diff options
Diffstat (limited to 'drivers/net/wireless/iwlwifi/iwl-shared.h')
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-shared.h | 227 |
1 files changed, 1 insertions, 226 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-shared.h b/drivers/net/wireless/iwlwifi/iwl-shared.h index 983b41e..35bd83c 100644 --- a/drivers/net/wireless/iwlwifi/iwl-shared.h +++ b/drivers/net/wireless/iwlwifi/iwl-shared.h @@ -70,6 +70,7 @@ #include "iwl-commands.h" #include "iwl-fw.h" +#include "iwl-config.h" /** * DOC: shared area - role and goal @@ -95,7 +96,6 @@ struct iwl_priv; struct iwl_trans; -struct iwl_sensitivity_ranges; struct iwl_trans_ops; #define DRV_NAME "iwlwifi" @@ -118,252 +118,56 @@ extern struct iwl_mod_params iwlagn_mod_params; * @disable_11n: disable 11n capabilities, default = 0, * use IWL_DISABLE_HT_* constants * @amsdu_size_8K: enable 8K amsdu size, default = 1 - * @antenna: both antennas (use diversity), default = 0 * @restart_fw: restart firmware, default = 1 * @plcp_check: enable plcp health check, default = true - * @ack_check: disable ack health check, default = false * @wd_disable: enable stuck queue check, default = 0 * @bt_coex_active: enable bt coex, default = true * @led_mode: system default, default = 0 - * @no_sleep_autoadjust: disable autoadjust, default = true * @power_save: disable power save, default = false * @power_level: power level, default = 1 * @debug_level: levels are IWL_DL_* * @ant_coupling: antenna coupling in dB, default = 0 * @bt_ch_announce: BT channel inhibition, default = enable - * @wanted_ucode_alternative: ucode alternative to use, default = 1 * @auto_agg: enable agg. without check, default = true */ struct iwl_mod_params { int sw_crypto; unsigned int disable_11n; int amsdu_size_8K; - int antenna; int restart_fw; bool plcp_check; - bool ack_check; int wd_disable; bool bt_coex_active; int led_mode; - bool no_sleep_autoadjust; bool power_save; int power_level; u32 debug_level; int ant_coupling; bool bt_ch_announce; - int wanted_ucode_alternative; bool auto_agg; }; /** - * struct iwl_hw_params - * - * Holds the module parameters - * - * @tx_chains_num: Number of TX chains - * @rx_chains_num: Number of RX chains - * @valid_tx_ant: usable antennas for TX - * @valid_rx_ant: usable antennas for RX - * @ht40_channel: is 40MHz width possible: BIT(IEEE80211_BAND_XXX) - * @sku: sku read from EEPROM - * @rx_page_order: Rx buffer page order - * @ct_kill_threshold: temperature threshold - in hw dependent unit - * @ct_kill_exit_threshold: when to reeable the device - in hw dependent unit - * relevant for 1000, 6000 and up - * @wd_timeout: TX queues watchdog timeout - * @struct iwl_sensitivity_ranges: range of sensitivity values - * @use_rts_for_aggregation: use rts/cts protection for HT traffic - */ -struct iwl_hw_params { - u8 tx_chains_num; - u8 rx_chains_num; - u8 valid_tx_ant; - u8 valid_rx_ant; - u8 ht40_channel; - bool use_rts_for_aggregation; - u16 sku; - u32 rx_page_order; - u32 ct_kill_threshold; - u32 ct_kill_exit_threshold; - unsigned int wd_timeout; - - const struct iwl_sensitivity_ranges *sens; -}; - -/* - * LED mode - * IWL_LED_DEFAULT: use device default - * IWL_LED_RF_STATE: turn LED on/off based on RF state - * LED ON = RF ON - * LED OFF = RF OFF - * IWL_LED_BLINK: adjust led blink rate based on blink table - * IWL_LED_DISABLE: led disabled - */ -enum iwl_led_mode { - IWL_LED_DEFAULT, - IWL_LED_RF_STATE, - IWL_LED_BLINK, - IWL_LED_DISABLE, -}; - -/* - * @max_ll_items: max number of OTP blocks - * @shadow_ram_support: shadow support for OTP memory - * @led_compensation: compensate on the led on/off time per HW according - * to the deviation to achieve the desired led frequency. - * The detail algorithm is described in iwl-led.c - * @chain_noise_num_beacons: number of beacons used to compute chain noise - * @adv_thermal_throttle: support advance thermal throttle - * @support_ct_kill_exit: support ct kill exit condition - * @plcp_delta_threshold: plcp error rate threshold used to trigger - * radio tuning when there is a high receiving plcp error rate - * @chain_noise_scale: default chain noise scale used for gain computation - * @wd_timeout: TX queues watchdog timeout - * @max_event_log_size: size of event log buffer size for ucode event logging - * @shadow_reg_enable: HW shadhow register bit - * @hd_v2: v2 of enhanced sensitivity value, used for 2000 series and up - * @no_idle_support: do not support idle mode - * wd_disable: disable watchdog timer - */ -struct iwl_base_params { - int eeprom_size; - int num_of_queues; /* def: HW dependent */ - /* for iwl_apm_init() */ - u32 pll_cfg_val; - - const u16 max_ll_items; - const bool shadow_ram_support; - u16 led_compensation; - bool adv_thermal_throttle; - bool support_ct_kill_exit; - u8 plcp_delta_threshold; - s32 chain_noise_scale; - unsigned int wd_timeout; - u32 max_event_log_size; - const bool shadow_reg_enable; - const bool hd_v2; - const bool no_idle_support; - const bool wd_disable; -}; - -/* - * @advanced_bt_coexist: support advanced bt coexist - * @bt_init_traffic_load: specify initial bt traffic load - * @bt_prio_boost: default bt priority boost value - * @agg_time_limit: maximum number of uSec in aggregation - * @bt_sco_disable: uCode should not response to BT in SCO/ESCO mode - */ -struct iwl_bt_params { - bool advanced_bt_coexist; - u8 bt_init_traffic_load; - u8 bt_prio_boost; - u16 agg_time_limit; - bool bt_sco_disable; - bool bt_session_2; -}; -/* - * @use_rts_for_aggregation: use rts/cts protection for HT traffic - */ -struct iwl_ht_params { - const bool ht_greenfield_support; /* if used set to true */ - bool use_rts_for_aggregation; - enum ieee80211_smps_mode smps_mode; -}; - -/** - * struct iwl_cfg - * @name: Offical name of the device - * @fw_name_pre: Firmware filename prefix. The api version and extension - * (.ucode) will be added to filename before loading from disk. The - * filename is constructed as fw_name_pre<api>.ucode. - * @ucode_api_max: Highest version of uCode API supported by driver. - * @ucode_api_ok: oldest version of the uCode API that is OK to load - * without a warning, for use in transitions - * @ucode_api_min: Lowest version of uCode API supported by driver. - * @max_inst_size: The maximal length of the fw inst section - * @max_data_size: The maximal length of the fw data section - * @valid_tx_ant: valid transmit antenna - * @valid_rx_ant: valid receive antenna - * @eeprom_ver: EEPROM version - * @eeprom_calib_ver: EEPROM calibration version - * @lib: pointer to the lib ops - * @additional_nic_config: additional nic configuration - * @base_params: pointer to basic parameters - * @ht_params: point to ht patameters - * @bt_params: pointer to bt parameters - * @need_temp_offset_calib: need to perform temperature offset calibration - * @no_xtal_calib: some devices do not need