mac80211: remove support for IFF_PROMISC

This support is essentially useless as typically networks are encrypted,
frames will be filtered by hardware, and rate scaling will be done with
the intended recipient in mind. For real monitoring of the network, the
monitor mode support should be used instead.

Removing it removes a lot of corner cases.

Signed-off-by: Johannes Berg <johannes.berg@intel.com>

10 files changed, 11 insertions, 42 deletions

diff --git a/drivers/net/wireless/ath/ar5523/ar5523.c b/drivers/net/wireless/ath/ar5523/ar5523.c
index 5147ebe..14937cb 100644
--- a/drivers/net/wireless/ath/ar5523/ar5523.c
+++ b/drivers/net/wireless/ath/ar5523/ar5523.c
@@ -1319,8 +1319,7 @@ out_unlock:
 
 }
 
-#define AR5523_SUPPORTED_FILTERS (FIF_PROMISC_IN_BSS | \
-				  FIF_ALLMULTI | \
+#define AR5523_SUPPORTED_FILTERS (FIF_ALLMULTI | \
 				  FIF_FCSFAIL | \
 				  FIF_OTHER_BSS)
 
diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c
index 4120fe5..fcd08b2 100644
--- a/drivers/net/wireless/ath/ath10k/mac.c
+++ b/drivers/net/wireless/ath/ath10k/mac.c
@@ -773,7 +773,6 @@ static int ath10k_monitor_recalc(struct ath10k *ar)
 	lockdep_assert_held(&ar->conf_mutex);
 
 	should_start = ar->monitor ||
-		       ar->filter_flags & FIF_PROMISC_IN_BSS ||
 		       test_bit(ATH10K_CAC_RUNNING, &ar->dev_flags);
 
 	ath10k_dbg(ar, ATH10K_DBG_MAC,
@@ -3493,8 +3492,7 @@ static void ath10k_remove_interface(struct ieee80211_hw *hw,
  * FIXME: Has to be verified.
  */
 #define SUPPORTED_FILTERS			\
-	(FIF_PROMISC_IN_BSS |			\
-	FIF_ALLMULTI |				\
+	(FIF_ALLMULTI |				\
 	FIF_CONTROL |				\
 	FIF_PSPOLL |				\
 	FIF_OTHER_BSS |				\
diff --git a/drivers/net/wireless/ath/ath5k/ath5k.h b/drivers/net/wireless/ath/ath5k/ath5k.h
index 7ca0d6f93..e22b0e7 100644
--- a/drivers/net/wireless/ath/ath5k/ath5k.h
+++ b/drivers/net/wireless/ath/ath5k/ath5k.h
@@ -1280,7 +1280,6 @@ struct ath5k_hw {
 
 	DECLARE_BITMAP(status, 4);
 #define ATH_STAT_INVALID	0		/* disable hardware accesses */
-#define ATH_STAT_PROMISC	1
 #define ATH_STAT_LEDSOFT	2		/* enable LED gpio status */
 #define ATH_STAT_STARTED	3		/* opened & irqs enabled */
 #define ATH_STAT_RESET		4		/* hw reset */
diff --git a/drivers/net/wireless/ath/ath5k/mac80211-ops.c b/drivers/net/wireless/ath/ath5k/mac80211-ops.c
index 3b4a646..0210630 100644
--- a/drivers/net/wireless/ath/ath5k/mac80211-ops.c
+++ b/drivers/net/wireless/ath/ath5k/mac80211-ops.c
@@ -369,7 +369,7 @@ ath5k_configure_filter(struct ieee80211_hw *hw, unsigned int changed_flags,
 		       unsigned int *new_flags, u64 multicast)
 {
 #define SUPPORTED_FIF_FLAGS \
-	(FIF_PROMISC_IN_BSS |  FIF_ALLMULTI | FIF_FCSFAIL | \
+	(FIF_ALLMULTI | FIF_FCSFAIL | \
 	FIF_PLCPFAIL | FIF_CONTROL | FIF_OTHER_BSS | \
 	FIF_BCN_PRBRESP_PROMISC)
 
