diff options
Diffstat (limited to 'Documentation/powerpc/dts-bindings/fsl/upm-nand.txt')
| -rw-r--r-- | Documentation/powerpc/dts-bindings/fsl/upm-nand.txt | 39 |
1 files changed, 37 insertions, 2 deletions
diff --git a/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt b/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt index 84a04d5..a48b2ca 100644 --- a/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt +++ b/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt @@ -5,9 +5,21 @@ Required properties: - reg : should specify localbus chip select and size used for the chip. - fsl,upm-addr-offset : UPM pattern offset for the address latch. - fsl,upm-cmd-offset : UPM pattern offset for the command latch. -- gpios : may specify optional GPIO connected to the Ready-Not-Busy pin. -Example: +Optional properties: +- fsl,upm-wait-flags : add chip-dependent short delays after running the + UPM pattern (0x1), after writing a data byte (0x2) or after + writing out a buffer (0x4). +- fsl,upm-addr-line-cs-offsets : address offsets for multi-chip support. + The corresponding address lines are used to select the chip. +- gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins + (R/B#). For multi-chip devices, "n" GPIO definitions are required + according to the number of chips. +- chip-delay : chip dependent delay for transfering data from array to + read registers (tR). Required if property "gpios" is not used + (R/B# pins not connected). + +Examples: upm@1,0 { compatible = "fsl,upm-nand"; @@ -26,3 +38,26 @@ upm@1,0 { }; }; }; + +upm@3,0 { + #address-cells = <0>; + #size-cells = <0>; + compatible = "tqc,tqm8548-upm-nand", "fsl,upm-nand"; + reg = <3 0x0 0x800>; + fsl,upm-addr-offset = <0x10>; + fsl,upm-cmd-offset = <0x08>; + /* Multi-chip NAND device */ + fsl,upm-addr-line-cs-offsets = <0x0 0x200>; + fsl,upm-wait-flags = <0x5>; + chip-delay = <25>; // in micro-seconds + + nand@0 { + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "fs"; + reg = <0x00000000 0x10000000>; + }; + }; +}; |
