diff options
Diffstat (limited to 'include/net/mac80211.h')
| -rw-r--r-- | include/net/mac80211.h | 109 |
1 files changed, 48 insertions, 61 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 95e39b6..bb86aa6 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -233,8 +233,10 @@ enum ieee80211_rssi_event { * valid in station mode only while @assoc is true and if also * requested by %IEEE80211_HW_NEED_DTIM_PERIOD (cf. also hw conf * @ps_dtim_period) - * @last_tsf: last beacon's/probe response's TSF timestamp (could be old + * @sync_tsf: last beacon's/probe response's TSF timestamp (could be old * as it may have been received during scanning long ago) + * @sync_device_ts: the device timestamp corresponding to the sync_tsf, + * the driver/device can use this to calculate synchronisation * @beacon_int: beacon interval * @assoc_capability: capabilities taken from assoc resp * @basic_rates: bitmap of basic rates, each bit stands for an @@ -281,7 +283,8 @@ struct ieee80211_bss_conf { u8 dtim_period; u16 beacon_int; u16 assoc_capability; - u64 last_tsf; + u64 sync_tsf; + u32 sync_device_ts; u32 basic_rates; int mcast_rate[IEEE80211_NUM_BANDS]; u16 ht_operation_mode; @@ -475,7 +478,7 @@ enum mac80211_rate_control_flags { #define IEEE80211_TX_INFO_RATE_DRIVER_DATA_SIZE 24 /* maximum number of rate stages */ -#define IEEE80211_TX_MAX_RATES 5 +#define IEEE80211_TX_MAX_RATES 4 /** * struct ieee80211_tx_rate - rate selection/status @@ -563,11 +566,11 @@ struct ieee80211_tx_info { } control; struct { struct ieee80211_tx_rate rates[IEEE80211_TX_MAX_RATES]; - u8 ampdu_ack_len; int ack_signal; + u8 ampdu_ack_len; u8 ampdu_len; u8 antenna; - /* 14 bytes free */ + /* 21 bytes free */ } status; struct { struct ieee80211_tx_rate driver_rates[ @@ -634,7 +637,7 @@ ieee80211_tx_info_clear_status(struct ieee80211_tx_info *info) info->status.rates[i].count = 0; BUILD_BUG_ON( - offsetof(struct ieee80211_tx_info, status.ampdu_ack_len) != 23); + offsetof(struct ieee80211_tx_info, status.ack_signal) != 20); memset(&info->status.ampdu_ack_len, 0, sizeof(struct ieee80211_tx_info) - offsetof(struct ieee80211_tx_info, status.ampdu_ack_len)); @@ -696,6 +699,8 @@ enum mac80211_rx_flags { * * @mactime: value in microseconds of the 64-bit Time Synchronization Function * (TSF) timer when the first data symbol (MPDU) arrived at the hardware. + * @device_timestamp: arbitrary timestamp for the device, mac80211 doesn't use + * it but can store it and pass it back to the driver for synchronisation * @band: the active band when this frame was received * @freq: frequency the radio was tuned to when receiving this frame, in MHz * @signal: signal strength when receiving this frame, either in dBm, in dB or @@ -709,13 +714,14 @@ enum mac80211_rx_flags { */ struct ieee80211_rx_status { u64 mactime; - enum ieee80211_band band; - int freq; - int signal; - int antenna; - int rate_idx; - int flag; - unsigned int rx_flags; + u32 device_timestamp; + u16 flag; + u16 freq; + u8 rate_idx; + u8 rx_flags; + u8 band; + u8 antenna; + s8 signal; }; /** @@ -1297,6 +1303,10 @@ enum ieee80211_hw_flags { * reports, by default it is set to _MCS, _GI and _BW but doesn't * include _FMT. Use %IEEE80211_RADIOTAP_MCS_HAVE_* values, only * adding _BW is supported today. + * + * @netdev_features: netdev features to be set in each netdev created + * from this HW. Note only HW checksum features are currently + * compatible with mac80211. Other feature bits will be rejected. */ struct ieee80211_hw { struct ieee80211_conf conf; @@ -1319,6 +1329,7 @@ struct ieee80211_hw { u8 max_tx_aggregation_subframes; u8 offchannel_tx_hw_queue; u8 radiotap_mcs_details; + netdev_features_t netdev_features; }; /** @@ -1891,19 +1902,6 @@ enum ieee80211_rate_control_changed { * The low-level driver should send the frame out based on * configuration in the TX control data. This handler should, * preferably, never fail and stop queues appropriately. - * This must be implemented if @tx_frags is not. - * Must be atomic. - * - * @tx_frags: Called to transmit multiple fragments of a single MSDU. - * This handler must consume all fragments, sending out some of - * them only is useless and it can't ask for some of them to be - * queued again. If the frame is not fragmented the queue has a - * single SKB only. To avoid issues with the networking stack - * when TX status is reported the frames should be removed from - * the skb queue. - * If this is used, the tx_info @vif and @sta pointers will be - * invalid -- you must not use them in that case. - * This must be implemented