diff options
| -rw-r--r-- | drivers/net/sky2.c | 32 | ||||
| -rw-r--r-- | drivers/net/sky2.h | 10 |
2 files changed, 21 insertions, 21 deletions
diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c index f5b101bf..92d69ff 100644 --- a/drivers/net/sky2.c +++ b/drivers/net/sky2.c @@ -214,7 +214,7 @@ static int sky2_set_power_state(struct sky2_hw *hw, pci_power_t state) pci_read_config_dword(hw->pdev, PCI_DEV_REG1, ®1); reg1 &= ~(PCI_Y2_PHY1_POWD | PCI_Y2_PHY2_POWD); - /* looks like this xl is back asswards .. */ + /* looks like this XL is back asswards .. */ if (hw->chip_id == CHIP_ID_YUKON_XL && hw->chip_rev > 1) { reg1 |= PCI_Y2_PHY1_COMA; if (hw->ports > 1) @@ -461,7 +461,7 @@ static void sky2_phy_init(struct sky2_hw *hw, unsigned port) if (ledover) gm_phy_write(hw, port, PHY_MARV_LED_OVER, ledover); - /* Enable phy interrupt on autonegotiation complete (or link up) */ + /* Enable phy interrupt on auto-negotiation complete (or link up) */ if (sky2->autoneg == AUTONEG_ENABLE) gm_phy_write(hw, port, PHY_MARV_INT_MASK, PHY_M_IS_AN_COMPL); else @@ -578,10 +578,10 @@ static void sky2_mac_init(struct sky2_hw *hw, unsigned port) sky2_write16(hw, SK_REG(port, RX_GMF_CTRL_T), GMF_RX_CTRL_DEF); - /* Flush Rx MAC FIFO on any flowcontrol or error */ + /* Flush Rx MAC FIFO on any flow control or error */ reg = GMR_FS_ANY_ERR; if (hw->chip_id == CHIP_ID_YUKON_XL && hw->chip_rev <= 1) - reg = 0; /* WA Dev #4115 */ + reg = 0; /* WA dev #4.115 */ sky2_write16(hw, SK_REG(port, RX_GMF_FL_MSK), reg); /* Set threshold to 0xa (64 bytes) @@ -662,7 +662,7 @@ static inline struct sky2_tx_le *get_tx_le(struct sky2_port *sky2) } /* - * This is a workaround code taken from syskonnect sk98lin driver + * This is a workaround code taken from SysKonnect sk98lin driver * to deal with chip bug on Yukon EC rev 0 in the wraparound case. */ static inline void sky2_put_idx(struct sky2_hw *hw, unsigned q, @@ -785,7 +785,7 @@ stopped: sky2_write32(hw, Y2_QADDR(rxq, PREF_UNIT_CTRL), PREF_UNIT_RST_SET); } -/* Cleanout receive buffer area, assumes receiver hardware stopped */ +/* Clean out receive buffer area, assumes receiver hardware stopped */ static void sky2_rx_clean(struct sky2_port *sky2) { unsigned i; @@ -1174,7 +1174,7 @@ out_unlock: * Free ring elements from starting at tx_cons until "done" * * NB: the hardware will tell us about partial completion of multi-part - * buffers; these are defered until completion. + * buffers; these are deferred until completion. */ static void sky2_tx_complete(struct sky2_port *sky2, u16 done) { @@ -1182,7 +1182,7 @@ static void sky2_tx_complete(struct sky2_port *sky2, u16 done) unsigned i; if (unlikely(netif_msg_tx_done(sky2))) - printk(KERN_DEBUG "%s: tx done, upto %u\n", + printk(KERN_DEBUG "%s: tx done, up to %u\n", dev->name, done); spin_lock(&sky2->tx_lock); @@ -1282,7 +1282,7 @@ static int sky2_down(struct net_device *dev) sky2_write8(hw, SK_REG(port, RX_GMF_CTRL_T), GMF_RST_SET); sky2_write8(hw, SK_REG(port, TX_GMF_CTRL_T), GMF_RST_SET); - /* turn off led's */ + /* turn off LED's */ sky2_write16(hw, B0_Y2LED, LED_STAT_OFF); sky2_tx_clean(sky2); @@ -1364,7 +1364,7 @@ static void sky2_link_up(struct sky2_port *sky2) if (netif_msg_link(sky2)) printk(KERN_INFO PFX - "%s: Link is up at %d Mbps, %s duplex, flowcontrol %s\n", + "%s: Link is up at %d Mbps, %s duplex, flow control %s\n", sky2->netdev->name, sky2->speed, sky2->duplex == DUPLEX_FULL ? "full" : "half", (sky2->tx_pause && sky2->rx_pause) ? "both" : @@ -1451,7 +1451,7 @@ static int sky2_autoneg_done(struct sky2_port *sky2, u16 aux) } /* - * Interrrupt from PHY are handled in tasklet (soft irq) + * Interrupt from PHY are handled in tasklet (soft irq) * because