crystal calibration data, - * don't send it to those - * @led_mode: 0=blinking, 1=On(RF On)/Off(RF Off) - * @adv_pm: advance power management - * @rx_with_siso_diversity: 1x1 device with rx antenna diversity - * @internal_wimax_coex: internal wifi/wimax combo device - * @temp_offset_v2: support v2 of temperature offset calibration - * - * We enable the driver to be backward compatible wrt. hardware features. - * API differences in uCode shouldn't be handled here but through TLVs - * and/or the uCode API version instead. - */ -struct iwl_cfg { - /* params specific to an individual device within a device family */ - const char *name; - const char *fw_name_pre; - const unsigned int ucode_api_max; - const unsigned int ucode_api_ok; - const unsigned int ucode_api_min; - const u32 max_data_size; - const u32 max_inst_size; - u8 valid_tx_ant; - u8 valid_rx_ant; - u16 eeprom_ver; - u16 eeprom_calib_ver; - const struct iwl_lib_ops *lib; - void (*additional_nic_config)(struct iwl_priv *priv); - /* params not likely to change within a device family */ - const struct iwl_base_params *base_params; - /* params likely to change within a device family */ - const struct iwl_ht_params *ht_params; - const struct iwl_bt_params *bt_params; - const bool need_temp_offset_calib; /* if used set to true */ - const bool no_xtal_calib; - enum iwl_led_mode led_mode; - const bool adv_pm; - const bool rx_with_siso_diversity; - const bool internal_wimax_coex; - const bool temp_offset_v2; -}; - -/** * struct iwl_shared - shared fields for all the layers of the driver * - * @status: STATUS_* * @wowlan: are we running wowlan uCode * @bus: pointer to the bus layer data * @cfg: see struct iwl_cfg * @priv: pointer to the upper layer data * @trans: pointer to the transport layer data * @nic: pointer to the nic data - * @hw_params: see struct iwl_hw_params * @lock: protect general shared data * @eeprom: pointer to the eeprom/OTP image */ struct iwl_shared { - unsigned long status; - const struct iwl_cfg *cfg; struct iwl_trans *trans; void *drv; - struct iwl_hw_params hw_params; - - /* eeprom -- this is in the card's little endian byte order */ - u8 *eeprom; - }; /*Whatever _m is (iwl_trans, iwl_priv, these macros will work */ #define cfg(_m) ((_m)->shrd->cfg) #define trans(_m) ((_m)->shrd->trans) -#define hw_params(_m) ((_m)->shrd->hw_params) static inline bool iwl_have_debug_level(u32 level) { @@ -377,33 +181,4 @@ enum iwl_rxon_context_id { NUM_IWL_RXON_CTX }; -int iwlagn_hw_valid_rtc_data_addr(u32 addr); -const char *get_cmd_string(u8 cmd); - -#define IWL_CMD(x) case x: return #x - -/***************************************************** -* DRIVER STATUS FUNCTIONS -******************************************************/ -#define STATUS_HCMD_ACTIVE 0 /* host command in progress */ -/* 1 is unused (used to be STATUS_HCMD_SYNC_ACTIVE) */ -#define STATUS_INT_ENABLED 2 -#define STATUS_RF_KILL_HW 3 -#define STATUS_CT_KILL 4 -#define STATUS_INIT 5 -#define STATUS_ALIVE 6 -#define STATUS_READY 7 -#define STATUS_TEMPERATURE 8 -#define STATUS_GEO_CONFIGURED 9 -#define STATUS_EXIT_PENDING 10 -#define STATUS_STATISTICS 12 -#define STATUS_SCANNING 13 -#define STATUS_SCAN_ABORTING 14 -#define STATUS_SCAN_HW 15 -#define STATUS_POWER_PMI 16 -#define STATUS_FW_ERROR 17 -#define STATUS_DEVICE_ENABLED 18 -#define STATUS_CHANNEL_SWITCH_PENDING 19 -#define STATUS_SCAN_COMPLETE 20 - #endif /* #__iwl_shared_h__ */ |
