diff options
Diffstat (limited to 'include/uapi/linux/nl80211.h')
| -rw-r--r-- | include/uapi/linux/nl80211.h | 28 |
1 files changed, 28 insertions, 0 deletions
diff --git a/include/uapi/linux/nl80211.h b/include/uapi/linux/nl80211.h index 29c4399..e5b8caf 100644 --- a/include/uapi/linux/nl80211.h +++ b/include/uapi/linux/nl80211.h @@ -722,6 +722,22 @@ * QoS mapping is relevant for IP packets, it is only valid during an * association. This is cleared on disassociation and AP restart. * + * @NL80211_CMD_ADD_TX_TS: Ask the kernel to add a traffic stream for the given + * %NL80211_ATTR_TSID and %NL80211_ATTR_MAC with %NL80211_ATTR_USER_PRIO + * and %NL80211_ATTR_ADMITTED_TIME parameters. + * Note that the action frame handshake with the AP shall be handled by + * userspace via the normal management RX/TX framework, this only sets + * up the TX TS in the driver/device. + * If the admitted time attribute is not added then the request just checks + * if a subsequent setup could be successful, the intent is to use this to + * avoid setting up a session with the AP when local restrictions would + * make that impossible. However, the subsequent "real" setup may still + * fail even if the check was successful. + * @NL80211_CMD_DEL_TX_TS: Remove an existing TS with the %NL80211_ATTR_TSID + * and %NL80211_ATTR_MAC parameters. It isn't necessary to call this + * before removing a station entry entirely, or before disassociating + * or similar, cleanup will happen in the driver/device in this case. + * * @NL80211_CMD_MAX: highest used command number * @__NL80211_CMD_AFTER_LAST: internal use */ @@ -893,6 +909,9 @@ enum nl80211_commands { NL80211_CMD_SET_QOS_MAP, + NL80211_CMD_ADD_TX_TS, + NL80211_CMD_DEL_TX_TS, + /* add new commands above here */ /* used to define NL80211_CMD_MAX below */ @@ -1611,6 +1630,11 @@ enum nl80211_commands { * drivers to indicate dynack capability. Dynack is automatically disabled * setting valid value for coverage class. * + * @NL80211_ATTR_TSID: a TSID value (u8 attribute) + * @NL80211_ATTR_USER_PRIO: user priority value (u8 attribute) + * @NL80211_ATTR_ADMITTED_TIME: admitted time in units of 32 microseconds + * (per second) (u16 attribute) + * * @NL80211_ATTR_MAX: highest attribute number currently defined * @__NL80211_ATTR_AFTER_LAST: internal use */ @@ -1957,6 +1981,10 @@ enum nl80211_attrs { NL80211_ATTR_WIPHY_DYN_ACK, + NL80211_ATTR_TSID, + NL80211_ATTR_USER_PRIO, + NL80211_ATTR_ADMITTED_TIME, + /* add attributes here, update the policy in nl80211.c */ __NL80211_ATTR_AFTER_LAST, |
