summaryrefslogtreecommitdiffstats
path: root/arch/powerpc
diff options
context:
space:
mode:
Diffstat (limited to 'arch/powerpc')
-rw-r--r--arch/powerpc/sysdev/fsl_soc.c26
1 files changed, 26 insertions, 0 deletions
diff --git a/arch/powerpc/sysdev/fsl_soc.c b/arch/powerpc/sysdev/fsl_soc.c
index 01b884b..26ecb96 100644
--- a/arch/powerpc/sysdev/fsl_soc.c
+++ b/arch/powerpc/sysdev/fsl_soc.c
@@ -223,6 +223,8 @@ static int gfar_mdio_of_init_one(struct device_node *np)
if (ret)
return ret;
+ /* The gianfar device will try to use the same ID created below to find
+ * this bus, to coordinate register access (since they share). */
mdio_dev = platform_device_register_simple("fsl-gianfar_mdio",
res.start&0xfffff, &res, 1);
if (IS_ERR(mdio_dev))
@@ -394,6 +396,30 @@ static int __init gfar_of_init(void)
of_node_put(mdio);
}
+ /* Get MDIO bus controlled by this eTSEC, if any. Normally only
+ * eTSEC 1 will control an MDIO bus, not necessarily the same
+ * bus that its PHY is on ('mdio' above), so we can't just use
+ * that. What we do is look for a gianfar mdio device that has
+ * overlapping registers with this device. That's really the
+ * whole point, to find the device sharing our registers to
+ * coordinate access with it.
+ */
+ for_each_compatible_node(mdio, NULL, "fsl,gianfar-mdio") {
+ if (of_address_to_resource(mdio, 0, &res))
+ continue;
+
+ if (res.start >= r[0].start && res.end <= r[0].end) {
+ /* Get the ID the mdio bus platform device was
+ * registered with. gfar_data.bus_id is
+ * different because it's for finding a PHY,
+ * while this is for finding a MII bus.
+ */
+ gfar_data.mdio_bus = res.start&0xfffff;
+ of_node_put(mdio);
+ break;
+ }
+ }
+
ret =
platform_device_add_data(gfar_dev, &gfar_data,
sizeof(struct
OpenPOWER on IntegriCloud