9 files changed, 41 insertions, 22 deletions

diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c
index af20c6e..e8e97a7 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c
@@ -662,14 +662,16 @@ void bnx2x_csum_validate(struct sk_buff *skb, union eth_rx_cqe *cqe,
 				 struct bnx2x_fastpath *fp,
 				 struct bnx2x_eth_q_stats *qstats)
 {
-	/* Do nothing if no IP/L4 csum validation was done */
-
+	/* Do nothing if no L4 csum validation was done.
+	 * We do not check whether IP csum was validated. For IPv4 we assume
+	 * that if the card got as far as validating the L4 csum, it also
+	 * validated the IP csum. IPv6 has no IP csum.
+	 */
 	if (cqe->fast_path_cqe.status_flags &
-	    (ETH_FAST_PATH_RX_CQE_IP_XSUM_NO_VALIDATION_FLG |
-	     ETH_FAST_PATH_RX_CQE_L4_XSUM_NO_VALIDATION_FLG))
+	    ETH_FAST_PATH_RX_CQE_L4_XSUM_NO_VALIDATION_FLG)
 		return;
 
-	/* If both IP/L4 validation were done, check if an error was found. */
+	/* If L4 validation was done, check if an error was found. */
 
 	if (cqe->fast_path_cqe.type_error_flags &
 	    (ETH_FAST_PATH_RX_CQE_IP_BAD_XSUM_FLG |
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
index 211753e..0875ecf 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
@@ -9831,12 +9831,13 @@ static void __devinit bnx2x_get_igu_cam_info(struct bnx2x *bp)
 	}
 
 #ifdef CONFIG_PCI_MSI
-	/*
-	 * It's expected that number of CAM entries for this functions is equal
-	 * to the number evaluated based on the MSI-X table size. We want a
-	 * harsh warning if these values are different!
+	/* Due to new PF resource allocation by MFW T7.4 and above, it's
+	 * optional that number of CAM entries will not be equal to the value
+	 * advertised in PCI.
+	 * Driver should use the minimal value of both as the actual status
+	 * block count
 	 */
-	WARN_ON(bp->igu_sb_cnt != igu_sb_cnt);
+	bp->igu_sb_cnt = min_t(int, bp->igu_sb_cnt, igu_sb_cnt);
 #endif
 
 	if (igu_sb_cnt == 0)
diff --git a/drivers/net/ethernet/cadence/at91_ether.c b/drivers/net/ethernet/cadence/at91_ether.c
index 7788419..4e980a78 100644
--- a/drivers/net/ethernet/cadence/at91_ether.c
+++ b/drivers/net/ethernet/cadence/at91_ether.c
@@ -1086,7 +1086,7 @@ static int __init at91ether_probe(struct platform_device *pdev)
 	/* Clock */
 	lp->ether_clk = clk_get(&pdev->dev, "ether_clk");
 	if (IS_ERR(lp->ether_clk)) {
-		res = -ENODEV;
+		res = PTR_ERR(lp->ether_clk);
 		goto err_ioumap;
 	}
 	clk_enable(lp->ether_clk);
diff --git a/drivers/net/ethernet/freescale/gianfar_ethtool.c b/drivers/net/ethernet/freescale/gianfar_ethtool.c
index 8971921..ab6762c 100644
--- a/drivers/net/ethernet/freescale/gianfar_ethtool.c
+++ b/drivers/net/ethernet/freescale/gianfar_ethtool.c
@@ -1773,6 +1773,7 @@ static int gfar_get_nfc(struct net_device *dev, struct ethtool_rxnfc *cmd,
 }
 
 int gfar_phc_index = -1;
+EXPORT_SYMBOL(gfar_phc_index);
 
 static int gfar_get_ts_info(struct net_device *dev,
 			    struct ethtool_ts_info *info)
diff --git a/drivers/net/ethernet/freescale/gianfar_ptp.c b/drivers/net/ethernet/freescale/gianfar_ptp.c
index c08e5d4..0daa66b 100644
--- a/drivers/net/ethernet/freescale/gianfar_ptp.c
+++ b/drivers/net/ethernet/freescale/gianfar_ptp.c
@@ -515,7 +515,7 @@ static int gianfar_ptp_probe(struct platform_device *dev)
 		err = PTR_ERR(etsects->clock);
 		goto no_clock;
 	}
-	gfar_phc_clock = ptp_clock_index(etsects->clock);
+	gfar_phc_index = ptp_clock_index(etsects->clock);
 
 	dev_set_drvdata(&dev->dev, etsects);
 
@@ -539,7 +539,7 @@ static int gianfar_ptp_remove(struct platform_device *dev)
 	gfar_write(&etsects->regs->tmr_temask, 0);
 	gfar_write(&etsects->regs->tmr_ctrl,   0);
 
