1 files changed, 16 insertions, 140 deletions

diff --git a/drivers/usb/musb/musb_gadget.c b/drivers/usb/musb/musb_gadget.c
index 83edded..ba70923 100644
--- a/drivers/usb/musb/musb_gadget.c
+++ b/drivers/usb/musb/musb_gadget.c
@@ -46,48 +46,6 @@
 #include "musb_core.h"
 
 
-/* MUSB PERIPHERAL status 3-mar-2006:
- *
- * - EP0 seems solid.  It passes both USBCV and usbtest control cases.
- *   Minor glitches:
- *
- *     + remote wakeup to Linux hosts work, but saw USBCV failures;
- *       in one test run (operator error?)
- *     + endpoint halt tests -- in both usbtest and usbcv -- seem
- *       to break when dma is enabled ... is something wrongly
- *       clearing SENDSTALL?
- *
- * - Mass storage behaved ok when last tested.  Network traffic patterns
- *   (with lots of short transfers etc) need retesting; they turn up the
- *   worst cases of the DMA, since short packets are typical but are not
- *   required.
- *
- * - TX/IN
- *     + both pio and dma behave in with network and g_zero tests
- *     + no cppi throughput issues other than no-hw-queueing
- *     + failed with FLAT_REG (DaVinci)
- *     + seems to behave with double buffering, PIO -and- CPPI
- *     + with gadgetfs + AIO, requests got lost?
- *
- * - RX/OUT
- *     + both pio and dma behave in with network and g_zero tests
- *     + dma is slow in typical case (short_not_ok is clear)
- *     + double buffering ok with PIO
- *     + double buffering *FAILS* with CPPI, wrong data bytes sometimes
- *     + request lossage observed with gadgetfs
- *
- * - ISO not tested ... might work, but only weakly isochronous
- *
- * - Gadget driver disabling of softconnect during bind() is ignored; so
- *   drivers can't hold off host requests until userspace is ready.
- *   (Workaround:  they can turn it off later.)
- *
- * - PORTABILITY (assumes PIO works):
- *     + DaVinci, basically works with cppi dma
- *     + OMAP 2430, ditto with mentor dma
- *     + TUSB 6010, platform-specific dma in the works
- */
-
 /* ----------------------------------------------------------------------- */
 
 #define is_buffer_mapped(req) (is_dma_capable() && \
@@ -280,41 +238,6 @@ static inline int max_ep_writesize(struct musb *musb, struct musb_ep *ep)
 		return ep->packet_sz;
 }
 
-
-#ifdef CONFIG_USB_INVENTRA_DMA
-
-/* Peripheral tx (IN) using Mentor DMA works as follows:
-	Only mode 0 is used for transfers <= wPktSize,
-	mode 1 is used for larger transfers,
-
-	One of the following happens:
-	- Host sends IN token which causes an endpoint interrupt
-		-> TxAvail
-			-> if DMA is currently busy, exit.
-			-> if queue is non-empty, txstate().
-
-	- Request is queued by the gadget driver.
-		-> if queue was previously empty, txstate()
-
-	txstate()
-		-> start
-		  /\	-> setup DMA
-		  |     (data is transferred to the FIFO, then sent out when
-		  |	IN token(s) are recd from Host.
-		  |		-> DMA interrupt on completion
-		  |		   calls TxAvail.
-		  |		      -> stop DMA, ~DMAENAB,
-		  |		      -> set TxPktRdy for last short pkt or zlp
-		  |		      -> Complete Request
-		  |		      -> Continue next request (call txstate)
-		  |___________________________________|
-
- * Non-Mentor DMA engines can of course work differently, such as by
- * upleveling from irq-per-packet to irq-per-buffer.
- */
-
-#endif
-
 /*
  * An endpoint is transmitting data. This can be called either from
  * the IRQ routine or from ep.queue() to kickstart a request on an
@@ -621,37 +544,6 @@ void musb_g_tx(struct musb *musb, u8 epnum)
 
 /* ------------------------------------------------------------ */
 
-#ifdef CONFIG_USB_INVENTRA_DMA
-
-/* Peripheral rx (OUT) using Mentor DMA works as follows:
-	- Only mode 0 is used.
-
-	- Request is queued by the gadget class driver.
-		-> if queue was previously empty, rxstate()
-
-	- Host sends OUT token which causes an endpoint interrupt
-	  /\      -> RxReady
-	  |	      -> if request queued, call rxstate
-	  |		/\	-> setup DMA
-	  |		|	     -> DMA interrupt on completion
-	  |		|		-> RxReady
-	  |		|		      -> stop DMA
-	  |		|		      -> ack the read
-	  |		|		      -> if data recd = max expected
-	  |		|				by the request, or host
-	  |		|				sent a short packet,
-	  |		|				complete the request,
-	  |		|				and start the next one.
-	  |		|_____________________________________|
-	  |					 else just wait for the host
-	  |					    to send the next OUT token.
-	  |__________________________________________________|
-
- * Non-Mentor DMA engines can of course work differently.
- */
-
-#endif
-
 /*
  * Context: controller locked, IRQs blocked, endpoint selected
  */
@@ -740,7 +632,7 @@ static void rxstate(struct musb *musb, struct musb_request *req)
 				struct dma_controller	*c;
 				struct dma_channel	*channel;
 				int			use_dma = 0;
-				int transfer_size;
+				unsigned int transfer_size;
 
 				c = musb->dma_controller;
 				channel = musb_ep->dma;
@@ -782,10 +674,11 @@ static void rxstate(struct musb *musb, struct musb_request *req)
 						csr | MUSB_RXCSR_DMAMODE);
 					musb_writew(epio, MUSB_RXCSR, csr);
 
