communication protocol. Adding support for Reader/Writer mode with Tag type 1/2/3/4 A & B. It is using proprietary gate 15 for ISO14443-3 such as type 1 & type 2 tags. It is using proprietary gate 14 for type F tags. ST21NFCA_DEVICE_MGNT_GATE gives access to proprietary CLF configuration. Standard gate for ISO14443-4 A (13) & B (11) are also used. ST21NFCA specific mecanism: One particular point to notice for the data handling is that frame does not contain any length value. Therefore the i2c part of this driver is managing the reception with a read length sequence until the end of frame (0x7e) is reached. In order to avoid conflict between sof & eof a mecanism called byte stuffing concist of an escape byte (0x7d) insertion before special byte (0x7e, 0x7d). The special byte is then xored with 0x20. In this driver, When data are available in the CLF, the interrupt gpio is driven to active state and triggered an interrupt. Once the i2c_master_recv start, the interrupt gpio is driven to idle state until its complete. If the frame is incomplete or data are still available, interrupts will be triggered again. Signed-off-by: Christophe Ricard <christophe-h.ricard@st.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: trf7970a: Add driver with ISO/IEC 14443 Type 2 Tag SupportMark A. Greer2014-03-111-0/+12
| | | | | | | | | | | Add a driver for the Texas Instruments TRF7970a RFID/NFC/15693 transceiver. The driver currently supports ISO/IEC 14443 Type 2 tags only (MIFARE Ultralight and Ultralight C but not Classic). CC: Erick Macias <emacias@ti.com> CC: Felipe Balbi <balbi@ti.com> Signed-off-by: Mark A. Greer <mgreer@animalcreek.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: nfcmrvl: Initial commit for Marvell NFC driverAmitkumar Karwar2014-01-071-0/+1
| | | | | | | | This patch adds NFC support for Marvell 8897 NFC-over-USB chipset. Signed-off-by: Amitkumar Karwar <akarwar@marvell.com> Signed-off-by: Bing Zhao <bzhao@marvell.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: Sony Port-100 Series driverThierry Escande2013-10-071-0/+10
| | | | | | | | | | | | | | | | This adds support for the Sony NFC USB dongle RC-S380, based on the Port-100 chip. This dongle is an analog frontend and does not implement the digital layer. This driver uses the nfc_digital module which is an implementation of the NFC Digital Protocol stack. This patch is a skeleton. It only registers the dongle against the NFC digital protocol stack. All NFC digital operation functions are stubbed out. Signed-off-by: Thierry Escande <thierry.escande@linux.intel.com> Cc: Stephen Tiedemann <stephen.tiedemann@gmail.com> Tested-by: Cho, Yu-Chen <acho@suse.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: Add a nfc hardware simulation driverThierry Escande2013-06-141-0/+10
| | | | | | | | | | | | This driver declares two virtual NFC devices supporting NFC-DEP protocol. An LLCP connection can be established between them and all packets sent from one device is sent back to the other, acting as loopback devices. Once established, the LLCP link can be disconnected by disabling the target device (with rfkill, nfctool, or neard disable-adapter test script). Signed-off-by: Thierry Escande <thierry.escande@linux.intel.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: mei_phy depends on INTEL_MEISamuel Ortiz2013-05-211-1/+1
| | | | | | INTEL_MEI_BUS_NFC never made it upstream, so make it depend on INTEL_MEI. Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: mei: Add a common mei bus API for NFC driversEric Lapuyade2013-04-161-0/+10
| | | | | | | | | | This isolates the common code that is required to use an mei bus nfc device from an NFC HCI drivers. This prepares for future drivers for NFC chips connected behind an Intel Management Engine controller. The microread_mei HCI driver is also modified to use that common code. Signed-off-by: Eric Lapuyade <eric.lapuyade@intel.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: Initial support for Inside Secure microreadEric Lapuyade2013-02-031-0/+1
