Merge tag 'scsi-misc' of git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi

Pull SCSI updates from James Bottomley:
 "This is the usual grab bag of driver updates (lpfc, hpsa,
  megaraid_sas, cxgbi, be2iscsi) plus an assortment of minor updates.

  There is also one new driver: the Cisco snic.  The advansys driver has
  been rewritten to get rid of the warning about converting it to the
  DMA API, the tape statistics patch got in and finally, there's a
  resuffle of SCSI header files to separate more cleanly initiator from
  target mode (and better share the common definitions)"

* tag 'scsi-misc' of git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi: (156 commits)
  snic: driver for Cisco SCSI HBA
  qla2xxx: Fix indentation
  qla2xxx: Comment out unreachable code
  fusion: remove dead MTRR code
  advansys: fix compilation errors and warnings when CONFIG_PCI is not set
  mptsas: fix depth param in scsi_track_queue_full
  megaraid: fix irq setup process regression
  lpfc: Update version to 10.7.0.0 for upstream patch set.
  lpfc: Fix to drop PLOGIs from fabric node till LOGO processing completes
  lpfc: Fix scsi task management error message.
  lpfc: Fix cq_id masking problem.
  lpfc: Fix scsi prep dma buf error.
  lpfc: Add support for using block multi-queue
  lpfc: Devices are not discovered during takeaway/giveback testing
  lpfc: Fix vport deletion failure.
  lpfc: Check for active portpeerbeacon.
  lpfc: Update driver version for upstream patch set 10.6.0.1.
  lpfc: Change buffer pool empty message to miscellaneous category
  lpfc: Fix incorrect log message reported for empty FCF record.
  lpfc: Fix rport leak.
  ...

1 files changed, 31 insertions, 3 deletions

diff --git a/drivers/scsi/hpsa_cmd.h b/drivers/scsi/hpsa_cmd.h
index 3a621c7..c601622 100644
--- a/drivers/scsi/hpsa_cmd.h
+++ b/drivers/scsi/hpsa_cmd.h
@@ -42,8 +42,22 @@
 #define CMD_UNSOLICITED_ABORT   0x000A
 #define CMD_TIMEOUT             0x000B
 #define CMD_UNABORTABLE		0x000C
+#define CMD_TMF_STATUS		0x000D
 #define CMD_IOACCEL_DISABLED	0x000E
+#define CMD_CTLR_LOCKUP		0xffff
+/* Note: CMD_CTLR_LOCKUP is not a value defined by the CISS spec
+ * it is a value defined by the driver that commands can be marked
+ * with when a controller lockup has been detected by the driver
+ */
 
+/* TMF function status values */
+#define CISS_TMF_COMPLETE	0x00
+#define CISS_TMF_INVALID_FRAME	0x02
+#define CISS_TMF_NOT_SUPPORTED	0x04
+#define CISS_TMF_FAILED		0x05
+#define CISS_TMF_SUCCESS	0x08
+#define CISS_TMF_WRONG_LUN	0x09
+#define CISS_TMF_OVERLAPPED_TAG 0x0a
 
 /* Unit Attentions ASC's as defined for the MSA2012sa */
 #define POWER_OR_RESET			0x29
@@ -240,6 +254,7 @@ struct ReportLUNdata {
 
 struct ext_report_lun_entry {
 	u8 lunid[8];
+#define MASKED_DEVICE(x) ((x)[3] & 0xC0)
 #define GET_BMIC_BUS(lunid) ((lunid)[7] & 0x3F)
 #define GET_BMIC_LEVEL_TWO_TARGET(lunid) ((lunid)[6])
 #define GET_BMIC_DRIVE_NUMBER(lunid) (((GET_BMIC_BUS((lunid)) - 1) << 8) + \
@@ -247,6 +262,8 @@ struct ext_report_lun_entry {
 	u8 wwid[8];
 	u8 device_type;
 	u8 device_flags;
+#define NON_DISK_PHYS_DEV(x) ((x)[17] & 0x01)
+#define PHYS_IOACCEL(x) ((x)[17] & 0x08)
 	u8 lun_count; /* multi-lun device, how many luns */
 	u8 redundant_paths;
 	u32 ioaccel_handle; /* ioaccel1 only uses lower 16 bits */
@@ -379,6 +396,7 @@ struct ErrorInfo {
 #define CMD_SCSI	0x03
 #define CMD_IOACCEL1	0x04
 #define CMD_IOACCEL2	0x05
+#define IOACCEL2_TMF	0x06
 
 #define DIRECT_LOOKUP_SHIFT 4
 #define DIRECT_LOOKUP_MASK (~((1 << DIRECT_LOOKUP_SHIFT) - 1))
@@ -421,7 +439,10 @@ struct CommandList {
 	 * not used.
 	 */
 	struct hpsa_scsi_dev_t *phys_disk;
-	atomic_t refcount; /* Must be last to avoid memset in cmd_alloc */
+
+	int abort_pending;
+	struct hpsa_scsi_dev_t *reset_pending;
+	atomic_t refcount; /* Must be last to avoid memset in hpsa_cmd_init() */
 } __aligned(COMMANDLIST_ALIGNMENT);
 
 /* Max S/G elements in I/O accelerator command */
@@ -515,6 +536,12 @@ struct io_accel2_scsi_response {
 #define IOACCEL2_STATUS_SR_TASK_COMP_SET_FULL	0x28
 #define IOACCEL2_STATUS_SR_TASK_COMP_ABORTED	0x40
 #define IOACCEL2_STATUS_SR_IOACCEL_DISABLED	0x0E
+#define IOACCEL2_STATUS_SR_IO_ERROR		0x01
+#define IOACCEL2_STATUS_SR_IO_ABORTED		0x02
+#define IOACCEL2_STATUS_SR_NO_PATH_TO_DEVICE	0x03
+#define IOACCEL2_STATUS_SR_INVALID_DEVICE	0x04
+#define IOACCEL2_STATUS_SR_UNDERRUN		0x51
+#define IOACCEL2_STATUS_SR_OVERRUN		0x75
 	u8 data_present;		/* low 2 bits */
 #define IOACCEL2_NO_DATAPRESENT		0x000
 #define IOACCEL2_RESPONSE_DATAPRESENT	0x001
@@ -567,6 +594,7 @@ struct io_accel2_cmd {
 #define IOACCEL2_DIR_NO_DATA	0x00
 #define IOACCEL2_DIR_DATA_IN	0x01
 #define IOACCEL2_DIR_DATA_OUT	0x02
+#define IOACCEL2_TMF_ABORT	0x01
 /*
  * SCSI Task Management Request format for Accelerator Mode 2
  */
@@ -575,13 +603,13 @@ struct hpsa_tmf_struct {
 	u8 reply_queue;		/* Reply Queue ID */
 	u8 tmf;			/* Task Management Function */
 	u8 reserved1;		/* byte 3 Reserved */
-	u32 it_nexus;		/* SCSI I-T Nexus */
+	__le32 it_nexus;	/* SCSI I-T Nexus */
 	u8 lun_id[8];		/* LUN ID for TMF request */
 	__le64 tag;		/* cciss tag associated w/ request */
 	__le64 abort_tag;	/* cciss tag of SCSI cmd or TMF to abort */
 	__le64 error_ptr;		/* Error Pointer */
 	__le32 error_len;		/* Error Length */
-};
+} __aligned(IOACCEL2_COMMANDLIST_ALIGNMENT);
 
 /* Configuration Table Structure */
 struct HostWrite {