diff options
Diffstat (limited to 'drivers/net/ethernet/intel/e1000e/netdev.c')
| -rw-r--r-- | drivers/net/ethernet/intel/e1000e/netdev.c | 38 |
1 files changed, 20 insertions, 18 deletions
diff --git a/drivers/net/ethernet/intel/e1000e/netdev.c b/drivers/net/ethernet/intel/e1000e/netdev.c index 77f81cb..e6d2c0f 100644 --- a/drivers/net/ethernet/intel/e1000e/netdev.c +++ b/drivers/net/ethernet/intel/e1000e/netdev.c @@ -2979,17 +2979,10 @@ static void e1000_setup_rctl(struct e1000_adapter *adapter) u32 pages = 0; /* Workaround Si errata on PCHx - configure jumbo frame flow */ - if (hw->mac.type >= e1000_pch2lan) { - s32 ret_val; - - if (adapter->netdev->mtu > ETH_DATA_LEN) - ret_val = e1000_lv_jumbo_workaround_ich8lan(hw, true); - else - ret_val = e1000_lv_jumbo_workaround_ich8lan(hw, false); - - if (ret_val) - e_dbg("failed to enable jumbo frame workaround mode\n"); - } + if ((hw->mac.type >= e1000_pch2lan) && + (adapter->netdev->mtu > ETH_DATA_LEN) && + e1000_lv_jumbo_workaround_ich8lan(hw, true)) + e_dbg("failed to enable jumbo frame workaround mode\n"); /* Program MC offset vector base */ rctl = er32(RCTL); @@ -3826,6 +3819,8 @@ void e1000e_reset(struct e1000_adapter *adapter) break; } + pba = 14; + ew32(PBA, pba); fc->high_water = ((pba << 10) * 9 / 10) & E1000_FCRTH_RTH; fc->low_water = ((pba << 10) * 8 / 10) & E1000_FCRTL_RTL; break; @@ -4034,6 +4029,12 @@ void e1000e_down(struct e1000_adapter *adapter) adapter->link_speed = 0; adapter->link_duplex = 0; + /* Disable Si errata workaround on PCHx for jumbo frame flow */ + if ((hw->mac.type >= e1000_pch2lan) && + (adapter->netdev->mtu > ETH_DATA_LEN) && + e1000_lv_jumbo_workaround_ich8lan(hw, false)) + e_dbg("failed to disable jumbo frame workaround mode\n"); + if (!pci_channel_offline(adapter->pdev)) e1000e_reset(adapter); @@ -4683,11 +4684,11 @@ static void e1000_phy_read_status(struct e1000_adapter *adapter) struct e1000_hw *hw = &adapter->hw; struct e1000_phy_regs *phy = &adapter->phy_regs; - if ((er32(STATUS) & E1000_STATUS_LU) && + if (!pm_runtime_suspended((&adapter->pdev->dev)->parent) && + (er32(STATUS) & E1000_STATUS_LU) && (adapter->hw.phy.media_type == e1000_media_type_copper)) { int ret_val; - pm_runtime_get_sync(&adapter->pdev->dev); ret_val = e1e_rphy(hw, MII_BMCR, &phy->bmcr); ret_val |= e1e_rphy(hw, MII_BMSR, &phy->bmsr); ret_val |= e1e_rphy(hw, MII_ADVERTISE, &phy->advertise); @@ -4698,7 +4699,6 @@ static void e1000_phy_read_status(struct e1000_adapter *adapter) ret_val |= e1e_rphy(hw, MII_ESTATUS, &phy->estatus); if (ret_val) e_warn("Error reading PHY register\n"); - pm_runtime_put_sync(&adapter->pdev->dev); } else { /* Do not read PHY registers if link is not up * Set values to typical power-on defaults @@ -5995,6 +5995,8 @@ static int __e1000_shutdown(struct pci_dev *pdev, bool runtime) */ e1000e_release_hw_control(adapter); + pci_clear_master(pdev); + /* The pci-e switch on some quad port adapters will report a * correctable error when the MAC transitions from D0 to D3. To * prevent this we need to mask off the correctable errors on the @@ -6723,10 +6725,6 @@ static int e1000_probe(struct pci_dev *pdev, const struct pci_device_id *ent) adapter->hw.fc.current_mode = e1000_fc_default; adapter->hw.phy.autoneg_advertised = 0x2f; - /* ring size defaults */ - adapter->rx_ring->count = E1000_DEFAULT_RXD; - adapter->tx_ring->count = E1000_DEFAULT_TXD; - /* Initial Wake on LAN setting - If APM wake is enabled in * the EEPROM, enable the ACPI Magic Packet filter */ @@ -6976,6 +6974,10 @@ static DEFINE_PCI_DEVICE_TABLE(e1000_pci_tbl) = { { PCI_VDEVICE(INTEL, E1000_DEV_ID_PCH_LPT_I217_V), board_pch_lpt }, { PCI_VDEVICE(INTEL, E1000_DEV_ID_PCH_LPTLP_I218_LM), board_pch_lpt }, { PCI_VDEVICE(INTEL, E1000_DEV_ID_PCH_LPTLP_I218_V), board_pch_lpt }, + { PCI_VDEVICE(INTEL, E1000_DEV_ID_PCH_I218_LM2), board_pch_lpt }, + { PCI_VDEVICE(INTEL, E1000_DEV_ID_PCH_I218_V2), board_pch_lpt }, + { PCI_VDEVICE(INTEL, E1000_DEV_ID_PCH_I218_LM3), board_pch_lpt }, + { PCI_VDEVICE(INTEL, E1000_DEV_ID_PCH_I218_V3), board_pch_lpt }, { 0, 0, 0, 0, 0, 0, 0 } /* terminate list */ }; |