| | | | | | | | Inside Secure microread is an HCI based NFC chipset. This initial support includes reader and p2p (Target and initiator) modes. Signed-off-by: Eric Lapuyade <eric.lapuyade@intel.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: pn544: Separate the core code and the i2c one into different modulesSamuel Ortiz2013-01-101-13/+2
| | | | | | | As we may need to support other physical layers, we can avoid linking the core part into each and every pn544 module. Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: Remove the pn544 raw driverCong Wang2012-09-251-12/+0
| | | | | | | | This was scheduled for 3.6, we're late. Signed-off-by: Cong Wang <xiyou.wangcong@gmail.com> Acked-by: Marcel Holtmann <marcel@holtmann.org> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: Changed HCI and PN544 HCI driver to use the new HCI LLC CoreEric Lapuyade2012-09-251-1/+1
| | | | | | | | | | | The previous shdlc HCI driver and its header are removed from the tree. PN544 now registers directly with HCI and passes the name of the llc it requires (shdlc). HCI instantiation now allocates the required llc instance. The llc is started when the HCI device is brought up. Signed-off-by: Eric Lapuyade <eric.lapuyade@intel.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
* NFC: HCI based pn544 driverEric Lapuyade2012-05-151-0/+13
| | | | | | | | | This is an NFC driver for NXP pn544. Unlike pn544.c, this one is based on the NFC HCI and SHDLC kernel layers. Signed-off-by: Eric Lapuyade <eric.lapuyade@intel.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com> Signed-off-by: John W. Linville <linville@tuxdriver.com>
* nfc: NFC_WILINK depends on NFC_NCIRandy Dunlap2011-09-211-1/+1
| | | | | | | | | | | | | | | nwcwilink.c uses nci_*() interfaces, so it should depend on NFC_NCI. Fixes these build errors: ERROR: "nci_register_device" [drivers/nfc/nfcwilink.ko] undefined! ERROR: "nci_allocate_device" [drivers/nfc/nfcwilink.ko] undefined! ERROR: "nci_recv_frame" [drivers/nfc/nfcwilink.ko] undefined! ERROR: "nci_free_device" [drivers/nfc/nfcwilink.ko] undefined! ERROR: "nci_unregister_device" [drivers/nfc/nfcwilink.ko] undefined! Signed-off-by: Randy Dunlap <rdunlap@xenotime.net> Signed-off-by: John W. Linville <linville@tuxdriver.com>
* NFC: driver for TI shared transportIlan Elias2011-09-201-0/+11
| | | | | Signed-off-by: Ilan Elias <ilane@ti.com> Signed-off-by: John W. Linville <linville@tuxdriver.com>
* NFC: pn533: add NXP pn533 nfc device driverAloisio Almeida Jr2011-07-051-0/+10
| | | | | | | Signed-off-by: Lauro Ramos Venancio <lauro.venancio@openbossa.org> Signed-off-by: Aloisio Almeida Jr <aloisio.almeida@openbossa.org> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com> Signed-off-by: John W. Linville <linville@tuxdriver.com>
* NFC: add nfc subsystem coreLauro Ramos Venancio2011-07-051-13/+3
| | | | | | | | | | | The NFC subsystem core is responsible for providing the device driver interface. It is also responsible for providing an interface to the control operations and data exchange. Signed-off-by: Lauro Ramos Venancio <lauro.venancio@openbossa.org> Signed-off-by: Aloisio Almeida Jr <aloisio.almeida@openbossa.org> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com> Signed-off-by: John W. Linville <linville@tuxdriver.com>
* drivers/nfc/Kconfig: use full form of the NFC acronymMatti J. Aaltonen2011-02-251-1/+1
| | | | | | | | | Spell out the NFC acronym when it's shown for the first time. Signed-off-by: Matti J. Aaltonen <matti.j.aaltonen@nokia.com> Acked-by: Wolfram Sang <w.sang@pengutronix.de> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
* NFC: Driver for NXP Semiconductors PN544 NFC chip.Matti J. Aaltonen2011-01-131-0/+30
Creates a new "Near Field Communication" subsystem in drivers/nfc. http://en.wikipedia.org/wiki/Near_Field_Communication is useful ;) This is a driver for the pn544 NFC device. The driver transfers ETSI messages between the device and the user space. Signed-off-by: Matti J. Aaltonen <matti.j.aaltonen@nokia.com> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
OpenPOWER on IntegriCloud