diff options
| -rw-r--r-- | Documentation/sound/oss/CS4232 | 23 | ||||
| -rw-r--r-- | Documentation/sound/oss/Introduction | 2 | ||||
| -rw-r--r-- | sound/oss/ad1848.c | 4 | ||||
| -rw-r--r-- | sound/oss/dmabuf.c | 2 | ||||
| -rw-r--r-- | sound/oss/pas2_card.c | 4 | ||||
| -rw-r--r-- | sound/oss/pss.c | 12 | ||||
| -rw-r--r-- | sound/oss/sequencer.c | 3 |
7 files changed, 12 insertions, 38 deletions
diff --git a/Documentation/sound/oss/CS4232 b/Documentation/sound/oss/CS4232 deleted file mode 100644 index 7d6af7a..0000000 --- a/Documentation/sound/oss/CS4232 +++ /dev/null @@ -1,23 +0,0 @@ -To configure the Crystal CS423x sound chip and activate its DSP functions, -modules may be loaded in this order: - - modprobe sound - insmod ad1848 - insmod uart401 - insmod cs4232 io=* irq=* dma=* dma2=* - -This is the meaning of the parameters: - - io--I/O address of the Windows Sound System (normally 0x534) - irq--IRQ of this device - dma and dma2--DMA channels (DMA2 may be 0) - -On some cards, the board attempts to do non-PnP setup, and fails. If you -have problems, use Linux' PnP facilities. - -To get MIDI facilities add - - insmod opl3 io=* - -where "io" is the I/O address of the OPL3 synthesizer. This will be shown -in /proc/sys/pnp and is normally 0x388. diff --git a/Documentation/sound/oss/Introduction b/Documentation/sound/oss/Introduction index f04ba6b..75d967f 100644 --- a/Documentation/sound/oss/Introduction +++ b/Documentation/sound/oss/Introduction @@ -80,7 +80,7 @@ Notes: additional features. 2. The commercial OSS driver may be obtained from the site: - http://www/opensound.com. This may be used for cards that + http://www.opensound.com. This may be used for cards that are unsupported by the kernel driver, or may be used by other operating systems. diff --git a/sound/oss/ad1848.c b/sound/oss/ad1848.c index 7cf9913..d12bd98 100644 --- a/sound/oss/ad1848.c +++ b/sound/oss/ad1848.c @@ -280,7 +280,7 @@ static void wait_for_calibration(ad1848_info * devc) while (timeout > 0 && (ad_read(devc, 11) & 0x20)) timeout--; if (ad_read(devc, 11) & 0x20) - if ( (devc->model != MD_1845) || (devc->model != MD_1845_SSCAPE)) + if ((devc->model != MD_1845) && (devc->model != MD_1845_SSCAPE)) printk(KERN_WARNING "ad1848: Auto calibration timed out(3).\n"); } @@ -2107,7 +2107,7 @@ int ad1848_control(int cmd, int arg) switch (cmd) { case AD1848_SET_XTAL: /* Change clock frequency of AD1845 (only ) */ - if (devc->model != MD_1845 || devc->model != MD_1845_SSCAPE) + if (devc->model != MD_1845 && devc->model != MD_1845_SSCAPE) return -EINVAL; spin_lock_irqsave(&devc->lock,flags); ad_enter_MCE(devc); diff --git a/sound/oss/dmabuf.c b/sound/oss/dmabuf.c index 1e90d76..1bfcf7e 100644 --- a/sound/oss/dmabuf.c +++ b/sound/oss/dmabuf.c @@ -439,7 +439,7 @@ int DMAbuf_sync(int dev) DMAbuf_launch_output(dev, dmap); adev->dmap_out->flags |= DMA_SYNCING; adev->dmap_out->underrun_count = 0; - while (!signal_pending(current) && n++ <= adev->dmap_out->nbufs && + while (!signal_pending(current) && n++ < adev->dmap_out->nbufs && adev->dmap_out->qlen && adev->dmap_out->underrun_count == 0) { long t = dmabuf_timeout(dmap); spin_unlock_irqrestore(&dmap->lock,flags); diff --git a/sound/oss/pas2_card.c b/sound/oss/pas2_card.c index 25f3a22..7f377ec 100644 --- a/sound/oss/pas2_card.c +++ b/sound/oss/pas2_card.c @@ -156,9 +156,7 @@ static int __init config_pas_hw(struct address_info *hw_config) * 0x80 */ , 0xB88); - pas_write(0x80 - | joystick?0x40:0 - ,0xF388); + pas_write(0x80 | (joystick ? 0x40 : 0), 0xF388); if (pas_irq < 0 || pas_irq > 15) { diff --git a/sound/oss/pss.c b/sound/oss/pss.c index 16ed069..16517a5 100644 --- a/sound/oss/pss.c +++ b/sound/oss/pss.c @@ -457,10 +457,9 @@ static void pss_mixer_reset(pss_confdata *devc) } } -static int set_volume_mono(unsigned __user *p, int *aleft) +static int set_volume_mono(unsigned __user *p, unsigned int *aleft) { - int left; - unsigned volume; + unsigned int left, volume; if (get_user(volume, p)) return -EFAULT; @@ -471,10 +470,11 @@ static int set_volume_mono(unsigned __user *p, int *aleft) return 0; } -static int set_volume_stereo(unsigned __user *p, int *aleft, int *aright) +static int set_volume_stereo(unsigned __user *p, + unsigned int *aleft, + unsigned int *aright) { - int left, right; - unsigned volume; + unsigned int left, right, volume; if (get_user(volume, p)) return -EFAULT; diff --git a/sound/oss/sequencer.c b/sound/oss/sequencer.c index 5c215f7..c798746 100644 --- a/sound/oss/sequencer.c +++ b/sound/oss/sequencer.c @@ -212,7 +212,6 @@ int sequencer_write(int dev, struct file *file, const char __user *buf, int coun { unsigned char event_rec[EV_SZ], ev_code; int p = 0, c, ev_size; - int err; int mode = translate_mode(file); dev = dev >> 4; @@ -285,7 +284,7 @@ int sequencer_write(int dev, struct file *file, const char __user *buf, int coun { if (!midi_opened[event_rec[2]]) { - int mode; + int err, mode; int dev = event_rec[2]; if (dev >= max_mididev || midi_devs[dev]==NULL) |
