powerpc: Move include files to arch/powerpc/include/asm

from include/asm-powerpc.  This is the result of a

mkdir arch/powerpc/include/asm
git mv include/asm-powerpc/* arch/powerpc/include/asm

Followed by a few documentation/comment fixups and a couple of places
where <asm-powepc/...> was being used explicitly.  Of the latter only
one was outside the arch code and it is a driver only built for powerpc.

Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: Paul Mackerras <paulus@samba.org>

1 files changed, 0 insertions, 108 deletions

diff --git a/include/asm-powerpc/dbdma.h b/include/asm-powerpc/dbdma.h
deleted file mode 100644
index e23f07e..0000000
--- a/include/asm-powerpc/dbdma.h
+++ /dev/null
@@ -1,108 +0,0 @@
-/*
- * Definitions for using the Apple Descriptor-Based DMA controller
- * in Power Macintosh computers.
- *
- * Copyright (C) 1996 Paul Mackerras.
- */
-
-#ifdef __KERNEL__
-#ifndef _ASM_DBDMA_H_
-#define _ASM_DBDMA_H_
-/*
- * DBDMA control/status registers.  All little-endian.
- */
-struct dbdma_regs {
-    unsigned int control;	/* lets you change bits in status */
-    unsigned int status;	/* DMA and device status bits (see below) */
-    unsigned int cmdptr_hi;	/* upper 32 bits of command address */
-    unsigned int cmdptr;	/* (lower 32 bits of) command address (phys) */
-    unsigned int intr_sel;	/* select interrupt condition bit */
-    unsigned int br_sel;	/* select branch condition bit */
-    unsigned int wait_sel;	/* select wait condition bit */
-    unsigned int xfer_mode;
-    unsigned int data2ptr_hi;
-    unsigned int data2ptr;
-    unsigned int res1;
-    unsigned int address_hi;
-    unsigned int br_addr_hi;
-    unsigned int res2[3];
-};
-
-/* Bits in control and status registers */
-#define RUN	0x8000
-#define PAUSE	0x4000
-#define FLUSH	0x2000
-#define WAKE	0x1000
-#define DEAD	0x0800
-#define ACTIVE	0x0400
-#define BT	0x0100
-#define DEVSTAT	0x00ff
-
-/*
- * DBDMA command structure.  These fields are all little-endian!
- */
-struct dbdma_cmd {
-    unsigned short req_count;	/* requested byte transfer count */
-    unsigned short command;	/* command word (has bit-fields) */
-    unsigned int   phy_addr;	/* physical data address */
-    unsigned int   cmd_dep;	/* command-dependent field */
-    unsigned short res_count;	/* residual count after completion */
-    unsigned short xfer_status;	/* transfer status */
-};
-
-/* DBDMA command values in command field */
-#define OUTPUT_MORE	0	/* transfer memory data to stream */
-#define OUTPUT_LAST	0x1000	/* ditto followed by end marker */
-#define INPUT_MORE	0x2000	/* transfer stream data to memory */
-#define INPUT_LAST	0x3000	/* ditto, expect end marker */
-#define STORE_WORD	0x4000	/* write word (4 bytes) to device reg */
-#define LOAD_WORD	0x5000	/* read word (4 bytes) from device reg */
-#define DBDMA_NOP	0x6000	/* do nothing */
-#define DBDMA_STOP	0x7000	/* suspend processing */
-
-/* Key values in command field */
-#define KEY_STREAM0	0	/* usual data stream */
-#define KEY_STREAM1	0x100	/* control/status stream */
-#define KEY_STREAM2	0x200	/* device-dependent stream */
-#define KEY_STREAM3	0x300	/* device-dependent stream */
-#define KEY_REGS	0x500	/* device register space */
-#define KEY_SYSTEM	0x600	/* system memory-mapped space */
-#define KEY_DEVICE	0x700	/* device memory-mapped space */
-
-/* Interrupt control values in command field */
-#define INTR_NEVER	0	/* don't interrupt */
-#define INTR_IFSET	0x10	/* intr if condition bit is 1 */
-#define INTR_IFCLR	0x20	/* intr if condition bit is 0 */
-#define INTR_ALWAYS	0x30	/* always interrupt */
-
-/* Branch control values in command field */
-#define BR_NEVER	0	/* don't branch */
-#define BR_IFSET	0x4	/* branch if condition bit is 1 */
-#define BR_IFCLR	0x8	/* branch if condition bit is 0 */
-#define BR_ALWAYS	0xc	/* always branch */
-
-/* Wait control values in command field */
-#define WAIT_NEVER	0	/* don't wait */
-#define WAIT_IFSET	1	/* wait if condition bit is 1 */
-#define WAIT_IFCLR	2	/* wait if condition bit is 0 */
-#define WAIT_ALWAYS	3	/* always wait */
-
-/* Align an address for a DBDMA command structure */
-#define DBDMA_ALIGN(x)	(((unsigned long)(x) + sizeof(struct dbdma_cmd) - 1) \
-			 & -sizeof(struct dbdma_cmd))
-
-/* Useful macros */
-#define DBDMA_DO_STOP(regs) do {				\
-	out_le32(&((regs)->control), (RUN|FLUSH)<<16);		\
-	while(in_le32(&((regs)->status)) & (ACTIVE|FLUSH))	\
-		; \
-} while(0)
-
-#define DBDMA_DO_RESET(regs) do {				\
-	out_le32(&((regs)->control), (ACTIVE|DEAD|WAKE|FLUSH|PAUSE|RUN)<<16);\
-	while(in_le32(&((regs)->status)) & (RUN)) \
-		; \
-} while(0)
-
-#endif /* _ASM_DBDMA_H_ */
-#endif /* __KERNEL__ */