summaryrefslogtreecommitdiffstats
path: root/drivers/net/ethernet/intel/igb/e1000_defines.h
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/net/ethernet/intel/igb/e1000_defines.h')
-rw-r--r--drivers/net/ethernet/intel/igb/e1000_defines.h50
1 files changed, 30 insertions, 20 deletions
diff --git a/drivers/net/ethernet/intel/igb/e1000_defines.h b/drivers/net/ethernet/intel/igb/e1000_defines.h
index 7e13337..31a0f82 100644
--- a/drivers/net/ethernet/intel/igb/e1000_defines.h
+++ b/drivers/net/ethernet/intel/igb/e1000_defines.h
@@ -138,8 +138,7 @@
#define E1000_RCTL_PMCF 0x00800000 /* pass MAC control frames */
#define E1000_RCTL_SECRC 0x04000000 /* Strip Ethernet CRC */
-/*
- * Use byte values for the following shift parameters
+/* Use byte values for the following shift parameters
* Usage:
* psrctl |= (((ROUNDUP(value0, 128) >> E1000_PSRCTL_BSIZE0_SHIFT) &
* E1000_PSRCTL_BSIZE0_MASK) |
@@ -237,11 +236,14 @@
#define E1000_STATUS_GIO_MASTER_ENABLE 0x00080000
/* BMC external code execution disabled */
+#define E1000_STATUS_2P5_SKU 0x00001000 /* Val of 2.5GBE SKU strap */
+#define E1000_STATUS_2P5_SKU_OVER 0x00002000 /* Val of 2.5GBE SKU Over */
/* Constants used to intrepret the masked PCI-X bus speed. */
#define SPEED_10 10
#define SPEED_100 100
#define SPEED_1000 1000
+#define SPEED_2500 2500
#define HALF_DUPLEX 1
#define FULL_DUPLEX 2
@@ -382,8 +384,7 @@
#define E1000_EICR_OTHER 0x80000000 /* Interrupt Cause Active */
/* TCP Timer */
-/*
- * This defines the bits that are set in the Interrupt Mask
+/* This defines the bits that are set in the Interrupt Mask
* Set/Read Register. Each bit is documented below:
* o RXT0 = Receiver Timer Interrupt (ring 0)
* o TXDW = Transmit Descriptor Written Back
@@ -440,8 +441,7 @@
#define E1000_VLAN_FILTER_TBL_SIZE 128 /* VLAN Filter Table (4096 bits) */
/* Receive Address */
-/*
- * Number of high/low register pairs in the RAR. The RAR (Receive Address
+/* Number of high/low register pairs in the RAR. The RAR (Receive Address
* Registers) holds the directed and multicast addresses that we monitor.
* Technically, we have 16 spots. However, we reserve one of these spots
* (RAR[15]) for our directed address used by controllers with
@@ -760,8 +760,7 @@
#define MAX_PHY_MULTI_PAGE_REG 0xF
/* Bit definitions for valid PHY IDs. */
-/*
- * I = Integrated
+/* I = Integrated
* E = External
*/
#define M88E1111_I_PHY_ID 0x01410CC0
@@ -772,6 +771,7 @@
#define I350_I_PHY_ID 0x015403B0
#define M88_VENDOR 0x0141
#define I210_I_PHY_ID 0x01410C00
+#define M88E1545_E_PHY_ID 0x01410EA0
/* M88E1000 Specific Registers */
#define M88E1000_PHY_SPEC_CTRL 0x10 /* PHY Specific Control Register */
@@ -791,8 +791,7 @@
#define M88E1000_PSCR_AUTO_X_1000T 0x0040
/* Auto crossover enabled all speeds */
#define M88E1000_PSCR_AUTO_X_MODE 0x0060
-/*
- * 1=Enable Extended 10BASE-T distance (Lower 10BASE-T Rx Threshold
+/* 1=Enable Extended 10BASE-T distance (Lower 10BASE-T Rx Threshold
* 0=Normal 10BASE-T Rx Threshold
*/
/* 1=5-bit interface in 100BASE-TX, 0=MII interface in 100BASE-TX */
@@ -802,8 +801,7 @@
#define M88E1000_PSSR_REV_POLARITY 0x0002 /* 1=Polarity reversed */
#define M88E1000_PSSR_DOWNSHIFT 0x0020 /* 1=Downshifted */
#define M88E1000_PSSR_MDIX 0x0040 /* 1=MDIX; 0=MDI */
-/*
- * 0 = <50M
+/* 0 = <50M
* 1 = 50-80M
* 2 = 80-110M
* 3 = 110-140M
@@ -816,20 +814,17 @@
#define M88E1000_PSSR_CABLE_LENGTH_SHIFT 7
/* M88E1000 Extended PHY Specific Control Register */
-/*
- * 1 = Lost lock detect enabled.
