diff options
Diffstat (limited to 'drivers/spi/spi_bfin5xx.c')
-rw-r--r-- | drivers/spi/spi_bfin5xx.c | 57 |
1 files changed, 14 insertions, 43 deletions
diff --git a/drivers/spi/spi_bfin5xx.c b/drivers/spi/spi_bfin5xx.c index d446524..830c705 100644 --- a/drivers/spi/spi_bfin5xx.c +++ b/drivers/spi/spi_bfin5xx.c @@ -114,10 +114,7 @@ struct slave_data { u16 flag; u8 chip_select_num; - u8 n_bytes; - u8 width; /* 0 or 1 */ u8 enable_dma; - u8 bits_per_word; /* 8 or 16 */ u16 cs_chg_udelay; /* Some devices require > 255usec delay */ u32 cs_gpio; u16 idle_tx_val; @@ -562,6 +559,7 @@ static void bfin_spi_pump_transfers(unsigned long data) struct spi_transfer *transfer = NULL; struct spi_transfer *previous = NULL; struct slave_data *chip = NULL; + unsigned int bits_per_word; u8 width; u16 cr, dma_width, dma_config; u32 tranf_success = 1; @@ -641,26 +639,15 @@ static void bfin_spi_pump_transfers(unsigned long data) drv_data->cs_change = transfer->cs_change; /* Bits per word setup */ - switch (transfer->bits_per_word) { - case 8: + bits_per_word = transfer->bits_per_word ? : message->spi->bits_per_word; + if (bits_per_word == 8) { drv_data->n_bytes = 1; width = CFG_SPI_WORDSIZE8; drv_data->ops = &bfin_transfer_ops_u8; - break; - - case 16: + } else { drv_data->n_bytes = 2; width = CFG_SPI_WORDSIZE16; drv_data->ops = &bfin_transfer_ops_u16; - break; - - default: - /* No change, the same as default setting */ - transfer->bits_per_word = chip->bits_per_word; - drv_data->n_bytes = chip->n_bytes; - width = chip->width; - drv_data->ops = chip->ops; - break; } cr = (read_CTRL(drv_data) & (~BIT_CTL_TIMOD)); cr |= (width << 8); @@ -811,9 +798,9 @@ static void bfin_spi_pump_transfers(unsigned long data) if (drv_data->tx == NULL) write_TDBR(drv_data, chip->idle_tx_val); else { - if (transfer->bits_per_word == 8) + if (bits_per_word == 8) write_TDBR(drv_data, (*(u8 *) (drv_data->tx))); - else if (transfer->bits_per_word == 16) + else write_TDBR(drv_data, (*(u16 *) (drv_data->tx))); drv_data->tx += drv_data->n_bytes; } @@ -987,9 +974,6 @@ static int bfin_spi_setup(struct spi_device *spi) struct master_data *drv_data = spi_master_get_devdata(spi->master); int ret = -EINVAL; - if (spi->bits_per_word != 8 && spi->bits_per_word != 16) - goto error; - /* Only alloc (or use chip_info) on first setup */ chip_info = NULL; chip = spi_get_ctldata(spi); @@ -1023,10 +1007,16 @@ static int bfin_spi_setup(struct spi_device *spi) chip->enable_dma = chip_info->enable_dma != 0 && drv_data->master_info->enable_dma; chip->ctl_reg = chip_info->ctl_reg; - chip->bits_per_word = chip_info->bits_per_word; chip->cs_chg_udelay = chip_info->cs_chg_udelay; chip->idle_tx_val = chip_info->idle_tx_val; chip->pio_interrupt = chip_info->pio_interrupt; + spi->bits_per_word = chip_info->bits_per_word; + } + + if (spi->bits_per_word != 8 && spi->bits_per_word != 16) { + dev_err(&spi->dev, "%d bits_per_word is not supported\n", + spi->bits_per_word); + goto error; } /* translate common spi framework into our register */ @@ -1050,25 +1040,6 @@ static int bfin_spi_setup(struct spi_device *spi) else chip->cs_gpio = chip->chip_select_num - MAX_CTRL_CS; - switch (chip->bits_per_word) { - case 8: - chip->n_bytes = 1; - chip->width = CFG_SPI_WORDSIZE8; - chip->ops = &bfin_transfer_ops_u8; - break; - - case 16: - chip->n_bytes = 2; - chip->width = CFG_SPI_WORDSIZE16; - chip->ops = &bfin_transfer_ops_u16; - break; - - default: - dev_err(&spi->dev, "%d bits_per_word is not supported\n", - chip->bits_per_word); - goto error; - } - if (chip->enable_dma && chip->pio_interrupt) { dev_err(&spi->dev, "enable_dma is set, " "do not set pio_interrupt\n"); @@ -1119,7 +1090,7 @@ static int bfin_spi_setup(struct spi_device *spi) } dev_dbg(&spi->dev, "setup spi chip %s, width is %d, dma is %d\n", - spi->modalias, chip->width, chip->enable_dma); + spi->modalias, spi->bits_per_word, chip->enable_dma); dev_dbg(&spi->dev, "ctl_reg is 0x%x, flag_reg is 0x%x\n", chip->ctl_reg, chip->flag); |