diff options
Diffstat (limited to 'arch/mips/include')
-rw-r--r-- | arch/mips/include/asm/mach-au1x00/au1000.h | 142 |
1 files changed, 93 insertions, 49 deletions
diff --git a/arch/mips/include/asm/mach-au1x00/au1000.h b/arch/mips/include/asm/mach-au1x00/au1000.h index 1bbcb30..49a227d 100644 --- a/arch/mips/include/asm/mach-au1x00/au1000.h +++ b/arch/mips/include/asm/mach-au1x00/au1000.h @@ -254,6 +254,14 @@ enum alchemy_usb_block { }; int alchemy_usb_control(int block, int enable); +/* PCI controller platform data */ +struct alchemy_pci_platdata { + int (*board_map_irq)(const struct pci_dev *d, u8 slot, u8 pin); + int (*board_pci_idsel)(unsigned int devsel, int assert); + /* bits to set/clear in PCI_CONFIG register */ + unsigned long pci_cfg_set; + unsigned long pci_cfg_clr; +}; /* SOC Interrupt numbers */ @@ -1309,58 +1317,30 @@ enum soc_au1200_ints { # define AC97C_RS (1 << 1) # define AC97C_CE (1 << 0) -#if defined(CONFIG_SOC_AU1500) || defined(CONFIG_SOC_AU1550) -/* Au1500 PCI Controller */ -#define Au1500_CFG_BASE 0xB4005000 /* virtual, KSEG1 addr */ -#define Au1500_PCI_CMEM (Au1500_CFG_BASE + 0) -#define Au1500_PCI_CFG (Au1500_CFG_BASE + 4) -# define PCI_ERROR ((1 << 22) | (1 << 23) | (1 << 24) | \ - (1 << 25) | (1 << 26) | (1 << 27)) -#define Au1500_PCI_B2BMASK_CCH (Au1500_CFG_BASE + 8) -#define Au1500_PCI_B2B0_VID (Au1500_CFG_BASE + 0xC) -#define Au1500_PCI_B2B1_ID (Au1500_CFG_BASE + 0x10) -#define Au1500_PCI_MWMASK_DEV (Au1500_CFG_BASE + 0x14) -#define Au1500_PCI_MWBASE_REV_CCL (Au1500_CFG_BASE + 0x18) -#define Au1500_PCI_ERR_ADDR (Au1500_CFG_BASE + 0x1C) -#define Au1500_PCI_SPEC_INTACK (Au1500_CFG_BASE + 0x20) -#define Au1500_PCI_ID (Au1500_CFG_BASE + 0x100) -#define Au1500_PCI_STATCMD (Au1500_CFG_BASE + 0x104) -#define Au1500_PCI_CLASSREV (Au1500_CFG_BASE + 0x108) -#define Au1500_PCI_HDRTYPE (Au1500_CFG_BASE + 0x10C) -#define Au1500_PCI_MBAR (Au1500_CFG_BASE + 0x110) - -#define Au1500_PCI_HDR 0xB4005100 /* virtual, KSEG1 addr */ -/* - * All of our structures, like PCI resource, have 32-bit members. - * Drivers are expected to do an ioremap on the PCI MEM resource, but it's - * hard to store 0x4 0000 0000 in a 32-bit type. We require a small patch - * to __ioremap to check for addresses between (u32)Au1500_PCI_MEM_START and - * (u32)Au1500_PCI_MEM_END and change those to the full 36-bit PCI MEM - * addresses. For PCI I/O, it's simpler because we get to do the ioremap - * ourselves and then adjust the device's resources. +/* The PCI chip selects are outside the 32bit space, and since we can't + * just program the 36bit addresses into BARs, we have to