diff options
Diffstat (limited to 'Documentation/devicetree/bindings/gpio')
-rw-r--r-- | Documentation/devicetree/bindings/gpio/led.txt | 58 |
1 files changed, 0 insertions, 58 deletions
diff --git a/Documentation/devicetree/bindings/gpio/led.txt b/Documentation/devicetree/bindings/gpio/led.txt deleted file mode 100644 index edc83c1..0000000 --- a/Documentation/devicetree/bindings/gpio/led.txt +++ /dev/null @@ -1,58 +0,0 @@ -LEDs connected to GPIO lines - -Required properties: -- compatible : should be "gpio-leds". - -Each LED is represented as a sub-node of the gpio-leds device. Each -node's name represents the name of the corresponding LED. - -LED sub-node properties: -- gpios : Should specify the LED's GPIO, see "gpios property" in - Documentation/devicetree/bindings/gpio/gpio.txt. Active low LEDs should be - indicated using flags in the GPIO specifier. -- label : (optional) The label for this LED. If omitted, the label is - taken from the node name (excluding the unit address). -- linux,default-trigger : (optional) This parameter, if present, is a - string defining the trigger assigned to the LED. Current triggers are: - "backlight" - LED will act as a back-light, controlled by the framebuffer - system - "default-on" - LED will turn on, but see "default-state" below - "heartbeat" - LED "double" flashes at a load average based rate - "ide-disk" - LED indicates disk activity - "timer" - LED flashes at a fixed, configurable rate -- default-state: (optional) The initial state of the LED. Valid - values are "on", "off", and "keep". If the LED is already on or off - and the default-state property is set the to same value, then no - glitch should be produced where the LED momentarily turns off (or - on). The "keep" setting will keep the LED at whatever its current - state is, without producing a glitch. The default is off if this - property is not present. - -Examples: - -leds { - compatible = "gpio-leds"; - hdd { - label = "IDE Activity"; - gpios = <&mcu_pio 0 1>; /* Active low */ - linux,default-trigger = "ide-disk"; - }; - - fault { - gpios = <&mcu_pio 1 0>; - /* Keep LED on if BIOS detected hardware fault */ - default-state = "keep"; - }; -}; - -run-control { - compatible = "gpio-leds"; - red { - gpios = <&mpc8572 6 0>; - default-state = "off"; - }; - green { - gpios = <&mpc8572 7 0>; - default-state = "on"; - }; -}; |