+/* 1 = Lost lock detect enabled.
* Will assert lost lock and bring
* link down if idle not seen
* within 1ms in 1000BASE-T
*/
-/*
- * Number of times we will attempt to autonegotiate before downshifting if we
+/* Number of times we will attempt to autonegotiate before downshifting if we
* are the master
*/
#define M88E1000_EPSCR_MASTER_DOWNSHIFT_MASK 0x0C00
#define M88E1000_EPSCR_MASTER_DOWNSHIFT_1X 0x0000
-/*
- * Number of times we will attempt to autonegotiate before downshifting if we
+/* Number of times we will attempt to autonegotiate before downshifting if we
* are the slave
*/
#define M88E1000_EPSCR_SLAVE_DOWNSHIFT_MASK 0x0300
@@ -844,8 +839,7 @@
/* i347-AT4 Extended PHY Specific Control Register */
-/*
- * Number of times we will attempt to autonegotiate before downshifting if we
+/* Number of times we will attempt to autonegotiate before downshifting if we
* are the master
*/
#define I347AT4_PSCR_DOWNSHIFT_ENABLE 0x0800
@@ -895,6 +889,22 @@
#define E1000_EEER_LPI_FC 0x00040000 /* EEE Enable on FC */
#define E1000_EEE_SU_LPI_CLK_STP 0X00800000 /* EEE LPI Clock Stop */
#define E1000_EEER_EEE_NEG 0x20000000 /* EEE capability nego */
+#define E1000_EEE_LP_ADV_ADDR_I350 0x040F /* EEE LP Advertisement */
+#define E1000_EEE_LP_ADV_DEV_I210 7 /* EEE LP Adv Device */
+#define E1000_EEE_LP_ADV_ADDR_I210 61 /* EEE LP Adv Register */
+#define E1000_MMDAC_FUNC_DATA 0x4000 /* Data, no post increment */
+#define E1000_M88E1545_PAGE_ADDR 0x16 /* Page Offset Register */
+#define E1000_M88E1545_EEE_CTRL_1 0x0
+#define E1000_M88E1545_EEE_CTRL_1_MS 0x0001 /* EEE Master/Slave */
+#define E1000_EEE_ADV_DEV_I354 7
+#define E1000_EEE_ADV_ADDR_I354 60
+#define E1000_EEE_ADV_100_SUPPORTED (1 << 1) /* 100BaseTx EEE Supported */
+#define E1000_EEE_ADV_1000_SUPPORTED (1 << 2) /* 1000BaseT EEE Supported */
+#define E1000_PCS_STATUS_DEV_I354 3
+#define E1000_PCS_STATUS_ADDR_I354 1
+#define E1000_PCS_STATUS_TX_LPI_IND 0x0200 /* Tx in LPI state */
+#define E1000_PCS_STATUS_RX_LPI_RCVD 0x0400
+#define E1000_PCS_STATUS_TX_LPI_RCVD 0x0800
/* SerDes Control */
#define E1000_GEN_CTL_READY 0x80000000
OpenPOWER on IntegriCloud