stmmac: remove dead code for STMMAC_TIMER support

The TIMER option is not longer supported and this
code can be considered dead for this driver in
the new kernel series.
In fact, It was not updated at all and never used.

Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 3 insertions, 98 deletions

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index c6cdbc4..777234c 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -115,16 +115,6 @@ static int tc = TC_DEFAULT;
 module_param(tc, int, S_IRUGO | S_IWUSR);
 MODULE_PARM_DESC(tc, "DMA threshold control value");
 
-/* Pay attention to tune this parameter; take care of both
- * hardware capability and network stabitily/performance impact.
- * Many tests showed that ~4ms latency seems to be good enough. */
-#ifdef CONFIG_STMMAC_TIMER
-#define DEFAULT_PERIODIC_RATE	256
-static int tmrate = DEFAULT_PERIODIC_RATE;
-module_param(tmrate, int, S_IRUGO | S_IWUSR);
-MODULE_PARM_DESC(tmrate, "External timer freq. (default: 256Hz)");
-#endif
-
 #define DMA_BUFFER_SIZE	BUF_SIZE_2KiB
 static int buf_sz = DMA_BUFFER_SIZE;
 module_param(buf_sz, int, S_IRUGO | S_IWUSR);
@@ -536,12 +526,6 @@ static void init_dma_desc_rings(struct net_device *dev)
 	else
 		bfsize = stmmac_set_bfsize(dev->mtu, priv->dma_buf_sz);
 
-#ifdef CONFIG_STMMAC_TIMER
-	/* Disable interrupts on completion for the reception if timer is on */
-	if (likely(priv->tm->enable))
-		dis_ic = 1;
-#endif
-
 	DBG(probe, INFO, "stmmac: txsize %d, rxsize %d, bfsize %d\n",
 	    txsize, rxsize, bfsize);
 
@@ -775,22 +759,12 @@ static void stmmac_tx(struct stmmac_priv *priv)
 
 static inline void stmmac_enable_irq(struct stmmac_priv *priv)
 {
-#ifdef CONFIG_STMMAC_TIMER
-	if (likely(priv->tm->enable))
-		priv->tm->timer_start(tmrate);
-	else
-#endif
-		priv->hw->dma->enable_dma_irq(priv->ioaddr);
+	priv->hw->dma->enable_dma_irq(priv->ioaddr);
 }
 
 static inline void stmmac_disable_irq(struct stmmac_priv *priv)
 {
-#ifdef CONFIG_STMMAC_TIMER
-	if (likely(priv->tm->enable))
-		priv->tm->timer_stop();
-	else
-#endif
-		priv->hw->dma->disable_dma_irq(priv->ioaddr);
+	priv->hw->dma->disable_dma_irq(priv->ioaddr);
 }
 
 static int stmmac_has_work(struct stmmac_priv *priv)
@@ -818,25 +792,6 @@ static inline void _stmmac_schedule(struct stmmac_priv *priv)
 	}
 }
 
-#ifdef CONFIG_STMMAC_TIMER
-void stmmac_schedule(struct net_device *dev)
-{
-	struct stmmac_priv *priv = netdev_priv(dev);
-
-	priv->xstats.sched_timer_n++;
-
-	_stmmac_schedule(priv);
-}
-
-static void stmmac_no_timer_started(unsigned int x)
-{;
-};
-
-static void stmmac_no_timer_stopped(void)
-{;
-};
-#endif
-
 /**
  * stmmac_tx_err:
  * @priv: pointer to the private device structure
@@ -1038,23 +993,6 @@ static int stmmac_open(struct net_device *dev)
 	struct stmmac_priv *priv = netdev_priv(dev);
 	int ret;
 
