diff options
Diffstat (limited to 'drivers/usb/host/ehci-fsl.c')
| -rw-r--r-- | drivers/usb/host/ehci-fsl.c | 366 |
1 files changed, 366 insertions, 0 deletions
diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c new file mode 100644 index 0000000..f985f121 --- /dev/null +++ b/drivers/usb/host/ehci-fsl.c @@ -0,0 +1,366 @@ +/* + * (C) Copyright David Brownell 2000-2002 + * Copyright (c) 2005 MontaVista Software + * + * This program is free software; you can redistribute it and/or modify it + * under the terms of the GNU General Public License as published by the + * Free Software Foundation; either version 2 of the License, or (at your + * option) any later version. + * + * This program is distributed in the hope that it will be useful, but + * WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY + * or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License + * for more details. + * + * You should have received a copy of the GNU General Public License + * along with this program; if not, write to the Free Software Foundation, + * Inc., 675 Mass Ave, Cambridge, MA 02139, USA. + * + * Ported to 834x by Randy Vinson <rvinson@mvista.com> using code provided + * by Hunter Wu. + */ + +#include <linux/platform_device.h> +#include <linux/fsl_devices.h> + +#include "ehci-fsl.h" + +/* FIXME: Power Managment is un-ported so temporarily disable it */ +#undef CONFIG_PM + +/* PCI-based HCs are common, but plenty of non-PCI HCs are used too */ + +/* configure so an HC device and id are always provided */ +/* always called with process context; sleeping is OK */ + +/** + * usb_hcd_fsl_probe - initialize FSL-based HCDs + * @drvier: Driver to be used for this HCD + * @pdev: USB Host Controller being probed + * Context: !in_interrupt() + * + * Allocates basic resources for this USB host controller. + * + */ +int usb_hcd_fsl_probe(const struct hc_driver *driver, + struct platform_device *pdev) +{ + struct fsl_usb2_platform_data *pdata; + struct usb_hcd *hcd; + struct resource *res; + int irq; + int retval; + unsigned int temp; + + pr_debug("initializing FSL-SOC USB Controller\n"); + + /* Need platform data for setup */ + pdata = (struct fsl_usb2_platform_data *)pdev->dev.platform_data; + if (!pdata) { + dev_err(&pdev->dev, + "No platform data for %s.\n", pdev->dev.bus_id); + return -ENODEV; + } + + /* + * This is a host mode driver, verify that we're supposed to be + * in host mode. + */ + if (!((pdata->operating_mode == FSL_USB2_DR_HOST) || + (pdata->operating_mode == FSL_USB2_MPH_HOST))) { + dev_err(&pdev->dev, + "Non Host Mode configured for %s. Wrong driver linked.\n", + pdev->dev.bus_id); + return -ENODEV; + } + + res = platform_get_resource(pdev, IORESOURCE_IRQ, 0); + if (!res) { + dev_err(&pdev->dev, + "Found HC with no IRQ. Check %s setup!\n", + pdev->dev.bus_id); + return -ENODEV; + } + irq = res->start; + + hcd = usb_create_hcd(driver, &pdev->dev, pdev->dev.bus_id); + if (!hcd) { + retval = -ENOMEM; + goto err1; + } + + res = platform_get_resource(pdev, IORESOURCE_MEM, 0); + if (!res) { + dev_err(&pdev->dev, + "Found HC with no register addr. Check %s setup!