diff options
Diffstat (limited to 'drivers/thermal')
| -rw-r--r-- | drivers/thermal/imx_thermal.c | 20 |
1 files changed, 20 insertions, 0 deletions
diff --git a/drivers/thermal/imx_thermal.c b/drivers/thermal/imx_thermal.c index 77a962f..deab7ba 100644 --- a/drivers/thermal/imx_thermal.c +++ b/drivers/thermal/imx_thermal.c @@ -7,6 +7,7 @@ * */ +#include <linux/clk.h> #include <linux/cpu_cooling.h> #include <linux/cpufreq.h> #include <linux/delay.h> @@ -73,6 +74,7 @@ struct imx_thermal_data { unsigned long last_temp; bool irq_enabled; int irq; + struct clk *thermal_clk; }; static void imx_set_alarm_temp(struct imx_thermal_data *data, @@ -457,6 +459,22 @@ static int imx_thermal_probe(struct platform_device *pdev) return ret; } + data->thermal_clk = devm_clk_get(&pdev->dev, NULL); + if (IS_ERR(data->thermal_clk)) { + dev_warn(&pdev->dev, "failed to get thermal clk!\n"); + } else { + /* + * Thermal sensor needs clk on to get correct value, normally + * we should enable its clk before taking measurement and disable + * clk after measurement is done, but if alarm function is enabled, + * hardware will auto measure the temperature periodically, so we + * need to keep the clk always on for alarm function. + */ + ret = clk_prepare_enable(data->thermal_clk); + if (ret) + dev_warn(&pdev->dev, "failed to enable thermal clk: %d\n", ret); + } + /* Enable measurements at ~ 10 Hz */ regmap_write(map, TEMPSENSE1 + REG_CLR, TEMPSENSE1_MEASURE_FREQ); measure_freq = DIV_ROUND_UP(32768, 10); /* 10 Hz */ @@ -478,6 +496,8 @@ static int imx_thermal_remove(struct platform_device *pdev) /* Disable measurements */ regmap_write(map, TEMPSENSE0 + REG_SET, TEMPSENSE0_POWER_DOWN); + if (!IS_ERR(data->thermal_clk)) + clk_disable_unprepare(data->thermal_clk); thermal_zone_device_unregister(data->tz); cpufreq_cooling_unregister(data->cdev); |