take a chunk + * out of the 32bit space and reserve it for PCI. When these addresses + * are ioremap()ed, they'll be fixed up to the real 36bit address before + * being passed to the real ioremap function. */ -#define Au1500_EXT_CFG 0x600000000ULL -#define Au1500_EXT_CFG_TYPE1 0x680000000ULL -#define Au1500_PCI_IO_START 0x500000000ULL -#define Au1500_PCI_IO_END 0x5000FFFFFULL -#define Au1500_PCI_MEM_START 0x440000000ULL -#define Au1500_PCI_MEM_END 0x44FFFFFFFULL +#define ALCHEMY_PCI_MEMWIN_START (AU1500_PCI_MEM_PHYS_ADDR >> 4) +#define ALCHEMY_PCI_MEMWIN_END (ALCHEMY_PCI_MEMWIN_START + 0x0FFFFFFF) -#define PCI_IO_START 0x00001000 -#define PCI_IO_END 0x000FFFFF -#define PCI_MEM_START 0x40000000 -#define PCI_MEM_END 0x4FFFFFFF +/* for PCI IO it's simpler because we get to do the ioremap ourselves and then + * adjust the device's resources. + */ +#define ALCHEMY_PCI_IOWIN_START 0x00001000 +#define ALCHEMY_PCI_IOWIN_END 0x0000FFFF -#define PCI_FIRST_DEVFN (0 << 3) -#define PCI_LAST_DEVFN (19 << 3) +#ifdef CONFIG_PCI #define IOPORT_RESOURCE_START 0x00001000 /* skip legacy probing */ #define IOPORT_RESOURCE_END 0xffffffff #define IOMEM_RESOURCE_START 0x10000000 #define IOMEM_RESOURCE_END 0xfffffffffULL -#else /* Au1000 and Au1100 and Au1200 */ +#else /* Don't allow any legacy ports probing */ #define IOPORT_RESOURCE_START 0x10000000 @@ -1368,13 +1348,77 @@ enum soc_au1200_ints { #define IOMEM_RESOURCE_START 0x10000000 #define IOMEM_RESOURCE_END 0xfffffffffULL -#define PCI_IO_START 0 -#define PCI_IO_END 0 -#define PCI_MEM_START 0 -#define PCI_MEM_END 0 -#define PCI_FIRST_DEVFN 0 -#define PCI_LAST_DEVFN 0 - #endif +/* PCI controller block register offsets */ +#define PCI_REG_CMEM 0x0000 +#define PCI_REG_CONFIG 0x0004 +#define PCI_REG_B2BMASK_CCH 0x0008 +#define PCI_REG_B2BBASE0_VID 0x000C +#define PCI_REG_B2BBASE1_SID 0x0010 +#define PCI_REG_MWMASK_DEV 0x0014 +#define PCI_REG_MWBASE_REV_CCL 0x0018 +#define PCI_REG_ERR_ADDR 0x001C +#define PCI_REG_SPEC_INTACK 0x0020 +#define PCI_REG_ID 0x0100 +#define PCI_REG_STATCMD 0x0104 +#define PCI_REG_CLASSREV 0x0108 +#define PCI_REG_PARAM 0x010C +#define PCI_REG_MBAR 0x0110 +#define PCI_REG_TIMEOUT 0x0140 + +/* PCI controller block register bits */ +#define PCI_CMEM_E (1 << 28) /* enable cacheable memory */ +#define PCI_CMEM_CMBASE(x) (((x) & 0x3fff) << 14) +#define PCI_CMEM_CMMASK(x) ((x) & 0x3fff) +#define PCI_CONFIG_ERD (1 << 27) /* pci error during R/W */ +#define PCI_CONFIG_ET (1 << 26) /* error in target mode */ +#define PCI_CONFIG_EF (1 << 25) /* fatal error */ +#define PCI_CONFIG_EP (1 << 24) /* parity error */ +#define