-	gfar_phc_clock = -1;
+	gfar_phc_index = -1;
 	ptp_clock_unregister(etsects->clock);
 	iounmap(etsects->regs);
 	release_resource(etsects->rsrc);
diff --git a/drivers/net/ethernet/intel/e1000/e1000_main.c b/drivers/net/ethernet/intel/e1000/e1000_main.c
index 3bfbb8d..bde337e 100644
--- a/drivers/net/ethernet/intel/e1000/e1000_main.c
+++ b/drivers/net/ethernet/intel/e1000/e1000_main.c
@@ -3149,6 +3149,17 @@ static netdev_tx_t e1000_xmit_frame(struct sk_buff *skb,
 		return NETDEV_TX_OK;
 	}
 
+	/* On PCI/PCI-X HW, if packet size is less than ETH_ZLEN,
+	 * packets may get corrupted during padding by HW.
+	 * To WA this issue, pad all small packets manually.
+	 */
+	if (skb->len < ETH_ZLEN) {
+		if (skb_pad(skb, ETH_ZLEN - skb->len))
+			return NETDEV_TX_OK;
+		skb->len = ETH_ZLEN;
+		skb_set_tail_pointer(skb, ETH_ZLEN);
+	}
+
 	mss = skb_shinfo(skb)->gso_size;
 	/* The controller does a simple calculation to
 	 * make sure there is enough room in the FIFO before
diff --git a/drivers/net/ethernet/qlogic/netxen/netxen_nic_main.c b/drivers/net/ethernet/qlogic/netxen/netxen_nic_main.c
index 342b3a7..a77c558 100644
--- a/drivers/net/ethernet/qlogic/netxen/netxen_nic_main.c
+++ b/drivers/net/ethernet/qlogic/netxen/netxen_nic_main.c
@@ -1378,6 +1378,10 @@ static void netxen_mask_aer_correctable(struct netxen_adapter *adapter)
 	struct pci_dev *root = pdev->bus->self;
 	u32 aer_pos;
 
+	/* root bus? */
+	if (!root)
+		return;
+
 	if (adapter->ahw.board_type != NETXEN_BRDTYPE_P3_4_GB_MM &&
 		adapter->ahw.board_type != NETXEN_BRDTYPE_P3_10G_TP)
 		return;
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index c136162..3be8833 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -1066,7 +1066,7 @@ static int stmmac_open(struct net_device *dev)
 	} else
 		priv->tm->enable = 1;
 #endif
-	clk_enable(priv->stmmac_clk);
+	clk_prepare_enable(priv->stmmac_clk);
 
 	stmmac_check_ether_addr(priv);
 
@@ -1188,7 +1188,7 @@ open_error:
 	if (priv->phydev)
 		phy_disconnect(priv->phydev);
 
-	clk_disable(priv->stmmac_clk);
+	clk_disable_unprepare(priv->stmmac_clk);
 
 	return ret;
 }
@@ -1246,7 +1246,7 @@ static int stmmac_release(struct net_device *dev)
 #ifdef CONFIG_STMMAC_DEBUG_FS
 	stmmac_exit_fs();
 #endif
-	clk_disable(priv->stmmac_clk);
+	clk_disable_unprepare(priv->stmmac_clk);
 
 	return 0;
 }
@@ -2178,7 +2178,7 @@ int stmmac_suspend(struct net_device *ndev)
 	else {
 		stmmac_set_mac(priv->ioaddr, false);
 		/* Disable clock in case of PWM is off */
-		clk_disable(priv->stmmac_clk);
+		clk_disable_unprepare(priv->stmmac_clk);
 	}
 	spin_unlock_irqrestore(&priv->lock, flags);
 	return 0;
@@ -2203,7 +2203,7 @@ int stmmac_resume(struct net_device *ndev)
 		priv->hw->mac->pmt(priv->ioaddr, 0);
 	else
 		/* enable the clk prevously disabled */
-		clk_enable(priv->stmmac_clk);
+		clk_prepare_enable(priv->stmmac_clk);
 
 	netif_device_attach(ndev);
 
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_timer.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_timer.c
index 2a0e1ab..4ccd4e2 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_timer.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_timer.c
@@ -97,19 +97,19 @@ static struct clk *timer_clock;
 static void stmmac_tmu_start(unsigned int new_freq)
 {
 	clk_set_rate(timer_clock, new_freq);
-	clk_enable(timer_clock);
+	clk_prepare_enable(timer_clock);
 }
 
 static void stmmac_tmu_stop(void)
 {
-	clk_disable(timer_clock);
+	clk_disable_unprepare(timer_clock);
 }
 
 int stmmac_open_ext_timer(struct net_device *dev, struct stmmac_timer *tm)
 {
 	timer_clock = clk_get(NULL, TMU_CHANNEL);
 
-	if (timer_clock == NULL)
+	if (IS_ERR(timer_clock))
 		return -1;
 
 	if (tmu2_register_user(stmmac_timer_handler, (void *)dev) < 0) {
@@ -126,7 +126,7 @@ int stmmac_open_ext_timer(struct net_device *dev, struct stmmac_timer *tm)
 
 int stmmac_close_ext_timer(void)
 {
-	clk_disable(timer_clock);
+	clk_disable_unprepare(timer_clock);
 	tmu2_unregister_user();
 	clk_put(timer_clock);
 	return 0;