@@ -393,16 +393,6 @@ ath5k_configure_filter(struct ieee80211_hw *hw, unsigned int changed_flags,
 		(AR5K_RX_FILTER_UCAST | AR5K_RX_FILTER_BCAST |
 		AR5K_RX_FILTER_MCAST);
 
-	if (changed_flags & (FIF_PROMISC_IN_BSS | FIF_OTHER_BSS)) {
-		if (*new_flags & FIF_PROMISC_IN_BSS)
-			__set_bit(ATH_STAT_PROMISC, ah->status);
-		else
-			__clear_bit(ATH_STAT_PROMISC, ah->status);
-	}
-
-	if (test_bit(ATH_STAT_PROMISC, ah->status))
-		rfilt |= AR5K_RX_FILTER_PROM;
-
 	/* Note, AR5K_RX_FILTER_MCAST is already enabled */
 	if (*new_flags & FIF_ALLMULTI) {
 		mfilt[0] =  ~0;
@@ -418,8 +408,7 @@ ath5k_configure_filter(struct ieee80211_hw *hw, unsigned int changed_flags,
 	if ((*new_flags & FIF_BCN_PRBRESP_PROMISC) || (ah->nvifs > 1))
 		rfilt |= AR5K_RX_FILTER_BEACON;
 
-	/* FIF_CONTROL doc says that if FIF_PROMISC_IN_BSS is not
-	 * set we should only pass on control frames for this
+	/* FIF_CONTROL doc says we should only pass on control frames for this
 	 * station. This needs testing. I believe right now this
 	 * enables *all* control frames, which is OK.. but
 	 * but we should see if we can improve on granularity */
diff --git a/drivers/net/wireless/ath/ath9k/htc_drv_main.c b/drivers/net/wireless/ath/ath9k/htc_drv_main.c
index 564923c..b71f307 100644
--- a/drivers/net/wireless/ath/ath9k/htc_drv_main.c
+++ b/drivers/net/wireless/ath/ath9k/htc_drv_main.c
@@ -1238,8 +1238,7 @@ out:
 }
 
 #define SUPPORTED_FILTERS			\
-	(FIF_PROMISC_IN_BSS |			\
-	FIF_ALLMULTI |				\
+	(FIF_ALLMULTI |				\
 	FIF_CONTROL |				\
 	FIF_PSPOLL |				\
 	FIF_OTHER_BSS |				\
diff --git a/drivers/net/wireless/ath/ath9k/htc_drv_txrx.c b/drivers/net/wireless/ath/ath9k/htc_drv_txrx.c
index a0f58e2..cc9648f 100644
--- a/drivers/net/wireless/ath/ath9k/htc_drv_txrx.c
+++ b/drivers/net/wireless/ath/ath9k/htc_drv_txrx.c
@@ -872,14 +872,7 @@ u32 ath9k_htc_calcrxfilter(struct ath9k_htc_priv *priv)
 	if (priv->rxfilter & FIF_PROBE_REQ)
 		rfilt |= ATH9K_RX_FILTER_PROBEREQ;
 
-	/*
-	 * Set promiscuous mode when FIF_PROMISC_IN_BSS is enabled for station
-	 * mode interface or when in monitor mode. AP mode does not need this
-	 * since it receives all in-BSS frames anyway.
-	 */
-	if (((ah->opmode != NL80211_IFTYPE_AP) &&
-	     (priv->rxfilter & FIF_PROMISC_IN_BSS)) ||
-	    ah->is_monitoring)
+	if (ah->is_monitoring)
 		rfilt |= ATH9K_RX_FILTER_PROM;
 
 	if (priv->rxfilter & FIF_CONTROL)
diff --git a/drivers/net/wireless/ath/ath9k/main.c b/drivers/net/wireless/ath/ath9k/main.c
index b0badef..d285e3a 100644
--- a/drivers/net/wireless/ath/ath9k/main.c
+++ b/drivers/net/wireless/ath/ath9k/main.c
@@ -1442,8 +1442,7 @@ static int ath9k_config(struct ieee80211_hw *hw, u32 changed)
 }
 
