diff options
Diffstat (limited to 'include/net/cfg80211.h')
| -rw-r--r-- | include/net/cfg80211.h | 94 |
1 files changed, 74 insertions, 20 deletions
diff --git a/include/net/cfg80211.h b/include/net/cfg80211.h index 7319f25..061c019 100644 --- a/include/net/cfg80211.h +++ b/include/net/cfg80211.h @@ -627,10 +627,10 @@ struct sta_bss_parameters { * @llid: mesh local link id * @plid: mesh peer link id * @plink_state: mesh peer link state - * @signal: the signal strength, type depends on the wiphy's signal_type - NOTE: For CFG80211_SIGNAL_TYPE_MBM, value is expressed in _dBm_. - * @signal_avg: avg signal strength, type depends on the wiphy's signal_type - NOTE: For CFG80211_SIGNAL_TYPE_MBM, value is expressed in _dBm_. + * @signal: The signal strength, type depends on the wiphy's signal_type. + * For CFG80211_SIGNAL_TYPE_MBM, value is expressed in _dBm_. + * @signal_avg: Average signal strength, type depends on the wiphy's signal_type. + * For CFG80211_SIGNAL_TYPE_MBM, value is expressed in _dBm_. * @txrate: current unicast bitrate from this station * @rxrate: current unicast bitrate to this station * @rx_packets: packets received from this station @@ -790,43 +790,95 @@ struct bss_parameters { int ht_opmode; }; -/* +/** * struct mesh_config - 802.11s mesh configuration * * These parameters can be changed while the mesh is active. + * + * @dot11MeshRetryTimeout: the initial retry timeout in millisecond units used + * by the Mesh Peering Open message + * @dot11MeshConfirmTimeout: the initial retry timeout in millisecond units + * used by the Mesh Peering Open message + * @dot11MeshHoldingTimeout: the confirm timeout in millisecond units used by + * the mesh peering management to close a mesh peering + * @dot11MeshMaxPeerLinks: the maximum number of peer links allowed on this + * mesh interface + * @dot11MeshMaxRetries: the maximum number of peer link open retries that can + * be sent to establish a new peer link instance in a mesh + * @dot11MeshTTL: the value of TTL field set at a source mesh STA + * @element_ttl: the value of TTL field set at a mesh STA for path selection + * elements + * @auto_open_plinks: whether we should automatically open peer links when we + * detect compatible mesh peers + * @dot11MeshNbrOffsetMaxNeighbor: the maximum number of neighbors to + * synchronize to for 11s default synchronization method + * @dot11MeshHWMPmaxPREQretries: the number of action frames containing a PREQ + * that an originator mesh STA can send to a particular path target + * @path_refresh_time: how frequently to refresh mesh paths in milliseconds + * @min_discovery_timeout: the minimum length of time to wait until giving up on + * a path discovery in milliseconds + * @dot11MeshHWMPactivePathTimeout: the time (in TUs) for which mesh STAs + * receiving a PREQ shall consider the forwarding information from the + * root to be valid. (TU = time unit) + * @dot11MeshHWMPpreqMinInterval: the minimum interval of time (in TUs) during + * which a mesh STA can send only one action frame containing a PREQ + * element + * @dot11MeshHWMPperrMinInterval: the minimum interval of time (in TUs) during + * which a mesh STA can send only one Action frame containing a PERR + * element + * @dot11MeshHWMPnetDiameterTraversalTime: the interval of time (in TUs) that + * it takes for an HWMP information element to propagate across the mesh + * @dot11MeshHWMPRootMode: the configuration of a mesh STA as root mesh STA + * @dot11MeshHWMPRannInterval: the interval of time (in TUs) between root + * announcements are transmitted + * @dot11MeshGateAnnouncementProtocol: whether to advertise that this mesh + * station has access to a broader network beyond the MBSS. (This is + * missnamed in draft 12.0: dot11MeshGateAnnouncementProtocol set to true + * only means that the station will announce others it's a mesh gate, but + * not necessarily using the gate announcement protocol. Still keeping the + * same nomenclature to be in sync with the spec) + * @dot11MeshForwarding: whether the Mesh STA is forwarding or non-forwarding + * entity (default is TRUE - forwarding entity) + * @rssi_threshold: the threshold for average signal strength of candidate + * station to establish a peer link + * @ht_opmode: mesh HT protection mode + * + * @dot11MeshHWMPactivePathToRootTimeout: The time (in TUs) for which mesh STAs + * receiving a proactive PREQ shall consider the forwarding information to + * the root mesh STA to be valid. + * + * @dot11MeshHWMProotInterval: The interval of time (in TUs) between proactive + * PREQs are transmitted. + * @dot11MeshHWMPconfirmationInterval: The minimum interval of time (in TUs) + * during which a mesh STA can send only one Action frame containing + * a PREQ element for root path confirmation. */ struct mesh_config { - /* Timeouts in ms */ - /* Mesh plink management parameters */ u16 dot11MeshRetryTimeout; u16 dot11MeshConfirmTimeout; u16 dot11MeshHoldingTimeout; u16 dot11MeshMaxPeerLinks; - u8 dot11MeshMaxRetries; - u8 dot11MeshTTL; - /* ttl used in path selection information elements */ - u8 element_ttl; + u8 dot11MeshMaxRetries; + u8 dot11MeshTTL; + u8 element_ttl; bool auto_open_plinks; - /* neighbor offset synchronization */ u32 dot11MeshNbrOffsetMaxNeighbor; - /* HWMP parameters */ - u8 dot11MeshHWMPmaxPREQretries; + u8 dot11MeshHWMPmaxPREQretries; u32 path_refresh_time; u16 min_discovery_timeout; u32 dot11MeshHWMPactivePathTimeout; u16 dot11MeshHWMPpreqMinInterval; u16 dot11MeshHWMPperrMinInterval; u16 dot11MeshHWMPnetDiameterTraversalTime; - u8 dot11MeshHWMPRootMode; + u8 dot11MeshHWMPRootMode; u16 dot11MeshHWMPRannInterval; - /* This is missnamed in draft 12.0: dot11MeshGateAnnouncementProtocol - * set to true only means that the station will announce others it's a - * mesh gate, but not necessarily using the gate announcement protocol. - * Still keeping the same nomenclature to be in sync with the spec. */ - bool dot11MeshGateAnnouncementProtocol; + bool dot11MeshGateAnnouncementProtocol; bool dot11MeshForwarding; s32 rssi_threshold; u16 ht_opmode; + u32 dot11MeshHWMPactivePathToRootTimeout; + u16 dot11MeshHWMProotInterval; + u16 dot11MeshHWMPconfirmationInterval; }; /** @@ -975,6 +1027,7 @@ struct cfg80211_match_set { * @wiphy: the wiphy this was for * @dev: the interface * @channels: channels to scan + * @rssi_thold: don't report scan results below this threshold (in s32 dBm) */ struct cfg80211_sched_scan_request { struct cfg80211_ssid *ssids; @@ -985,6 +1038,7 @@ struct cfg80211_sched_scan_request { size_t ie_len; struct cfg80211_match_set *match_sets; int n_match_sets; + s32 rssi_thold; /* internal */ struct wiphy *wiphy; |
