diff options
| -rw-r--r-- | drivers/net/cs89x0.c | 28 |
1 files changed, 17 insertions, 11 deletions
diff --git a/drivers/net/cs89x0.c b/drivers/net/cs89x0.c index ff64976..7433b88 100644 --- a/drivers/net/cs89x0.c +++ b/drivers/net/cs89x0.c @@ -501,6 +501,21 @@ static void net_poll_controller(struct net_device *dev) } #endif +static const struct net_device_ops net_ops = { + .ndo_open = net_open, + .ndo_stop = net_close, + .ndo_tx_timeout = net_timeout, + .ndo_start_xmit = net_send_packet, + .ndo_get_stats = net_get_stats, + .ndo_set_multicast_list = set_multicast_list, + .ndo_set_mac_address = set_mac_address, +#ifdef CONFIG_NET_POLL_CONTROLLER + .ndo_poll_controller = net_poll_controller, +#endif + .ndo_change_mtu = eth_change_mtu, + .ndo_validate_addr = eth_validate_addr, +}; + /* This is the real probe routine. Linux has a history of friendly device probes on the ISA bus. A good device probes avoids doing writes, and verifies that the correct device exists and functions. @@ -843,17 +858,8 @@ cs89x0_probe1(struct net_device *dev, int ioaddr, int modular) /* print the ethernet address. */ printk(", MAC %pM", dev->dev_addr); - dev->open = net_open; - dev->stop = net_close; - dev->tx_timeout = net_timeout; - dev->watchdog_timeo = HZ; - dev->hard_start_xmit = net_send_packet; - dev->get_stats = net_get_stats; - dev->set_multicast_list = set_multicast_list; - dev->set_mac_address = set_mac_address; -#ifdef CONFIG_NET_POLL_CONTROLLER - dev->poll_controller = net_poll_controller; -#endif + dev->netdev_ops = &net_ops; + dev->watchdog_timeo = HZ; printk("\n"); if (net_debug) |
