diff options
Diffstat (limited to 'Documentation/dmatest.txt')
| -rw-r--r-- | Documentation/dmatest.txt | 6 |
1 files changed, 3 insertions, 3 deletions
diff --git a/Documentation/dmatest.txt b/Documentation/dmatest.txt index 279ac0a..132a094 100644 --- a/Documentation/dmatest.txt +++ b/Documentation/dmatest.txt @@ -34,7 +34,7 @@ command: After a while you will start to get messages about current status or error like in the original code. -Note that running a new test will stop any in progress test. +Note that running a new test will not stop any in progress test. The following command should return actual state of the test. % cat /sys/kernel/debug/dmatest/run @@ -52,8 +52,8 @@ To wait for test done the user may perform a busy loop that checks the state. The module parameters that is supplied to the kernel command line will be used for the first performed test. After user gets a control, the test could be -interrupted or re-run with same or different parameters. For the details see -the above section "Part 2 - When dmatest is built as a module..." +re-run with the same or different parameters. For the details see the above +section "Part 2 - When dmatest is built as a module..." In both cases the module parameters are used as initial values for the test case. You always could check them at run-time by running |