-#ifdef CONFIG_STMMAC_TIMER
-	priv->tm = kzalloc(sizeof(struct stmmac_timer *), GFP_KERNEL);
-	if (unlikely(priv->tm == NULL))
-		return -ENOMEM;
-
-	priv->tm->freq = tmrate;
-
-	/* Test if the external timer can be actually used.
-	 * In case of failure continue without timer. */
-	if (unlikely((stmmac_open_ext_timer(dev, priv->tm)) < 0)) {
-		pr_warning("stmmaceth: cannot attach the external timer.\n");
-		priv->tm->freq = 0;
-		priv->tm->timer_start = stmmac_no_timer_started;
-		priv->tm->timer_stop = stmmac_no_timer_stopped;
-	} else
-		priv->tm->enable = 1;
-#endif
 	clk_prepare_enable(priv->stmmac_clk);
 
 	stmmac_check_ether_addr(priv);
@@ -1141,10 +1079,6 @@ static int stmmac_open(struct net_device *dev)
 	priv->hw->dma->start_tx(priv->ioaddr);
 	priv->hw->dma->start_rx(priv->ioaddr);
 
-#ifdef CONFIG_STMMAC_TIMER
-	priv->tm->timer_start(tmrate);
-#endif
-
 	/* Dump DMA/MAC registers */
 	if (netif_msg_hw(priv)) {
 		priv->hw->mac->dump_regs(priv->ioaddr);
@@ -1170,9 +1104,6 @@ open_error_wolirq:
 	free_irq(dev->irq, dev);
 
 open_error:
-#ifdef CONFIG_STMMAC_TIMER
-	kfree(priv->tm);
-#endif
 	if (priv->phydev)
 		phy_disconnect(priv->phydev);
 
@@ -1203,12 +1134,6 @@ static int stmmac_release(struct net_device *dev)
 
 	netif_stop_queue(dev);
 
-#ifdef CONFIG_STMMAC_TIMER
-	/* Stop and release the timer */
-	stmmac_close_ext_timer();
-	if (priv->tm != NULL)
-		kfree(priv->tm);
-#endif
 	napi_disable(&priv->napi);
 
 	/* Free the IRQ lines */
@@ -1323,12 +1248,6 @@ static netdev_tx_t stmmac_xmit(struct sk_buff *skb, struct net_device *dev)
 	/* Interrupt on completition only for the latest segment */
 	priv->hw->desc->close_tx_desc(desc);
 
-#ifdef CONFIG_STMMAC_TIMER
-	/* Clean IC while using timer */
-	if (likely(priv->tm->enable))
-		priv->hw->desc->clear_tx_ic(desc);
-#endif
-
 	wmb();
 
 	/* To avoid raise condition */
@@ -1523,7 +1442,7 @@ static int stmmac_poll(struct napi_struct *napi, int budget)
  *  stmmac_tx_timeout
  *  @dev : Pointer to net device structure
  *  Description: this function is called when a packet transmission fails to
- *   complete within a reasonable tmrate. The driver will mark the error in the
+ *   complete within a reasonable time. The driver will mark the error in the
  *   netdev structure and arrange for the device to be reset to a sane state
  *   in order to transmit a new packet.
  */
@@ -2141,11 +2060,6 @@ int stmmac_suspend(struct net_device *ndev)
 	netif_device_detach(ndev);
 	netif_stop_queue(ndev);
 
-#ifdef CONFIG_STMMAC_TIMER
-	priv->tm->timer_stop();
-	if (likely(priv->tm->enable))
-		dis_ic = 1;
-#endif
 	napi_disable(&priv->napi);
 
 	/* Stop TX/RX DMA */
@@ -2196,10 +2110,6 @@ int stmmac_resume(struct net_device *ndev)
 	priv->hw->dma->start_tx(priv->ioaddr);
 	priv->hw->dma->start_rx(priv->ioaddr);
 
-#ifdef CONFIG_STMMAC_TIMER
-	if (likely(priv->tm->enable))
-		priv->tm->timer_start(tmrate);
-#endif
 	napi_enable(&priv->napi);
 
 	netif_start_queue(ndev);
@@ -2295,11 +2205,6 @@ static int __init stmmac_cmdline_opt(char *str)
 		} else if (!strncmp(opt, "eee_timer:", 6)) {
 			if (kstrtoint(opt + 10, 0, &eee_timer))
 				goto err;
-#ifdef CONFIG_STMMAC_TIMER
-		} else if (!strncmp(opt, "tmrate:", 7)) {
-			if (kstrtoint(opt + 7, 0, &tmrate))
-				goto err;
-#endif
 		}
 	}
 	return 0;