accessing phy registers requires spin wait which might * cause excess interrupt latency. */ @@ -1556,7 +1556,7 @@ static int sky2_change_mtu(struct net_device *dev, int new_mtu) /* * Receive one packet. * For small packets or errors, just reuse existing skb. - * For larger pakects, get new buffer. + * For larger packets, get new buffer. */ static struct sk_buff *sky2_receive(struct sky2_port *sky2, u16 length, u32 status) @@ -1818,7 +1818,7 @@ static void sky2_hw_intr(struct sky2_hw *hw) } if (status & Y2_IS_PCI_EXP) { - /* PCI-Express uncorrectable Error occured */ + /* PCI-Express uncorrectable Error occurred */ u32 pex_err; pci_read_config_dword(hw->pdev, PEX_UNC_ERR_STAT, &pex_err); @@ -2113,7 +2113,7 @@ static int sky2_reset(struct sky2_hw *hw) if (hw->chip_id == CHIP_ID_YUKON_XL && hw->chip_rev == 0) sky2_write8(hw, STAT_FIFO_ISR_WM, 0x10); - else /* WA 4109 */ + else /* WA dev 4.109 */ sky2_write8(hw, STAT_FIFO_ISR_WM, 0x04); sky2_write32(hw, STAT_ISR_TIMER_INI, 0x0190); @@ -2420,7 +2420,7 @@ static void sky2_set_multicast(struct net_device *dev) reg = gma_read16(hw, port, GM_RX_CTRL); reg |= GM_RXCR_UCF_ENA; - if (dev->flags & IFF_PROMISC) /* promiscious */ + if (dev->flags & IFF_PROMISC) /* promiscuous */ reg &= ~(GM_RXCR_UCF_ENA | GM_RXCR_MCF_ENA); else if ((dev->flags & IFF_ALLMULTI) || dev->mc_count > 16) /* all multicast */ memset(filter, 0xff, sizeof(filter)); @@ -2833,7 +2833,7 @@ static int __devinit sky2_probe(struct pci_dev *pdev, } } #ifdef __BIG_ENDIAN - /* byte swap decriptors in hardware */ + /* byte swap descriptors in hardware */ { u32 reg; diff --git a/drivers/net/sky2.h b/drivers/net/sky2.h index c15d464..629d08f 100644 --- a/drivers/net/sky2.h +++ b/drivers/net/sky2.h @@ -356,11 +356,11 @@ enum { /* B2_Y2_CLK_GATE 8 bit Clock Gating (Yukon-2 only) */ enum { - Y2_STATUS_LNK2_INAC = 1<<7, /* Status Link 2 inactiv (0 = activ) */ + Y2_STATUS_LNK2_INAC = 1<<7, /* Status Link 2 inactive (0 = active) */ Y2_CLK_GAT_LNK2_DIS = 1<<6, /* Disable clock gating Link 2 */ Y2_COR_CLK_LNK2_DIS = 1<<5, /* Disable Core clock Link 2 */ Y2_PCI_CLK_LNK2_DIS = 1<<4, /* Disable PCI clock Link 2 */ - Y2_STATUS_LNK1_INAC = 1<<3, /* Status Link 1 inactiv (0 = activ) */ + Y2_STATUS_LNK1_INAC = 1<<3, /* Status Link 1 inactive (0 = active) */ Y2_CLK_GAT_LNK1_DIS = 1<<2, /* Disable clock gating Link 1 */ Y2_COR_CLK_LNK1_DIS = 1<<1, /* Disable Core clock Link 1 */ Y2_PCI_CLK_LNK1_DIS = 1<<0, /* Disable PCI clock Link 1 */ @@ -410,7 +410,7 @@ enum { #define RAM_ADR_RAN 0x0007ffffL /* Bit 18.. 0: RAM Address Range */ /* RAM Interface Registers */ -/* B3_RI_CTRL 16 bit RAM Iface Control Register */ +/* B3_RI_CTRL 16 bit RAM Interface Control Register */ enum { RI_CLR_RD_PERR = 1<<9, /* Clear IRQ RAM Read Parity Err */ RI_CLR_WR_PERR = 1<<8, /* Clear IRQ RAM Write Parity Err*/ @@ -613,7 +613,7 @@ enum { BMU_ENA_RX_CHKSUM = 1<<13, /* Enable Rx TCP/IP Checksum Check */ BMU_DIS_RX_CHKSUM = 1<<12, /* Disable Rx TCP/IP Checksum Check */ BMU_CLR_IRQ_PAR = 1<<11, /* Clear IRQ on Parity errors (Rx) */ - BMU_CLR_IRQ_TCP = 1<<11, /* Clear IRQ on TCP segmen. error (Tx) */ + BMU_CLR_IRQ_TCP = 1<<11, /* Clear IRQ on TCP segment. error (Tx) */ BMU_CLR_IRQ_CHK = 1<<10, /* Clear IRQ Check */ BMU_STOP = 1<<9, /* Stop Rx/Tx Queue */ BMU_START = 1<<8, /* Start Rx/Tx Queue */ @@ -636,7 +636,7 @@ enum { enum { BMU_TX_IPIDINCR_ON = 1<<13, /* Enable IP ID Increment */ BMU_TX_IPIDINCR_OFF = 1<<12, /* Disable IP ID Increment */ - BMU_TX_CLR_IRQ_TCP = 1<<11, /* Clear IRQ on TCP segm. length mism. */ + BMU_TX_CLR_IRQ_TCP = 1<<11, /* Clear IRQ on TCP segment length mismatch */ }; /* Queue Prefetch Unit Offsets, use Y2_QADDR() to address (Yukon-2 only)*/ |
