diff options
Diffstat (limited to 'drivers/ide/pci/tc86c001.c')
| -rw-r--r-- | drivers/ide/pci/tc86c001.c | 309 |
1 files changed, 309 insertions, 0 deletions
diff --git a/drivers/ide/pci/tc86c001.c b/drivers/ide/pci/tc86c001.c new file mode 100644 index 0000000..2ad72bb --- /dev/null +++ b/drivers/ide/pci/tc86c001.c @@ -0,0 +1,309 @@ +/* + * drivers/ide/pci/tc86c001.c Version 1.00 Dec 12, 2006 + * + * Copyright (C) 2002 Toshiba Corporation + * Copyright (C) 2005-2006 MontaVista Software, Inc. <source@mvista.com> + * + * This file is licensed under the terms of the GNU General Public + * License version 2. This program is licensed "as is" without any + * warranty of any kind, whether express or implied. + */ + +#include <linux/types.h> +#include <linux/pci.h> +#include <linux/ide.h> + +static inline u8 tc86c001_ratemask(ide_drive_t *drive) +{ + return eighty_ninty_three(drive) ? 2 : 1; +} + +static int tc86c001_tune_chipset(ide_drive_t *drive, u8 speed) +{ + ide_hwif_t *hwif = HWIF(drive); + unsigned long scr_port = hwif->config_data + (drive->dn ? 0x02 : 0x00); + u16 mode, scr = hwif->INW(scr_port); + + speed = ide_rate_filter(tc86c001_ratemask(drive), speed); + + switch (speed) { + case XFER_UDMA_4: mode = 0x00c0; break; + case XFER_UDMA_3: mode = 0x00b0; break; + case XFER_UDMA_2: mode = 0x00a0; break; + case XFER_UDMA_1: mode = 0x0090; break; + case XFER_UDMA_0: mode = 0x0080; break; + case XFER_MW_DMA_2: mode = 0x0070; break; + case XFER_MW_DMA_1: mode = 0x0060; break; + case XFER_MW_DMA_0: mode = 0x0050; break; + case XFER_PIO_4: mode = 0x0400; break; + case XFER_PIO_3: mode = 0x0300; break; + case XFER_PIO_2: mode = 0x0200; break; + case XFER_PIO_1: mode = 0x0100; break; + case XFER_PIO_0: + default: mode = 0x0000; break; + } + + scr &= (speed < XFER_MW_DMA_0) ? 0xf8ff : 0xff0f; + scr |= mode; + hwif->OUTW(scr, scr_port); + + return ide_config_drive_speed(drive, speed); +} + +static void tc86c001_tune_drive(ide_drive_t *drive, u8 pio) +{ + pio = ide_get_best_pio_mode(drive, pio, 4, NULL); + (void) tc86c001_tune_chipset(drive, XFER_PIO_0 + pio); +} + +/* + * HACKITY HACK + * + * This is a workaround for the limitation 5 of the TC86C001 IDE controller: + * if a DMA transfer terminates prematurely, the controller leaves the device's + * interrupt request (INTRQ) pending and does not generate a PCI interrupt (or + * set the interrupt bit in the DMA status register), thus no PCI interrupt + * will occur until a DMA transfer has been successfully completed. + * + * We work around this by initiating dummy, zero-length DMA transfer on + * a DMA timeout expiration. I found no better way to do this with the current + * IDE core than to temporarily replace a higher level driver's timer expiry + * handler with our own backing up to that handler in case our recovery fails. + */ +static int tc86c001_timer_expiry(ide_drive_t *drive) +{ + ide_hwif_t *hwif = HWIF(drive); + ide_expiry_t *expiry = ide_get_hwifdata(hwif); + ide_hwgroup_t *hwgroup = HWGROUP(drive); + u8 dma_stat = hwif->INB(hwif->dma_status); + + /* Restore a higher level driver's expiry handler first. */ + hwgroup->expiry = expiry; + + if ((dma_stat & 5) == 1) { /* DMA active and no interrupt */ + unsigned long sc_base = hwif->config_data; + unsigned long twcr_port = sc_base + (drive->dn ? 