 #define SUPPORTED_FILTERS			\
-	(FIF_PROMISC_IN_BSS |			\
-	FIF_ALLMULTI |				\
+	(FIF_ALLMULTI |				\
 	FIF_CONTROL |				\
 	FIF_PSPOLL |				\
 	FIF_OTHER_BSS |				\
diff --git a/drivers/net/wireless/ath/ath9k/recv.c b/drivers/net/wireless/ath/ath9k/recv.c
index 6fb40ef..6c75fb1 100644
--- a/drivers/net/wireless/ath/ath9k/recv.c
+++ b/drivers/net/wireless/ath/ath9k/recv.c
@@ -392,11 +392,6 @@ u32 ath_calcrxfilter(struct ath_softc *sc)
 	if (sc->cur_chan->rxfilter & FIF_PROBE_REQ)
 		rfilt |= ATH9K_RX_FILTER_PROBEREQ;
 
-	/*
-	 * Set promiscuous mode when FIF_PROMISC_IN_BSS is enabled for station
-	 * mode interface or when in monitor mode. AP mode does not need this
-	 * since it receives all in-BSS frames anyway.
-	 */
 	if (sc->sc_ah->is_monitoring)
 		rfilt |= ATH9K_RX_FILTER_PROM;
 
diff --git a/drivers/net/wireless/ath/carl9170/fw.c b/drivers/net/wireless/ath/carl9170/fw.c
index 47d5c2e..020cd46 100644
--- a/drivers/net/wireless/ath/carl9170/fw.c
+++ b/drivers/net/wireless/ath/carl9170/fw.c
@@ -310,8 +310,7 @@ static int carl9170_fw(struct ar9170 *ar, const __u8 *data, size_t len)
 	if (SUPP(CARL9170FW_RX_FILTER)) {
 		ar->fw.rx_filter = true;
 		ar->rx_filter_caps = FIF_FCSFAIL | FIF_PLCPFAIL |
-			FIF_CONTROL | FIF_PSPOLL | FIF_OTHER_BSS |
-			FIF_PROMISC_IN_BSS;
+			FIF_CONTROL | FIF_PSPOLL | FIF_OTHER_BSS;
 	}
 
 	if (SUPP(CARL9170FW_HW_COUNTERS))
diff --git a/drivers/net/wireless/ath/carl9170/main.c b/drivers/net/wireless/ath/carl9170/main.c
index f1455a0..59db673 100644
--- a/drivers/net/wireless/ath/carl9170/main.c
+++ b/drivers/net/wireless/ath/carl9170/main.c
@@ -1011,9 +1011,8 @@ static void carl9170_op_configure_filter(struct ieee80211_hw *hw,
 	if (multicast != ar->cur_mc_hash)
 		WARN_ON(carl9170_update_multicast(ar, multicast));
 
-	if (changed_flags & (FIF_OTHER_BSS | FIF_PROMISC_IN_BSS)) {
-		ar->sniffer_enabled = !!(*new_flags &
-			(FIF_OTHER_BSS | FIF_PROMISC_IN_BSS));
+	if (changed_flags & FIF_OTHER_BSS) {
+		ar->sniffer_enabled = !!(*new_flags & FIF_OTHER_BSS);
 
 		WARN_ON(carl9170_set_operating_mode(ar));
 	}
@@ -1033,7 +1032,7 @@ static void carl9170_op_configure_filter(struct ieee80211_hw *hw,
 		if (!(*new_flags & FIF_PSPOLL))
 			rx_filter |= CARL9170_RX_FILTER_CTL_PSPOLL;
 
-		if (!(*new_flags & (FIF_OTHER_BSS | FIF_PROMISC_IN_BSS))) {
+		if (!(*new_flags & FIF_OTHER_BSS)) {
 			rx_filter |= CARL9170_RX_FILTER_OTHER_RA;
 			rx_filter |= CARL9170_RX_FILTER_DECRY_FAIL;
 		}