summaryrefslogtreecommitdiffstats
diff options
context:
space:
mode:
-rw-r--r--Documentation/hwmon/zl610014
-rw-r--r--drivers/hwmon/pmbus/zl6100.c12
2 files changed, 9 insertions, 17 deletions
diff --git a/Documentation/hwmon/zl6100 b/Documentation/hwmon/zl6100
index 51f76a1..a4e8d90 100644
--- a/Documentation/hwmon/zl6100
+++ b/Documentation/hwmon/zl6100
@@ -88,14 +88,12 @@ Module parameters
delay
-----
-Some Intersil/Zilker Labs DC-DC controllers require a minimum interval between
-I2C bus accesses. According to Intersil, the minimum interval is 2 ms, though
-1 ms appears to be sufficient and has not caused any problems in testing.
-The problem is known to affect ZL6100, ZL2105, and ZL2008. It is known not to
-affect ZL2004 and ZL6105. The driver automatically sets the interval to 1 ms
-except for ZL2004 and ZL6105. To enable manual override, the driver provides a
-writeable module parameter, 'delay', which can be used to set the interval to
-a value between 0 and 65,535 microseconds.
+Intersil/Zilker Labs DC-DC controllers require a minimum interval between I2C
+bus accesses. According to Intersil, the minimum interval is 2 ms, though 1 ms
+appears to be sufficient and has not caused any problems in testing. The problem
+is known to affect all currently supported chips. For manual override, the
+driver provides a writeable module parameter, 'delay', which can be used to set
+the interval to a value between 0 and 65,535 microseconds.
Sysfs entries
diff --git a/drivers/hwmon/pmbus/zl6100.c b/drivers/hwmon/pmbus/zl6100.c
index 880b90c..e3e8420 100644
--- a/drivers/hwmon/pmbus/zl6100.c
+++ b/drivers/hwmon/pmbus/zl6100.c
@@ -200,17 +200,11 @@ static int zl6100_probe(struct i2c_client *client,
data->id = mid->driver_data;
/*
- * ZL2005, ZL2008, ZL2105, and ZL6100 are known to require a wait time
- * between I2C accesses. ZL2004 and ZL6105 are known to be safe.
- * Other chips have not yet been tested.
- *
- * Only clear the wait time for chips known to be safe. The wait time
- * can be cleared later for additional chips if tests show that it
- * is not needed (in other words, better be safe than sorry).
+ * According to information from the chip vendor, all currently
+ * supported chips are known to require a wait time between I2C
+ * accesses.
*/
data->delay = delay;
- if (data->id == zl2004 || data->id == zl6105)
- data->delay = 0;
/*
* Since there was a direct I2C device access above, wait before
OpenPOWER on IntegriCloud