video: exynos_dp: add analog and pll control setting

This patch adds analog and pll control setting. This control setting
is used for DP TX PHY block to set the values as below. It is beneficial
to improve analog characteristics.
 - TX terminal registor is 50 Ohm.
 - Reference clock of PHY is 24 MHz.
 - Power source for TX digital logic is 1.0625 V.
 - Power source for internal clock driver is 1.0625 V.
 - PLL VCO range setting is 600 uA.
 - Power down ring osc is turned off.
 - AUX terminal resistor is 50 Ohm.
 - AUX channel current is 8 mA and multiplied by 2.
 - TX channel output amplitude is 400 mV.

Signed-off-by: Jingoo Han <jg1.han@samsung.com>
Signed-off-by: Florian Tobias Schandinat <FlorianSchandinat@gmx.de>

1 files changed, 23 insertions, 0 deletions

diff --git a/drivers/video/exynos/exynos_dp_reg.c b/drivers/video/exynos/exynos_dp_reg.c
index 169d181..3863726 100644
--- a/drivers/video/exynos/exynos_dp_reg.c
+++ b/drivers/video/exynos/exynos_dp_reg.c
@@ -65,6 +65,28 @@ void exynos_dp_lane_swap(struct exynos_dp_device *dp, bool enable)
 	writel(reg, dp->reg_base + EXYNOS_DP_LANE_MAP);
 }
 
+void exynos_dp_init_analog_param(struct exynos_dp_device *dp)
+{
+	u32 reg;
+
+	reg = TX_TERMINAL_CTRL_50_OHM;
+	writel(reg, dp->reg_base + EXYNOS_DP_ANALOG_CTL_1);
+
+	reg = SEL_24M | TX_DVDD_BIT_1_0625V;
+	writel(reg, dp->reg_base + EXYNOS_DP_ANALOG_CTL_2);
+
+	reg = DRIVE_DVDD_BIT_1_0625V | VCO_BIT_600_MICRO;
+	writel(reg, dp->reg_base + EXYNOS_DP_ANALOG_CTL_3);
+
+	reg = PD_RING_OSC | AUX_TERMINAL_CTRL_50_OHM |
+		TX_CUR1_2X | TX_CUR_8_MA;
+	writel(reg, dp->reg_base + EXYNOS_DP_PLL_FILTER_CTL_1);
+
+	reg = CH3_AMP_400_MV | CH2_AMP_400_MV |
+		CH1_AMP_400_MV | CH0_AMP_400_MV;
+	writel(reg, dp->reg_base + EXYNOS_DP_TX_AMP_TUNING_CTL);
+}
+
 void exynos_dp_init_interrupt(struct exynos_dp_device *dp)
 {
 	/* Set interrupt pin assertion polarity as high */
@@ -131,6 +153,7 @@ void exynos_dp_reset(struct exynos_dp_device *dp)
 
 	writel(0x00000101, dp->reg_base + EXYNOS_DP_SOC_GENERAL_CTL);
 
+	exynos_dp_init_analog_param(dp);
 	exynos_dp_init_interrupt(dp);
 }