\n", + pdev->dev.bus_id); + retval = -ENODEV; + goto err2; + } + hcd->rsrc_start = res->start; + hcd->rsrc_len = res->end - res->start + 1; + if (!request_mem_region(hcd->rsrc_start, hcd->rsrc_len, + driver->description)) { + dev_dbg(&pdev->dev, "controller already in use\n"); + retval = -EBUSY; + goto err2; + } + hcd->regs = ioremap(hcd->rsrc_start, hcd->rsrc_len); + + if (hcd->regs == NULL) { + dev_dbg(&pdev->dev, "error mapping memory\n"); + retval = -EFAULT; + goto err3; + } + + /* Enable USB controller */ + temp = in_be32(hcd->regs + 0x500); + out_be32(hcd->regs + 0x500, temp | 0x4); + + /* Set to Host mode */ + temp = in_le32(hcd->regs + 0x1a8); + out_le32(hcd->regs + 0x1a8, temp | 0x3); + + retval = usb_add_hcd(hcd, irq, SA_SHIRQ); + if (retval != 0) + goto err4; + return retval; + + err4: + iounmap(hcd->regs); + err3: + release_mem_region(hcd->rsrc_start, hcd->rsrc_len); + err2: + usb_put_hcd(hcd); + err1: + dev_err(&pdev->dev, "init %s fail, %d\n", pdev->dev.bus_id, retval); + return retval; +} + +/* may be called without controller electrically present */ +/* may be called with controller, bus, and devices active */ + +/** + * usb_hcd_fsl_remove - shutdown processing for FSL-based HCDs + * @dev: USB Host Controller being removed + * Context: !in_interrupt() + * + * Reverses the effect of usb_hcd_fsl_probe(). + * + */ +void usb_hcd_fsl_remove(struct usb_hcd *hcd, struct platform_device *pdev) +{ + usb_remove_hcd(hcd); + iounmap(hcd->regs); + release_mem_region(hcd->rsrc_start, hcd->rsrc_len); + usb_put_hcd(hcd); +} + +static void mpc83xx_setup_phy(struct ehci_hcd *ehci, + enum fsl_usb2_phy_modes phy_mode, + unsigned int port_offset) +{ + u32 portsc = 0; + switch (phy_mode) { + case FSL_USB2_PHY_ULPI: + portsc |= PORT_PTS_ULPI; + break; + case FSL_USB2_PHY_SERIAL: + portsc |= PORT_PTS_SERIAL; + break; + case FSL_USB2_PHY_UTMI_WIDE: + portsc |= PORT_PTS_PTW; + /* fall through */ + case FSL_USB2_PHY_UTMI: + portsc |= PORT_PTS_UTMI; + break; + case FSL_USB2_PHY_NONE: + break; + } + writel(portsc, &ehci->regs->port_status[port_offset]); +} + +static void mpc83xx_usb_setup(struct usb_hcd *hcd) +{ + struct ehci_hcd *ehci = hcd_to_ehci(hcd); + struct fsl_usb2_platform_data *pdata; + void __iomem *non_ehci = hcd->regs; + + pdata = + (struct fsl_usb2_platform_data *)hcd->self.controller-> + platform_data; + /* Enable PHY interface in the control reg. */ + out_be32(non_ehci + FSL_SOC_USB_CTRL, 0x00000004); + out_be32(non_ehci + FSL_SOC_USB_SNOOP1, 0x0000001b); + + if (pdata->operating_mode == FSL_USB2_DR_HOST) + mpc83xx_setup_phy(ehci, pdata->phy_mode, 0); + + if (pdata->operating_mode == FSL_USB2_MPH_HOST) { + unsigned int chip, rev, svr; + + svr = mfspr(SPRN_SVR); + chip = svr >> 16; + rev = (svr >> 4) & 0xf; + + /* Deal with USB Erratum #14 on MPC834x Rev 1.0 & 1.1 chips */ + if ((rev == 1) && (chip >= 0x8050) && (chip <= 0x8055)) + ehci->has_fsl_port_bug = 1; + + if (pdata->port_enables & FSL_USB2_PORT0_ENABLED) + mpc83xx_setup_phy(ehci, pdata->phy_mode, 0); + if (pdata->port_enables & FSL_USB2_PORT1_ENABLED) + mpc83xx_setup_phy(ehci, pdata->phy_mode, 1); + } + + /* put controller in host mode. */ + writel(0x00000003, non_ehci + FSL_SOC_USB_USBMODE); + out_be32(non_ehci + FSL_SOC_USB_PRICTRL, 0x0000000c); + out_be32(non_ehci + FSL_SOC_USB_AGECNTTHRSH, 0x00000040); + out_be32(non_ehci + FSL_SOC_USB_SICTRL, 0x00000001); +} + +/* called after powerup, by probe or system-pm "wakeup" */ +static int ehci_fsl_reinit(struct ehci_hcd *ehci) +{ + mpc83xx_usb_setup(ehci_to_hcd(ehci)); + ehci_port_power(ehci, 0); + + return 0; +} + +/* called during probe() after chip reset completes */ +static int ehci_fsl_setup(struct usb_hcd *hcd) +{ + struct ehci_hcd *ehci = hcd_to_ehci(hcd); + int retval; + + /* EHCI registers start at offset 0x100 */ + ehci->caps = hcd->regs + 0x100; + ehci->regs = hcd->regs + 0x100 + + HC_LENGTH(readl(&ehci->caps->hc_capbase)); + dbg_hcs_params(ehci, "reset"); + dbg_hcc_params(ehci, "reset"); + + /* cache this readonly data; minimize chip reads */ + ehci->hcs_params = readl(&ehci->caps->hcs_params); + + retval = ehci_halt(ehci); + if (retval) + return retval; + + /* data structure init */ + retval = ehci_init(hcd); + if (retval) + return retval; + + ehci->is_tdi_rh_tt = 1; + + ehci->sbrn = 0x20; + + ehci_reset(ehci); + + retval = ehci_fsl_reinit(ehci); + return retval; +} + +static const struct hc_driver ehci_fsl_hc_driver = { + .description = hcd_name, + .product_desc = "Freescale On-Chip EHCI Host Controller", + .hcd_priv_size = sizeof(struct ehci_hcd), + + /* + * generic hardware linkage + */ + .irq = ehci_irq, + .flags = HCD_USB2, + + /* + * basic lifecycle operations + */ + .reset = ehci_fsl_setup, + .start = ehci_run, +#ifdef CONFIG_PM + .suspend = ehci_bus_suspend, + .resume = ehci_bus_resume, +#endif + .stop = ehci_stop, + + /* + * managing i/o requests and associated device resources + */ + .urb_enqueue = ehci_urb_enqueue, + .urb_dequeue = ehci_urb_dequeue, + .endpoint_disable = ehci_endpoint_disable, + + /* + * scheduling support + */ + .get_frame_number = ehci_get_frame, + + /* + * root hub support + */ + .hub_status_data = ehci_hub_status_data, + .hub_control = ehci_hub_control, + .bus_suspend = ehci_bus_suspend, + .bus_resume = ehci_bus_resume, +}; + +static int ehci_fsl_drv_probe(struct platform_device *pdev) +{ + if (usb_disabled()) + return -ENODEV; + + return usb_hcd_fsl_probe(&ehci_fsl_hc_driver, pdev); +} + +static int ehci_fsl_drv_remove(struct platform_device *pdev) +{ + struct usb_hcd *hcd = platform_get_drvdata(pdev); + + usb_hcd_fsl_remove(hcd, pdev); + + return 0; +} + +static struct platform_driver ehci_fsl_dr_driver = { + .probe = ehci_fsl_drv_probe, + .remove = ehci_fsl_drv_remove, + .driver = { + .name = "fsl-usb2-dr", + }, +}; + +static struct platform_driver ehci_fsl_mph_driver = { + .probe = ehci_fsl_drv_probe, + .remove = ehci_fsl_drv_remove, + .driver = { + .name = "fsl-usb2-mph", + }, +}; + +static int __init ehci_fsl_init(void) +{ + int retval; + + pr_debug("%s: block sizes: qh %Zd qtd %Zd itd %Zd sitd %Zd\n", + hcd_name, + sizeof(struct ehci_qh), sizeof(struct ehci_qtd), + sizeof(struct ehci_itd), sizeof(struct ehci_sitd)); + + retval = platform_driver_register(&ehci_fsl_dr_driver); + if (retval) + return retval; + + return platform_driver_register(&ehci_fsl_mph_driver); +} + +static void __exit ehci_fsl_cleanup(void) +{ + platform_driver_unregister(&ehci_fsl_mph_driver); + platform_driver_unregister(&ehci_fsl_dr_driver); +} + +module_init(ehci_fsl_init); +module_exit(ehci_fsl_cleanup); |