0x06 : 0x04); + u8 dma_cmd = hwif->INB(hwif->dma_command); + + printk(KERN_WARNING "%s: DMA interrupt possibly stuck, " + "attempting recovery...\n", drive->name); + + /* Stop DMA */ + hwif->OUTB(dma_cmd & ~0x01, hwif->dma_command); + + /* Setup the dummy DMA transfer */ + hwif->OUTW(0, sc_base + 0x0a); /* Sector Count */ + hwif->OUTW(0, twcr_port); /* Transfer Word Count 1 or 2 */ + + /* Start the dummy DMA transfer */ + hwif->OUTB(0x00, hwif->dma_command); /* clear R_OR_WCTR for write */ + hwif->OUTB(0x01, hwif->dma_command); /* set START_STOPBM */ + + /* + * If an interrupt was pending, it should come thru shortly. + * If not, a higher level driver's expiry handler should + * eventually cause some kind of recovery from the DMA stall. + */ + return WAIT_MIN_SLEEP; + } + + /* Chain to the restored expiry handler if DMA wasn't active. */ + if (likely(expiry != NULL)) + return expiry(drive); + + /* If there was no handler, "emulate" that for ide_timer_expiry()... */ + return -1; +} + +static void tc86c001_dma_start(ide_drive_t *drive) +{ + ide_hwif_t *hwif = HWIF(drive); + ide_hwgroup_t *hwgroup = HWGROUP(drive); + unsigned long sc_base = hwif->config_data; + unsigned long twcr_port = sc_base + (drive->dn ? 0x06 : 0x04); + unsigned long nsectors = hwgroup->rq->nr_sectors; + + /* + * We have to manually load the sector count and size into + * the appropriate system control registers for DMA to work + * with LBA48 and ATAPI devices... + */ + hwif->OUTW(nsectors, sc_base + 0x0a); /* Sector Count */ + hwif->OUTW(SECTOR_SIZE / 2, twcr_port); /* Transfer Word Count 1/2 */ + + /* Install our timeout expiry hook, saving the current handler... */ + ide_set_hwifdata(hwif, hwgroup->expiry); + hwgroup->expiry = &tc86c001_timer_expiry; + + ide_dma_start(drive); +} + +static int tc86c001_busproc(ide_drive_t *drive, int state) +{ + ide_hwif_t *hwif = HWIF(drive); + unsigned long sc_base = hwif->config_data; + u16 scr1; + + /* System Control 1 Register bit 11 (ATA Hard Reset) read */ + scr1 = hwif->INW(sc_base + 0x00); + + switch (state) { + case BUSSTATE_ON: + if (!(scr1 & 0x0800)) + return 0; + scr1 &= ~0x0800; + + hwif->drives[0].failures = hwif->drives[1].failures = 0; + break; + case BUSSTATE_OFF: + if (scr1 & 0x0800) + return 0; + scr1 |= 0x0800; + + hwif->drives[0].failures = hwif->drives[0].max_failures + 1; + hwif->drives[1].failures = hwif->drives[1].max_failures + 1; + break; + default: + return -EINVAL; + } + + /* System Control 1 Register bit 11 (ATA Hard Reset) write */ + hwif->OUTW(scr1, sc_base + 0x00); + return 0; +} + +static int config_chipset_for_dma(ide_drive_t *drive) +{ + u8 speed = ide_dma_speed(drive, tc86c001_ratemask(drive)); + + if (!speed) + return 0; + + (void) tc86c001_tune_chipset(drive, speed); + return ide_dma_enable(drive); +} + +static int tc86c001_config_drive_xfer_rate(ide_drive_t *drive) +{ + ide_hwif_t *hwif = HWIF(drive); + struct hd_driveid *id = drive->id; + + if ((id->capability & 