PCI_CONFIG_EM (1 << 23) /* multiple errors */ +#define PCI_CONFIG_BM (1 << 22) /* bad master error */ +#define PCI_CONFIG_PD (1 << 20) /* PCI Disable */ +#define PCI_CONFIG_BME (1 << 19) /* Byte Mask Enable for reads */ +#define PCI_CONFIG_NC (1 << 16) /* mark mem access non-coherent */ +#define PCI_CONFIG_IA (1 << 15) /* INTA# enabled (target mode) */ +#define PCI_CONFIG_IP (1 << 13) /* int on PCI_PERR# */ +#define PCI_CONFIG_IS (1 << 12) /* int on PCI_SERR# */ +#define PCI_CONFIG_IMM (1 << 11) /* int on master abort */ +#define PCI_CONFIG_ITM (1 << 10) /* int on target abort (as master) */ +#define PCI_CONFIG_ITT (1 << 9) /* int on target abort (as target) */ +#define PCI_CONFIG_IPB (1 << 8) /* int on PERR# in bus master acc */ +#define PCI_CONFIG_SIC_NO (0 << 6) /* no byte mask changes */ +#define PCI_CONFIG_SIC_BA_ADR (1 << 6) /* on byte/hw acc, invert adr bits */ +#define PCI_CONFIG_SIC_HWA_DAT (2 << 6) /* on halfword acc, swap data */ +#define PCI_CONFIG_SIC_ALL (3 << 6) /* swap data bytes on all accesses */ +#define PCI_CONFIG_ST (1 << 5) /* swap data by target transactions */ +#define PCI_CONFIG_SM (1 << 4) /* swap data from PCI ctl */ +#define PCI_CONFIG_AEN (1 << 3) /* enable internal arbiter */ +#define PCI_CONFIG_R2H (1 << 2) /* REQ2# to hi-prio arbiter */ +#define PCI_CONFIG_R1H (1 << 1) /* REQ1# to hi-prio arbiter */ +#define PCI_CONFIG_CH (1 << 0) /* PCI ctl to hi-prio arbiter */ +#define PCI_B2BMASK_B2BMASK(x) (((x) & 0xffff) << 16) +#define PCI_B2BMASK_CCH(x) ((x) & 0xffff) /* 16 upper bits of class code */ +#define PCI_B2BBASE0_VID_B0(x) (((x) & 0xffff) << 16) +#define PCI_B2BBASE0_VID_SV(x) ((x) & 0xffff) +#define PCI_B2BBASE1_SID_B1(x) (((x) & 0xffff) << 16) +#define PCI_B2BBASE1_SID_SI(x) ((x) & 0xffff) +#define PCI_MWMASKDEV_MWMASK(x) (((x) & 0xffff) << 16) +#define PCI_MWMASKDEV_DEVID(x) ((x) & 0xffff) +#define PCI_MWBASEREVCCL_BASE(x) (((x) & 0xffff) << 16) +#define PCI_MWBASEREVCCL_REV(x) (((x) & 0xff) << 8) +#define PCI_MWBASEREVCCL_CCL(x) ((x) & 0xff) +#define PCI_ID_DID(x) (((x) & 0xffff) << 16) +#define PCI_ID_VID(x) ((x) & 0xffff) +#define PCI_STATCMD_STATUS(x) (((x) & 0xffff) << 16) +#define PCI_STATCMD_CMD(x) ((x) & 0xffff) +#define PCI_CLASSREV_CLASS(x) (((x) & 0x00ffffff) << 8) +#define PCI_CLASSREV_REV(x) ((x) & 0xff) +#define PCI_PARAM_BIST(x) (((x) & 0xff) << 24) +#define PCI_PARAM_HT(x) (((x) & 0xff) << 16) +#define PCI_PARAM_LT(x) (((x) & 0xff) << 8) +#define PCI_PARAM_CLS(x) ((x) & 0xff) +#define PCI_TIMEOUT_RETRIES(x) (((x) & 0xff) << 8) /* max retries */ +#define PCI_TIMEOUT_TO(x) ((x) & 0xff) /* target ready timeout */ + #endif |