-					transfer_size = min(request->length - request->actual,
+					transfer_size = min_t(unsigned int,
+							request->length -
+							request->actual,
 							channel->max_len);
 					musb_ep->dma->desired_mode = 1;
-
 				} else {
 					if (!musb_ep->hb_mult &&
 						musb_ep->hw_ep->rx_double_buffered)
@@ -815,7 +708,7 @@ static void rxstate(struct musb *musb, struct musb_request *req)
 
 				struct dma_controller *c;
 				struct dma_channel *channel;
-				int transfer_size = 0;
+				unsigned int transfer_size = 0;
 
 				c = musb->dma_controller;
 				channel = musb_ep->dma;
@@ -824,11 +717,13 @@ static void rxstate(struct musb *musb, struct musb_request *req)
 				if (fifo_count < musb_ep->packet_sz)
 					transfer_size = fifo_count;
 				else if (request->short_not_ok)
-					transfer_size =	min(request->length -
+					transfer_size =	min_t(unsigned int,
+							request->length -
 							request->actual,
 							channel->max_len);
 				else
-					transfer_size = min(request->length -
+					transfer_size = min_t(unsigned int,
+							request->length -
 							request->actual,
 							(unsigned)fifo_count);
 
@@ -1681,7 +1576,7 @@ static int musb_gadget_wakeup(struct usb_gadget *gadget)
 		goto done;
 	default:
 		dev_dbg(musb->controller, "Unhandled wake: %s\n",
-			otg_state_string(musb->xceiv->state));
+			usb_otg_state_string(musb->xceiv->state));
 		goto done;
 	}
 
@@ -1801,13 +1696,6 @@ static const struct usb_gadget_ops musb_gadget_operations = {
  * all peripheral ports are external...
  */
 
-static void musb_gadget_release(struct device *dev)
-{
-	/* kref_put(WHAT) */
-	dev_dbg(dev, "%s\n", __func__);
-}
-
-
 static void
 init_peripheral_ep(struct musb *musb, struct musb_ep *ep, u8 epnum, int is_in)
 {
@@ -1892,12 +1780,7 @@ int musb_gadget_setup(struct musb *musb)
 	musb->g.speed = USB_SPEED_UNKNOWN;
 
 	/* this "gadget" abstracts/virtualizes the controller */
-	dev_set_name(&musb->g.dev, "gadget");
-	musb->g.dev.parent = musb->controller;
-	musb->g.dev.dma_mask = musb->controller->dma_mask;
-	musb->g.dev.release = musb_gadget_release;
 	musb->g.name = musb_driver_name;
-
 	musb->g.is_otg = 1;
 
 	musb_g_init_endpoints(musb);
@@ -1905,11 +1788,6 @@ int musb_gadget_setup(struct musb *musb)
 	musb->is_active = 0;
 	musb_platform_try_idle(musb, 0);
 
-	status = device_register(&musb->g.dev);
-	if (status != 0) {
-		put_device(&musb->g.dev);
-		return status;
-	}
 	status = usb_add_gadget_udc(musb->controller, &musb->g);
 	if (status)
 		goto err;
@@ -1924,8 +1802,6 @@ err:
 void musb_gadget_cleanup(struct musb *musb)
 {
 	usb_del_gadget_udc(&musb->g);
-	if (musb->g.dev.parent)
-		device_unregister(&musb->g.dev);
 }
 
 /*
@@ -1977,9 +1853,8 @@ static int musb_gadget_start(struct usb_gadget *g,
 		goto err;
 	}
 
-	if ((musb->xceiv->last_event == USB_EVENT_ID)
-				&& otg->set_vbus)
-		otg_set_vbus(otg, 1);
+	if (musb->xceiv->last_event == USB_EVENT_ID)
+		musb_platform_set_vbus(musb, 1);
 
 	hcd->self.uses_pio_for_control = 1;
 
@@ -2063,6 +1938,7 @@ static int musb_gadget_stop(struct usb_gadget *g,
 	dev_dbg(musb->controller, "unregistering driver %s\n", driver->function);
 
 	musb->is_active = 0;
+	musb->gadget_driver = NULL;
 	musb_platform_try_idle(musb, 0);
 	spin_unlock_irqrestore(&musb->lock, flags);
 
@@ -2099,7 +1975,7 @@ void musb_g_resume(struct musb *musb)
 		break;
 	default:
 		WARNING("unhandled RESUME transition (%s)\n",
-				otg_state_string(musb->xceiv->state));
+				usb_otg_state_string(musb->xceiv->state));
 	}
 }
 
@@ -2129,7 +2005,7 @@ void musb_g_suspend(struct musb *musb)
 		 * A_PERIPHERAL may need care too
 		 */
 		WARNING("unhandled SUSPEND transition (%s)\n",
-				otg_state_string(musb->xceiv->state));
+				usb_otg_state_string(musb->xceiv->state));
 	}
 }
 
@@ -2163,7 +2039,7 @@ void musb_g_disconnect(struct musb *musb)
 	switch (musb->xceiv->state) {
 	default:
 		dev_dbg(musb->controller, "Unhandled disconnect %s, setting a_idle\n",
-			otg_state_string(musb->xceiv->state));
+			usb_otg_state_string(musb->xceiv->state));
 		musb->xceiv->state = OTG_STATE_A_IDLE;
 		MUSB_HST_MODE(musb);
 		break;