diff options
Diffstat (limited to 'drivers/usb/host/xhci.c')
| -rw-r--r-- | drivers/usb/host/xhci.c | 129 |
1 files changed, 127 insertions, 2 deletions
diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c index 7648b2d..6ece0ed 100644 --- a/drivers/usb/host/xhci.c +++ b/drivers/usb/host/xhci.c @@ -26,6 +26,7 @@ #include <linux/module.h> #include <linux/moduleparam.h> #include <linux/slab.h> +#include <linux/dmi.h> #include "xhci.h" @@ -166,7 +167,7 @@ int xhci_reset(struct xhci_hcd *xhci) xhci_writel(xhci, command, &xhci->op_regs->command); ret = handshake(xhci, &xhci->op_regs->command, - CMD_RESET, 0, 250 * 1000); + CMD_RESET, 0, 10 * 1000 * 1000); if (ret) return ret; @@ -175,7 +176,8 @@ int xhci_reset(struct xhci_hcd *xhci) * xHCI cannot write to any doorbells or operational registers other * than status until the "Controller Not Ready" flag is cleared. */ - ret = handshake(xhci, &xhci->op_regs->status, STS_CNR, 0, 250 * 1000); + ret = handshake(xhci, &xhci->op_regs->status, + STS_CNR, 0, 10 * 1000 * 1000); for (i = 0; i < 2; ++i) { xhci->bus_state[i].port_c_suspend = 0; @@ -397,6 +399,95 @@ static void xhci_msix_sync_irqs(struct xhci_hcd *xhci) #endif +static void compliance_mode_recovery(unsigned long arg) +{ + struct xhci_hcd *xhci; + struct usb_hcd *hcd; + u32 temp; + int i; + + xhci = (struct xhci_hcd *)arg; + + for (i = 0; i < xhci->num_usb3_ports; i++) { + temp = xhci_readl(xhci, xhci->usb3_ports[i]); + if ((temp & PORT_PLS_MASK) == USB_SS_PORT_LS_COMP_MOD) { + /* + * Compliance Mode Detected. Letting USB Core + * handle the Warm Reset + */ + xhci_dbg(xhci, "Compliance Mode Detected->Port %d!\n", + i + 1); + xhci_dbg(xhci, "Attempting Recovery routine!\n"); + hcd = xhci->shared_hcd; + + if (hcd->state == HC_STATE_SUSPENDED) + usb_hcd_resume_root_hub(hcd); + + usb_hcd_poll_rh_status(hcd); + } + } + + if (xhci->port_status_u0 != ((1 << xhci->num_usb3_ports)-1)) + mod_timer(&xhci->comp_mode_recovery_timer, + jiffies + msecs_to_jiffies(COMP_MODE_RCVRY_MSECS)); +} + +/* + * Quirk to work around issue generated by the SN65LVPE502CP USB3.0 re-driver + * that causes ports behind that hardware to enter compliance mode sometimes. + * The quirk creates a timer that polls every 2 seconds the link state of + * each host controller's port and recovers it by issuing a Warm reset + * if Compliance mode is detected, otherwise the port will become "dead" (no + * device connections or disconnections will be detected anymore). Becasue no + * status event is generated when entering compliance mode (per xhci spec), + * this quirk is needed on systems that have the failing hardware installed. + */ +static void compliance_mode_recovery_timer_init(struct xhci_hcd *xhci) +{ + xhci->port_status_u0 = 0; + init_timer(&xhci->comp_mode_recovery_timer); + + xhci->comp_mode_recovery_timer.data = (unsigned long) xhci; + xhci->comp_mode_recovery_timer.function = compliance_mode_recovery; + xhci->comp_mode_recovery_timer.expires = jiffies + + msecs_to_jiffies(COMP_MODE_RCVRY_MSECS); + + set_timer_slack(&xhci->comp_mode_recovery_timer, + msecs_to_jiffies(COMP_MODE_RCVRY_MSECS)); + add_timer(&xhci->comp_mode_recovery_timer); + xhci_dbg(xhci, "Compliance Mode Recovery Timer Initialized.