diff options
Diffstat (limited to 'include/linux/platform_data/atmel.h')
| -rw-r--r-- | include/linux/platform_data/atmel.h | 67 |
1 files changed, 67 insertions, 0 deletions
diff --git a/include/linux/platform_data/atmel.h b/include/linux/platform_data/atmel.h index b0f2c56..dbd6d53 100644 --- a/include/linux/platform_data/atmel.h +++ b/include/linux/platform_data/atmel.h @@ -8,6 +8,49 @@ #define __ATMEL_H__ #include <linux/mtd/nand.h> +#include <linux/mtd/partitions.h> +#include <linux/device.h> +#include <linux/i2c.h> +#include <linux/leds.h> +#include <linux/spi/spi.h> +#include <linux/usb/atmel_usba_udc.h> +#include <linux/atmel-mci.h> +#include <sound/atmel-ac97c.h> +#include <linux/serial.h> +#include <linux/platform_data/macb.h> + + /* USB Device */ +struct at91_udc_data { + int vbus_pin; /* high == host powering us */ + u8 vbus_active_low; /* vbus polarity */ + u8 vbus_polled; /* Use polling, not interrupt */ + int pullup_pin; /* active == D+ pulled up */ + u8 pullup_active_low; /* true == pullup_pin is active low */ +}; + + /* Compact Flash */ +struct at91_cf_data { + int irq_pin; /* I/O IRQ */ + int det_pin; /* Card detect */ + int vcc_pin; /* power switching */ + int rst_pin; /* card reset */ + u8 chipselect; /* EBI Chip Select number */ + u8 flags; +#define AT91_CF_TRUE_IDE 0x01 +#define AT91_IDE_SWAP_A0_A2 0x02 +}; + + /* USB Host */ +#define AT91_MAX_USBH_PORTS 3 +struct at91_usbh_data { + int vbus_pin[AT91_MAX_USBH_PORTS]; /* port power-control pin */ + int overcurrent_pin[AT91_MAX_USBH_PORTS]; + u8 ports; /* number of ports on root hub */ + u8 overcurrent_supported; + u8 vbus_pin_active_low[AT91_MAX_USBH_PORTS]; + u8 overcurrent_status[AT91_MAX_USBH_PORTS]; + u8 overcurrent_changed[AT91_MAX_USBH_PORTS]; +}; /* NAND / SmartMedia */ struct atmel_nand_data { @@ -24,4 +67,28 @@ struct atmel_nand_data { unsigned int num_parts; }; + /* Serial */ +struct atmel_uart_data { + int num; /* port num */ + short use_dma_tx; /* use transmit DMA? */ + short use_dma_rx; /* use receive DMA? */ + void __iomem *regs; /* virt. base address, if any */ + struct serial_rs485 rs485; /* rs485 settings */ +}; + + /* Touchscreen Controller */ +struct at91_tsadcc_data { + unsigned int adc_clock; + u8 pendet_debounce; + u8 ts_sample_hold_time; +}; + +/* CAN */ +struct at91_can_data { + void (*transceiver_switch)(int on); +}; + +/* FIXME: this needs a better location, but gets stuff building again */ +extern int at91_suspend_entering_slow_clock(void); + #endif /* __ATMEL_H__ */ |