if @tx isn't. * Must be atomic. * * @start: Called before the first netdevice attached to the hardware @@ -2183,7 +2181,10 @@ enum ieee80211_rate_control_changed { * offload. Frames to transmit on the off-channel channel are transmitted * normally except for the %IEEE80211_TX_CTL_TX_OFFCHAN flag. When the * duration (which will always be non-zero) expires, the driver must call - * ieee80211_remain_on_channel_expired(). This callback may sleep. + * ieee80211_remain_on_channel_expired(). + * Note that this callback may be called while the device is in IDLE and + * must be accepted in this case. + * This callback may sleep. * @cancel_remain_on_channel: Requests that an ongoing off-channel period is * aborted before it expires. This callback may sleep. * @@ -2246,11 +2247,24 @@ enum ieee80211_rate_control_changed { * @get_et_strings: Ethtool API to get a set of strings to describe stats * and perhaps other supported types of ethtool data-sets. * + * @get_rssi: Get current signal strength in dBm, the function is optional + * and can sleep. + * + * @mgd_prepare_tx: Prepare for transmitting a management frame for association + * before associated. In multi-channel scenarios, a virtual interface is + * bound to a channel before it is associated, but as it isn't associated + * yet it need not necessarily be given airtime, in particular since any + * transmission to a P2P GO needs to be synchronized against the GO's + * powersave state. mac80211 will call this function before transmitting a + * management frame prior to having successfully associated to allow the + * driver to give it channel time for the transmission, to get a response + * and to be able to synchronize with the GO. + * The callback will be called before each transmission and upon return + * mac80211 will transmit the frame right away. + * The callback is optional and can (should!) sleep. */ struct ieee80211_ops { void (*tx)(struct ieee80211_hw *hw, struct sk_buff *skb); - void (*tx_frags)(struct ieee80211_hw *hw, struct ieee80211_vif *vif, - struct ieee80211_sta *sta, struct sk_buff_head *skbs); int (*start)(struct ieee80211_hw *hw); void (*stop)(struct ieee80211_hw *hw); #ifdef CONFIG_PM @@ -2385,6 +2399,11 @@ struct ieee80211_ops { void (*get_et_strings)(struct ieee80211_hw *hw, struct ieee80211_vif *vif, u32 sset, u8 *data); + int (*get_rssi)(struct ieee80211_hw *hw, struct ieee80211_vif *vif, + struct ieee80211_sta *sta, s8 *rssi_dbm); + + void (*mgd_prepare_tx)(struct ieee80211_hw *hw, + struct ieee80211_vif *vif); }; /** @@ -3557,16 +3576,6 @@ void ieee80211_cqm_rssi_notify(struct ieee80211_vif *vif, gfp_t gfp); /** - * ieee80211_get_operstate - get the operstate of the vif - * - * @vif: &struct ieee80211_vif pointer from the add_interface callback. - * - * The driver might need to know the operstate of the net_device - * (specifically, whether the link is IF_OPER_UP after resume) - */ -unsigned char ieee80211_get_operstate(struct ieee80211_vif *vif); - -/** * ieee80211_chswitch_done - Complete channel switch process * @vif: &struct ieee80211_vif pointer from the add_interface callback. * @success: make the channel switch successful or not @@ -3589,22 +3598,6 @@ void ieee80211_request_smps(struct ieee80211_vif *vif, enum ieee80211_smps_mode smps_mode); /** - * ieee80211_key_removed - disable hw acceleration for key - * @key_conf: The key hw acceleration should be disabled for - * - * This allows drivers to indicate that the given key has been - * removed from hardware acceleration, due to a new key that - * was added. Don't use this if the key can continue to be used - * for TX, if the key restriction is on RX only it is permitted - * to keep the key for TX only and not call this function. - * - * Due to locking constraints, it may only be called during - * @set_key. This function must be allowed to sleep, and the - * key it tries to disable may still be used until it returns. - */ -void ieee80211_key_removed(struct ieee80211_key_conf *key_conf); - -/** * ieee80211_ready_on_channel - notification of remain-on-channel start * @hw: pointer as obtained from ieee80211_alloc_hw() */ @@ -3829,12 +3822,6 @@ void ieee80211_enable_rssi_reports(struct ieee80211_vif *vif, void ieee80211_disable_rssi_reports(struct ieee80211_vif *vif); -int ieee80211_add_srates_ie(struct ieee80211_vif *vif, - struct sk_buff *skb, bool need_basic); - -int ieee80211_add_ext_srates_ie(struct ieee80211_vif *vif, - struct sk_buff *skb, bool need_basic); - /** * ieee80211_ave_rssi - report the average rssi for the specified interface * |