1) && drive->autodma) { + + if (ide_use_dma(drive) && config_chipset_for_dma(drive)) + return hwif->ide_dma_on(drive); + + goto fast_ata_pio; + + } else if ((id->capability & 8) || (id->field_valid & 2)) { +fast_ata_pio: + tc86c001_tune_drive(drive, 255); + return hwif->ide_dma_off_quietly(drive); + } + /* IORDY not supported */ + return 0; +} + +static void __devinit init_hwif_tc86c001(ide_hwif_t *hwif) +{ + unsigned long sc_base = pci_resource_start(hwif->pci_dev, 5); + u16 scr1 = hwif->INW(sc_base + 0x00);; + + /* System Control 1 Register bit 15 (Soft Reset) set */ + hwif->OUTW(scr1 | 0x8000, sc_base + 0x00); + + /* System Control 1 Register bit 14 (FIFO Reset) set */ + hwif->OUTW(scr1 | 0x4000, sc_base + 0x00); + + /* System Control 1 Register: reset clear */ + hwif->OUTW(scr1 & ~0xc000, sc_base + 0x00); + + /* Store the system control register base for convenience... */ + hwif->config_data = sc_base; + + hwif->tuneproc = &tc86c001_tune_drive; + hwif->speedproc = &tc86c001_tune_chipset; + hwif->busproc = &tc86c001_busproc; + + hwif->drives[0].autotune = hwif->drives[1].autotune = 1; + + if (!hwif->dma_base) + return; + + /* + * Sector Count Control Register bits 0 and 1 set: + * software sets Sector Count Register for master and slave device + */ + hwif->OUTW(0x0003, sc_base + 0x0c); + + /* Sector Count Register limit */ + hwif->rqsize = 0xffff; + + hwif->atapi_dma = 1; + hwif->ultra_mask = 0x1f; + hwif->mwdma_mask = 0x07; + + hwif->ide_dma_check = &tc86c001_config_drive_xfer_rate; + hwif->dma_start = &tc86c001_dma_start; + + if (!hwif->udma_four) { + /* + * System Control 1 Register bit 13 (PDIAGN): + * 0=80-pin cable, 1=40-pin cable + */ + scr1 = hwif->INW(sc_base + 0x00); + hwif->udma_four = (scr1 & 0x2000) ? 0 : 1; + } + + if (!noautodma) + hwif->autodma = 1; + hwif->drives[0].autodma = hwif->drives[1].autodma = hwif->autodma; +} + +static unsigned int __devinit init_chipset_tc86c001(struct pci_dev *dev, + const char *name) +{ + int err = pci_request_region(dev, 5, name); + + if (err) + printk(KERN_ERR "%s: system control regs already in use", name); + return err; +} + +static ide_pci_device_t tc86c001_chipset __devinitdata = { + .name = "TC86C001", + .init_chipset = init_chipset_tc86c001, + .init_hwif = init_hwif_tc86c001, + .channels = 1, + .autodma = AUTODMA, + .bootable = OFF_BOARD +}; + +static int __devinit tc86c001_init_one(struct pci_dev *dev, + const struct pci_device_id *id) +{ + return ide_setup_pci_device(dev, &tc86c001_chipset); +} + +static struct pci_device_id tc86c001_pci_tbl[] = { + { PCI_VENDOR_ID_TOSHIBA_2, PCI_DEVICE_ID_TOSHIBA_TC86C001_IDE, + PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0}, + { 0, } +}; +MODULE_DEVICE_TABLE(pci, tc86c001_pci_tbl); + +static struct pci_driver driver = { + .name = "TC86C001", + .id_table = tc86c001_pci_tbl, + .probe = tc86c001_init_one +}; + +static int __init tc86c001_ide_init(void) +{ + return ide_pci_register_driver(&driver); +} +module_init(tc86c001_ide_init); + +MODULE_AUTHOR("MontaVista Software, Inc. <source@mvista.com>"); +MODULE_DESCRIPTION("PCI driver module for TC86C001 IDE"); +MODULE_LICENSE("GPL"); |