\n"); +} + +/* + * This function identifies the systems that have installed the SN65LVPE502CP + * USB3.0 re-driver and that need the Compliance Mode Quirk. + * Systems: + * Vendor: Hewlett-Packard -> System Models: Z420, Z620 and Z820 + */ +static bool compliance_mode_recovery_timer_quirk_check(void) +{ + const char *dmi_product_name, *dmi_sys_vendor; + + dmi_product_name = dmi_get_system_info(DMI_PRODUCT_NAME); + dmi_sys_vendor = dmi_get_system_info(DMI_SYS_VENDOR); + + if (!(strstr(dmi_sys_vendor, "Hewlett-Packard"))) + return false; + + if (strstr(dmi_product_name, "Z420") || + strstr(dmi_product_name, "Z620") || + strstr(dmi_product_name, "Z820")) + return true; + + return false; +} + +static int xhci_all_ports_seen_u0(struct xhci_hcd *xhci) +{ + return (xhci->port_status_u0 == ((1 << xhci->num_usb3_ports)-1)); +} + + /* * Initialize memory for HCD and xHC (one-time init). * @@ -420,6 +511,12 @@ int xhci_init(struct usb_hcd *hcd) retval = xhci_mem_init(xhci, GFP_KERNEL); xhci_dbg(xhci, "Finished xhci_init\n"); + /* Initializing Compliance Mode Recovery Data If Needed */ + if (compliance_mode_recovery_timer_quirk_check()) { + xhci->quirks |= XHCI_COMP_MODE_QUIRK; + compliance_mode_recovery_timer_init(xhci); + } + return retval; } @@ -628,6 +725,11 @@ void xhci_stop(struct usb_hcd *hcd) del_timer_sync(&xhci->event_ring_timer); #endif + /* Deleting Compliance Mode Recovery Timer */ + if ((xhci->quirks & XHCI_COMP_MODE_QUIRK) && + (!(xhci_all_ports_seen_u0(xhci)))) + del_timer_sync(&xhci->comp_mode_recovery_timer); + if (xhci->quirks & XHCI_AMD_PLL_FIX) usb_amd_dev_put(); @@ -658,6 +760,9 @@ void xhci_shutdown(struct usb_hcd *hcd) { struct xhci_hcd *xhci = hcd_to_xhci(hcd); + if (xhci->quirks & XHCI_SPURIOUS_REBOOT) + usb_disable_xhci_ports(to_pci_dev(hcd->self.controller)); + spin_lock_irq(&xhci->lock); xhci_halt(xhci); spin_unlock_irq(&xhci->lock); @@ -802,6 +907,16 @@ int xhci_suspend(struct xhci_hcd *xhci) } spin_unlock_irq(&xhci->lock); + /* + * Deleting Compliance Mode Recovery Timer because the xHCI Host + * is about to be suspended. + */ + if ((xhci->quirks & XHCI_COMP_MODE_QUIRK) && + (!(xhci_all_ports_seen_u0(xhci)))) { + del_timer_sync(&xhci->comp_mode_recovery_timer); + xhci_dbg(xhci, "Compliance Mode Recovery Timer Deleted!\n"); + } + /* step 5: remove core well power */ /* synchronize irq when using MSI-X */ xhci_msix_sync_irqs(xhci); @@ -934,6 +1049,16 @@ int xhci_resume(struct xhci_hcd *xhci, bool hibernated) usb_hcd_resume_root_hub(hcd); usb_hcd_resume_root_hub(xhci->shared_hcd); } + + /* + * If system is subject to the Quirk, Compliance Mode Timer needs to + * be re-initialized Always after a system resume. Ports are subject + * to suffer the Compliance Mode issue again. It doesn't matter if + * ports have entered previously to U0 before system's suspension. + */ + if (xhci->quirks & XHCI_COMP_MODE_QUIRK) + compliance_mode_recovery_timer_init(xhci); + return retval; } #endif /* CONFIG_PM */ |
